coupling strength 中文意思是什麼

coupling strength 解釋
耦合強度
  • coupling : n. 聯結；交尾；【機械工程】管箍；聯結器；軸接；（火車的）車鉤，【電學】耦合。
  • strength : n. 1. 力，力量，體力。2. 強度，濃度；長處；（要塞等的）抵抗力。3. 實力；兵力；全體人數，額定人數，編制。4. 筆力；文勢。5. （證券等的）市價堅挺。6. 〈美俚〉（可能有的）利潤。
  1. The coupling admixes the particle and collective degrees of freedom in such a manner as to partially transfer the one-particle transition strength onto the collective modes.

    耦合使粒子和集體自由度按這樣的方式混合，即使單粒子躍遷強度部分地轉變到集體模式中。
  2. By introduction of two lif layers, the adjustment of the position of thin layer alq3 in the microcavity is achieved and the effect of the coupling strength between the emissive dipole and vacuum electric - field on the emission intensity in ( / 2 - length microcavity is studied for the first time

    在帶有dbr結構的高q值微腔中，觀察熒光壽命變短輻射速率提高的現象。通過使用填充層，來實現對薄層alq在腔中位置的調節，研究了輻射偶極子同光電磁場的耦合強度對輻射強度的影響。
  3. And due to the heat expansile coefficient of the stainless steel rather high, the connecting force between the stainless steel pipe and the pipe coupling in the room temperature is much less than that between the titanium alloy pipe and the pipe coupling. the results accord with the tensile experiments well. finally, the dependence of dimensions of the coupling on the strength of the connector system is analyzed

    模型計算還表明，被接管材料和管接頭材料之間的熱膨脹系數的差異會造成管接頭系統的室溫強度低於高溫強度；由於不銹鋼的熱膨脹系數較大，使得室溫下1不銹鋼管與n立tinb形狀記憶合金管接頭間的抱緊力遠小於鈦合金管與nitinb形狀記憶合金管接頭間的抱緊力，成功地解釋了拉脫實驗中的結果。
  4. The stress state in the stainless steel pipe - titanium alloy pipe - nitinb shape memory alloy connector system is analyzed by using the theory of solid mechanics and the recovery rules of nitinb shape memory alloy with constrains on the basis of analysis of the structure of the connector system and the all steps in the preparation and the service. a mathematical model for the strength was proposed. the temperature dependence of connecting force and the maximal stress intensity in the pipe connector in the process of preparation and service was studied by programming and computing. the computing results show that the difference of heat expansile coefficient between the coupling material and the pipe material leads to the strength of connector system at room temperature less than the strength at high temperature

    通過分析管接頭結構以及制備、使用的各個步驟，運用固體力學的基本理論，結合nitinb形狀記憶合金在約束下的回復規律，對不銹鋼- -鈦合金管- -四川大學碩士論文nitinb形狀記憶合金管接頭系統內的應力狀態進行了理論分析，建立了強度的數學模型，通過編程計算，研究了不銹鋼一鈦合金管一nitinb形狀記憶合金管接頭系統裝配及使用過程中的抱緊力以及最大應力強度隨溫度變化的規律。
  5. Motor vehicles - fifth wheel coupling pins - strength test

    汽車半掛車牽引座牽引銷強度試驗
  6. At first, the bonded magnet has been produced at varied technological conditions. then the influences of varied technological conditions, such as species and quantity of coupling agent, species and quantity of agglomerant, process of compression moulding and solidification process on magnetic property and compression strength of bonded magnet have been analysis by means of apparatus for measuring magnetic property and compression strength

    首先，在不同工藝條件下制備出粘結磁體，然後利用磁性能測試儀、力學性能測試設備等測試手段，分析了偶聯劑的類型及其用量、粘結劑的類型及其用量、模壓工藝和固化工藝等因素對鐵氧體粘結磁體磁性能及力學性能的影響。
  7. Provides the remarkable oil film strength, prevented the coupling slips

    提供卓越的油膜強度，防止離合器打滑。
  8. From the result of optimum, the higher splitting tensile strength is maim from the fiber amount of hpc, and connected with the coupling of other ingredients

    由配比優化結果可知，抗拉強度的提高主要受碳纖維摻量的影響，同時與其它因素的交互作用有密切關系。
  9. I. e. strong coupling critical admittance and weak coupling critical admittance that affect the occurring conditions and types of commutation failures in multi - infeed hvdc system, are defined in this paper. factors which has great influence on the above two parameters, such as ac system strength

    針對一個典型的多饋入直流輸電系統，首次定義了影響多饋入直流輸電系統中換相失敗及其發生類型的兩個重要參數，即強耦合臨界導納和弱耦合臨界導納。
  10. Strength of coupling mechanism fiber optic interconnecting devices

    耦合機制光纖互連裝置的機械強度
  11. At last, in order to improve the interfacial bond strength, durafiber pretreated by variable silane coupling agents were mixed into furan polymer mortar, then make its mechanic properties testing

