concentrated flow 中文意思是什麼

concentrated flow 解釋
槽流
  • concentrated : adj. 1. 集中了的；濃縮了的；汰選出來的。2. 聚精會神的。
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  1. On the formation mechanism, the rills were mainly formed by the concentrated action of the runoff on dyke slope, while the formation of socket mainly depended on surface runoff, subsurface flow and the existing defects within the dykes such as crack, mouse hole, fox and brocks dens

    在成因上，前者主要是降雨形成超滲地面徑流的集中對戧坡的侵蝕作用而形成；後者主要與坡面徑流、壤中流，以及土堤的薄弱點（如裂縫、鼠洞、狐1一灌洞等）有關。
  2. As the flow becomes concentrated in low places because of irregularities in the surface, rills are formed.

    由於地面凸凹不平，當水流逐漸集中於低地時，就形成了溪流。
  3. Advances in research of rheological properties and flow behavior of highly concentrated coal - water slurries

    高濃度水煤漿的流變特性和流動規律研究進展
  4. The integrated simulation of wide area data distribution emerges as an issue with the interconnection and development of area network. while the conventional power flow and reactive power optimization methods are usually based on concentrated network data, the integrated network data simulation becomes intricate since the network power scheduling management by voltage levels and areas under various dispatching centers is hard to concentrate

    傳統的潮流、無功優化等方法都基於集中的電網數據資源，而當全網數據因電力調度管理的分層分區控制分佈在不同的調度部門難以集中時，如何對數據資源廣域分佈的電網進行一體化模擬就成了一個非常突出的問題。
  5. Part : this part is concentrated on discounted cash flow method. basic concepts and valuation procedures is introduced ， then there is an argument on factors that determine the dcf method

    三、現金流量貼現法首先對現金流量貼現法的基本概念和評估程序進行了介紹，然後針對價值評估公式中各因素的確定進行了有益的分析和探討。
  6. In order to calculate the high external water pressure, the rock seepage field and external water pressure coefficient should be treated in detail. concentrated on the questions of high external water pressure and flow of the deep - lying tunnel, the basic theory and method calculating external water pressure are systematically studied, the high external water pressure of jinping cascade 2 hydropower station is analyzed and studied in detail

    本文在總結前人研究成果的基礎上，圍繞深埋隧洞的突涌水和高外水壓力問題，系統地研究了深埋隧洞襯砌水荷載和外水壓力的作用機理及計算方法等理論，並對錦屏二級水電站深埋引水隧洞的外水壓力問題進行了詳細的分析和研究。
  7. The numerical simulation and experimental research made on the characteristics of the clearance cavitations in kaplan turbine are described herein ; in which the analysis mainly is concentrated on the characteristics of leakage - vortex caused by the flow of the clearance between blade tip and blade chamber, that occurs at the front - pressure side of the blade, and the intensity of the secondary - flow - vortex ; furthermore, the relationship in between the leakage - vortex, secondary flow vortex, cavitations and erosion are analyzed as well

    摘要對軸流轉槳式水輪機輪緣間隙流動及空化特性進行數值模擬和試驗研究，重點分析輪緣間隙流動在正面頭部泄漏流動所引起的泄漏渦帶、二次流動的漩渦強度和空化特性，以及泄漏渦帶旋轉、二次流動的漩渦與空蝕和磨損之間的關系。
  8. The geomorphological instantaneous unit hydrograph ( giuh ) is viewed as the frequency distribution of the times of arrival of individual water deoplets at the catchment outlet. the travel path, for a typical hillslope cell. consists of a hillslope fraction, corresponding to overland flow and a stream fraction, corresponding to concentrated channeled flow. to obtain the time of travel, velocities must be defined. hillslope and stream velocities vary with location and must be strongly correlated with slope, and therefore a spatial distribution of velocities and hence of travel times could be obtained. the present methods of giuh neglect any time delays associated with overland flow pathways

    地貌單位線被看作是流域上各水質點在弱相互作用下，到達流域出口匯流時間的頻率分佈。對於一個典型的山坡型網格單元，匯流路徑由兩部分組成，即坡地部分和河道部分，為了得到匯流時間，必須首先確定匯流速度。坡地和河道的匯流速度隨著區域位置而變，並且必然與坡度有關，因此，可首先計算流速的空間分佈，進而得到匯流時間的空間分佈。
  9. Uasb ( up - flow anaerobic sludge bed ) technique in the pretreatment of high concentrated wastewater of petroleum chemical production is introduced, with its technological design and process, as well as the operation result

    介紹了採用上流式厭氧污泥反應器對高濃度石化廢水進行預處理的新方法，包括高濃度己內酰胺廢水預處理工藝設計、預處理工藝流程和調試運行結果等。
  10. Experts agree that debris flow forms and grows upon three basic conditions, i. e., inducible landform, abundant material supply and adequate water flow. research in this paper is thus concentrated upon the environment from the geology and the three conditions

    眾多專家一致認為，泥石流的形成與發育必須具備三個基本條件：一是有利的地形地貌基礎；二是豐富的補給物質條件；三是有適當的水源激發。
  11. In the second part, the reliability research on electronic packaging was concentrated with finite element method ( fem ) on moisture diffusion in plastic materials, die cracking of flip - chip with no - flow underfill and thermal performance of high power electronic components. in the last chapter, the design tool for advanced electronic package was studied. the main conclusions in the second part are as follows

    論文第二部分電子封裝可靠性研究包含對塑封材料中水汽擴散研究、填充不流動膠的倒裝焊晶元可靠性研究以及大功率器件散熱問題研究三方面內容，最後為實現封裝設計標準化和自動化，研究了若干最主要的電子封裝構型的參數化有限元建模、加載和相應的求解方法。
  12. The tissue - localization showed that there were more silver - grains labelled in the ray, callus and regenerated differentiating vascular tissue cells than that in other tissues. it further suggested that the high concentration of endogenous iaa triggered the dedifferentiation of the immature vascular tissues after girdling, and the lower concentrated iaa flow could promote the initiation and activity of the regenerated cambium

    內源iaa組織定位的結果表明射線細胞愈傷組織和新生維管組織內均有較多的銀顆粒標記。這些似可表明，高濃度的內源iaa可啟動未成熟維管組織細胞的脫分化，而較低濃度的內源iaa流則可誘導再生形成層的發生和活動。
  13. And this numerical result is similar to the experimental result. then, the computation was played on different domain, rate of fibers and st numbers and got the conclusion that the farther the distance between the domain and the center of the pipe was, the more fibers " axis concentrated on the orientation of flow, while the rate of fibers and the st numbers had little influence on the distribution

    然後通過考慮管道截面上的不同區域、改變纖維長徑比和st數來研究他們對纖維偏角分佈的影響，從而得出結果：隨著計算區域從管道截面的中心向壁面的轉移，纖維粒子的偏角分佈逐漸集中於低角度；而纖維長徑比和st數卻對纖維的偏角分佈沒有明顯影響。
  14. Analysis has been concentrated upon the triple - pipe construction method in this thesis. detailed introduction has been carried out from the cut of earth by means of gaseous - hydraulic co - axial composite grouting flow to the principle of earth stabilization, from the makeup of grouting liquid to the equipments, types of instruments, operation regulations and means of quality control required in every link of grouting

    論文重點分析了三重管法施工技術，分別從氣液同軸復合噴射流對土體的切削到對土體的加固原理，從注漿液體的配備到注漿各環節所需設備、機具型號及操作規程和質量控制手段等方面都做了詳細的介紹。
分享友人
分享到 Line

分享到臉書