coolant conditions 中文意思是什麼

coolant conditions 解釋
冷卻劑條件
  • coolant : n. 【機械工程】冷卻劑;(減熱的)潤滑劑。
  • conditions : (旅遊合同中)條件或服務項目
  1. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下,當裝置穩態功率變化時,冷卻劑平均溫度與蒸汽壓都保持不變,與通常採用的冷卻劑平均溫度恆定運行方案相比,有效地改善了核動力裝置的總體運行性能,特別是在低負荷運行時,可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件,這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  2. Therefore, sequential research on chf is necessary. when in accidental conditions of nuclear reactor, the mass flux of coolant is very low. in such condition, the steam quality is high, and the mechanism of chf is mainly controlled by bulk flow, whereas microcosmic parameters near the chf area are affected by the flow conditions in whole tube which called " upstream memory effect "

    在反應堆事故工況下,冷卻劑流量很低,含汽量很高,其臨界機制與正常運行工況下的臨界機制有所不同,不僅是一種主流控制臨界工況,更由於其局部的各微觀參數受上游流道的累積效果的影響而存在上游記憶效應。
  3. Abstract : according to the working conditions of cutting lubricating coolant used in stone processing, we developed a specialized emulsifying oil for stone processing cooloant, and estabhshed the corresponding standard

    文摘:根據石材加工使用切削潤滑冷卻液的工作要求,開發研製專用的石材加工冷卻液乳化油,應制定出相應的產品標準。
  4. For all the four cases the boundary conditions are exactly the same and the coolant mass flux per unit area in the region with holes on the plate is also the same

    為了便於相互比較,各計算模型的邊界條件完全相同,而且平板氣膜孔區單位面積上冷氣流量均相等。
分享友人