conventional figure 中文意思是什麼

conventional figure 解釋
慣用圖形
  • conventional : adj 1 因襲的，傳統的。2 習用的；平常的，常規的；形式上的。3 約定的，協定的；會議的。n ism 依從俗...
  • figure : n 1 外形，形狀，外觀；姿態。2 畫像，塑像。3 圖形，圖案；插圖；圖表。4 人影，人形；人物。5 風度，...
  1. In this rebuilt environment, architecture relinquishes its conventional identity as autonomous figure, to initiate a dialogue with the striated geology of the natural and industrial landscape

    在這個人為重建的環境，建築拋棄了它傳統做為獨立個體的意識形態，開啟了與（自然和工業地景）地質紋理的對話。
  2. Along with silicon ulsi technology has seen an exponential improvement in virtually any figure of merit, as described by moore ’ s law ; the miniaturization of circuit elements down to the nanometer scale has resulted in structures which exhibt novel physical effects due to the emerging quantum mechanical nature of the electrons, the new devices take advantage of quantum mechanical phenomena that emerge on the nanometer scale, including the discreteness of electrons. laws of quantum mechanics and the limitations of fabrication may soon prevent further reduction in the size of today ’ s conventional field effect transistors ( fet ’ s )

    隨著超大規模集成電路的的發展，半導體硅技術非常好地遵循moore定理發展，電子器件的特徵尺寸越來越小;數字集成電路的晶元的集成度越來越高，電子器件由微米級進入納米級，量子效應對器件工作的影響變的越來越重要，尺寸小於10nm將出現一些如庫侖阻塞等新特性。量子效應將抑制傳統晶體管fet繼續按照以前的規律繼續減小。在這種情況下，宏觀的器件理論將被替代，可能需要採用新概念的晶體管結構。
  3. The conventional connection circuit as the figure shows for two - wired transmitter : handhold terminal palm computer and external communication interface or mainframe communication circuit cannot directly bridges in the ends of power source. but may either meet on field ends a and b or meet on the ends of load resistance b and c. in the above - mentioned case, the circuit are supplied by power source

    對兩線制變送器來說，傳統的連接電路如圖所示：手持終端掌上電腦和外接通訊介面或主機通訊電路不能直接跨接在電源兩端，但既可接于現場兩端a ， b上，也可接在負載電阻兩端b ， c ，兩種情況下，電路都要通過電源來供電， hart規范允許負載電阻為2301100 。
  4. It is thus of importance to develop an l - band edfa. however, a conventional l - band edfa is relatively inefficient and has low gain and high noise figure since they are operated at the tail of the erbium gain band. therefore, it is very important to design and analyze a high performance l - band edfa with simultaneously high gain, low noise and low gain ripple for a dwdm system

    開發新的l - bandedfa是十分必要的，然而傳統的l - bandedfa由於工作在鉺光纖增益譜的尾部，其存在增益低、工作轉換效率低、噪聲大等缺點，因此，分析和設計符合dwdm系統發展要求的具有優良性能（高增益、低噪聲、動態增益均衡）的l - bandedfa是十分有意義的。
分享友人
分享到 Line

分享到臉書