    最後，為改善杜拉纖維與呋喃樹脂砂漿的界面粘結性能，採用杜拉纖維用不同的硅烷偶聯劑處理后再加入到呋喃樹脂砂漿中，測試其力學性能。
  12. The results show that the tensile strength and rupture strength of furan polymer concrete were improved when the durafiber was used ; and durafiber pretreated by wd - 60 silane coupling agent can enhance the strengths ( the tensile strength, rupture strength and impact toughness ) greatly,

    結果表明：在呋喃樹脂混凝土（砂漿）中加入杜拉纖維，可提高其抗拉強度、抗折強度和沖擊韌性；經硅烷偶聯劑wd - 60處理后的杜拉纖維對其抗拉強度、抗折強度有大幅度提高。
  13. It " s fit for the polaronic models of all coupling strength

    Feynman路徑積分方法適用於各種耦合強度的極化子模型。
  14. Main content in simulation is the spatio - temporal evolution of the set of descriptive variables characterizing tectonic mineralization state under coupling of various processes as following : ( 1 ) variables related to forming and property of ore - forming fluid, such as dissolution rate of minerals ( include metal minerals ) in rock, concentration and saturation of aqueous species in fluid, temperature, pressure, and ionic strength etc. ; ( 2 ) variables related to structural deformation and fluid flow, such as stress, deformation rate, fracture network, porosity, fracture permeability ; ( 3 ) variables related to precipitation and mineralization, such as nucleation rate of gangue and metal minerals, accumulation precipitation of various minerals, etc. ; ( 4 ) spatio - temporal coupling relation of various variables above, such as the coupling relationship between spatio - temporal evolution of fracture permeability and flow and focus of fluid and ore - forming

    模擬的主要內容是在各種過程耦合作用下，以下描述構造成礦體系的主要變量的時空演化：與成礦流體的形成和性質有關的變量，如地層中礦物（包括成礦物質）的溶解速率、流體中各組分的濃度與飽和度、流體溫度、壓力、離子強度等；與構造變形和流體運移有關的各變量，如應力與變形速率、巖石孔隙度、構造（斷裂）滲透率等；與沉澱成礦有關的變量，如礦物（金屬礦物和脈石礦物）的成核速率、各礦物的沉澱量等；上述各有關變量間的時空耦合關系，如斷裂滲透率時空演化與流體流動、匯聚和成礦的耦合關系等。
  15. The major influential factors of the gateway stability is the non - coupling states for the stiffness and strength, as well as the structure of the support system and rock mass

    摘要支護體與圍巖在剛度、強度和結構上的不耦合是影響全煤巷道圍巖穩定性的主要原因。
  16. The study showed that under contain load and input speed, the output speed of the coupling could be controlled by modulating the strength of the applied dc field, which provides a new control means for continuous speed modulating of a transmission system

    實驗表明，在確定負載和輸入速度下，可以通過調節直流電場控制聯軸器的輸出速度。這為傳動系統的無級調速提供了一種新的更簡便的手段。
  17. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - torque strength of coupling mechanisms

    光纖互聯裝置和無源部件.基本試驗和測量程序.試驗.連軸機械扭矩強度
  18. For coupled - quantum - dot systems, no matter the spatial symmetry, size and tunnel coupling strength between quantum dots are all controllable. in this way, the dream of controlling solids is realized. for this reason, the transport properties of systems consisting mutiple quantum dots have attracted the interest of physicists

    對于耦合量子點體系，無論其組成的量子點的空間對稱性，還是量子點的尺寸、相互之間的耦合強度都是人為可以調控的，從而實現了人們操縱固體的夢想，並因此而受到廣泛的關注。
  19. This paper proposes the occasional coupling synchronization scheme of the active - passive decomposition ( active - occasional coupling ). this scheme consists of synchronization and autonomous phases. in the former, the synchronization scheme is used to synchronize the drive and the response systems ; in the latter, small errors will lead to the two systems separated from each other and desynchronization. but if the synchronization phases are large enough, the full synchronization will be obtained. the synchronization condition is discussed theoretically. the spatiotemporal chaos in coupled map lattice system is achieved and the synchronization condition is given. moreover, the relation between the synchronization phases and the coupling strength is investigated numerically

    提出了離散系統中的主動-間隙耦合同步方法.該方法由同步相和自治相組成.在同步相，同步方案使得混沌系統趨于同步，而在自治相，兩系統間的誤差將迅速放大，導致失同步.但只要同步相足夠大，最終可實現系統的準確同步.還從理論上討論了同步條件，並利用該方法實現了耦合映象格子時空混沌系統中的混沌同步，給出了同步條件以及同步相與耦合強度的關系
  20. In the absence of signals, there is a transition phenomenon hi the firing rate which is only occurred under condition of the coupling between each neuron units, and there are two regions in the transition diagram of noise intensity and coupling strength plane : one is the non - sensitive to both noise intensity and coupling strength region, the other is the sensitive one

    發現了由於耦合的存在，增大噪聲強度會導致相變。同時進一步研究了在無信號輸人的情況下，神經系統的激發率隨噪聲強度和耦合強度的變化，發現了在一定的噪聲強度的作用下，神經系統的激發率到達一個峰值，即存在「同步共振」的現象。
分享友人
分享到 Line

分享到臉書