composition homogeneity 中文意思是什麼

composition homogeneity 解釋
組成均勻性
  • composition : n 1 作文(法),作詩(法),作曲(法);作品,文章;樂曲;文體,措辭。2 編制;結構,構造,組成,...
  • homogeneity : n. 1. 同種;同質;同性。2. 【數學】齊性,均勻;同一性,均衡性,均勻性。
  1. Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate

    Pzt的制備方法有很多,其中溶膠?凝膠( sol - gel )方法可以和集成電路( ic )光刻工藝相互兼容,處理溫度低,有大面積塗敷性能,能精確地控制組分,無需復雜的真空設備,成本低廉,所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜( ito )襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射, sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度,結構和電學性能進行了測試。
  2. This edta route has several remarkable advantages in comparison with other method. because of the greater ability of edta anions to chelate metal cations, and forming very stable and soluble complexes, all of the starting materials are mixed at the molecular or atoms level in a solution, it is easy to control the composition and a high degree of homogeneity is achievable

    傳統的合成方法是高溫固相反應,由於灼燒溫度高、灼燒時間長,形成硬團聚體,產物粒徑較大,一般為m級,需進行球磨粉碎以減少其粒徑,很難制得均相、均一粒度分佈的氧化物粉體,在研磨過程中容易引入雜質且晶形破壞使得發光亮度減小。
  3. Based on these parameters, the performs with the outer diameter 1200mm, the inner diameter 600mm and thickness 100mm were prepared. composition and microstructure homogeneity combined with fine primary silicon grain and uniform distribution of sic reinforced particles of 15 % were achieved

    並在此工藝參數下,制備出了不同硅含量的鋁基復合材料環坯,其尺寸為1200 600 100mm ,沉積坯的組織均勻、初晶硅細小,增強相sic顆粒的分佈均勻,體積分數約為15 % 。
分享友人