current frequency 中文意思是什麼

current frequency 解釋
電流頻率
  • current : adj. 1. 通用的,流行的。2. 現在的,現時的,當時的。3. 流暢的;草寫的。n. 1. 水流;氣流;電流。2. 思潮,潮流;趨勢,傾向。3. 進行,過程。
  • frequency : n. 1. 屢次,頻仍,頻繁。2. (脈搏等的)次數,出現率;頻度;【物理學】頻率,周率。
  1. The ionosphere is a complex medium, which is aeolotropy, asymmetry, dispersive and changes randomly with time. in order to improve the communication quality of the shortwave that depends on the ionosphere, we should have aknowledge of the current condition of the ionosphere in real time. the backscatter sounding of high frequency can diagnose the real - time channel characters for shortwave communication or hf radar, which is great assistant to shortwave communication and hf radar

    電離層是隨機時變,各向異性,非均勻、色散的復雜介質。為了保證依賴于電離層進行的短波通信質量,必須了解電離層的實時狀態信息。高頻返回散射探測可以實時監測與短波通信或高頻天波雷達相關的天波傳播通道的狀態,對短波通信和天波雷達工作起了重要的輔助作用。
  2. Mems ( micro electromechanical system ) has become one of the most rapidly development technologies. along with the rapid development of mems techniques, capacitive sensor is used widely whose capacitance changes small, which has put forward the new request to the measurement technique. the common measure for capacitance measurement is that convert capacitance to voltage, electric current or frequency. the area of polar plate of the capacitor becomes smaller and smaller, and the total capacitance of micro capacitive sensor is usually several pico farad only. as a result, its change amount is smaller

    Mems ( microelectromechanicalsystem )近年來發展最快的技術之一,隨著mems技術的快速發展,電容式加速度計的電容變化變化量越來越小,對檢測技術提出了新的要求。在電容式傳感器中,常用電容檢測電路是將其轉換為電壓、電流或者頻率信號。目前的微型電容傳感器的極板面積變得越來越小,電容總量只有幾個pf ,變化量就更小。
  3. Fourthly, according with the analyzing of flow measurement, we research the main problems needed to be solve in the process of measurement, such as analysis and measurement of the internal resistance, selection of excitation frequency, stable signal datum mark and restraining common mode interference, restraining for serial mode interference and working frequency interference ; transporting and shielding the flow signal, constant current excitation and magnetic field equalizing, flow measuring

    第四,根據對流量測量問題分析的,深入研究了設計過程中需要解決的主要問題。如內阻分析與測量;勵磁頻率的選擇;穩定信號基準點與抑制共模干擾;串模干擾與工頻干擾抑制;流量信號傳輸與屏蔽;恆流勵磁與磁場補償;流量測量點的選擇等。
  4. A circuit topology of the inverter with duty cycle extended active clamp forward style high frequency pulse dc link is adopted by each independent inverter. each inverter is cascaded by a circuit with duty cycle extended active clamp forward style high frequency pulse dc link and a dc / ac inverting bridge. the control strategy of voltage mode pwm forwardback is adopted by the former, and the control strategy of three - state discrete pulse modulation ( dpm ) hystersis current is adopted by the later

    每個獨立的航空靜止變流器採用占空比擴展有源箝位正激式高頻脈沖直流環節電路拓撲,由占空比擴展有源箝位正激式高頻脈沖直流環節電路與dc ac逆變橋級聯而成,前級採用電壓型pwm前饋控制技術,后級採用三態dpm電流滯環控制技術。
  5. The main features of the apparatus are focus on small volume, light weight, no iron core, no magnetic saturation and no ferreous resonance, moreover, related advantages such as the large range of transient and frequency response, excellent electrical magnetic compatibility, oil - free configuration, reliable insulation structure, are all the trends of current transformer in the future. meanwhile, it should agree with the future power gauge and digital, computer, automatic relay protection. it will meet the demand of digital power network

    它具有體積小、重量輕;無鐵芯、不存在磁飽和與鐵磁諧振問題;動態響應范圍大,頻率響應寬;抗電磁干擾性能強;無油化結構、絕緣可靠、價格低等優點;是未來電流互感器發展的方向,是新一代電力數字網發展的需要,適應電力計量和保護數字化、微機化和自動化發展的潮流。
  6. Frequency changer by means of electric current for calculation limitation

    因變頻器以電流為計算限制
  7. Ecundum motor up yi rating plate, select by means of current rating threefold hereinbefore frequency changer

    馬達選后,以馬達上之銘牌,以選用變頻器,
  8. Name : dlf current meter name : dfd frequency meter

    名稱: dfd頻率表
  9. Induction heated oil tempered spring wire is a kind of new technical material which has been developed since 1980s. it can be heated by means of eddy induced into itself through electromagnetic coil and this method is mainly used in surface quenching. with correct designing and reasonable current frequency, induction coil and heat treatment process selected, as well as plc controlling applied, the wire can be uniform heated along cross - sectional and longitudinal direction and can be quenched and tempered continuously

    應加熱油淬火-回火彈簧鋼絲,是二十世紀八十年代發展起來的新技術材料,在國外稱為itw induction heat oil tempered spring wire 。是通過線圈電磁感應鋼絲本身產生的渦流進行加熱,通常主要用於表面淬火。經正確設計,選擇電流頻率,合理的感應線圈及熱處理工藝,並實施plc控制,可使鋼絲整個截面及長度上得到均勻加熱,進行連續整體淬火和回火。
  10. Investigation of an integrated current - frequency converter circuit

    頻率轉換器電路的研究
  11. This unit is particularly designed for monitoring 400v feeder with backup automatic switch. it could accurately measure and calculate : voltage, current, frequency, active power, reactive power, power factor and energy. when bus gets into trouble, it can perform the function of automatic switching to backup power supply

    該單元是特別針對400v饋線備自投而設計的,它具有測量母線的電壓、電流、頻率、有功功率、無功功率、功率因數以及有功電度、無功電度等電參數的功能;當母線出現故障(過壓或欠壓)時,能夠完成兩組母線的自動投切,即備自投的功能。
  12. Considering the practicality in specific design, the two different drive system has been designed in the electrical control system, this is, the hoist and gantry uses a set of the ac ( alternating current ) frequency conversion timing drive system, the trolley and boom uses a set of the dc ( direct current ) adjusting voltage and timing system

    在具體設計時考慮到實用性,設計的電氣控制系統中採用了兩類不同的驅動系統,即起升與大車共用一套交流變頻調速驅動系統,小車與臂架俯仰共用一套直流調壓調速驅動系統。
  13. Considering the practicality in specific design, two different drive systems are designed in the electrical control system, that is, the hoist and gantry share a set of alternating current frequency conversion timing driving system, and the trolley and boom share a set of direct current adjusting voltage and timing system

    考慮到實用性,設計的電氣控制系統採用兩類不同的驅動系統,即起升與大車共用1套交流變頻調速驅動系統,小車與臂架俯仰共用1套直流調壓調速驅動系統。
  14. Development of ac - switch voltage current frequency adj - ustable power amplifier

    交流開關式電壓電流頻率可調功率放大器的研製
  15. The finite element method ( fe '. i ) is adopted to analyze the effects of the numbers of coil turns, current intensity and current frequency upon the rate of joule heat generation in details. the thermo - radiation analytical countermeasures of various types are adopted to carry out the numerical analysis of the effects of the crucible with different shapes and sizes and the blind holes with different depths opened in the tops of crucibles as well as coil positions upon the thermal field distribution whereby solving the main problem of field the thermo - field design of the induction - heating sic crystal growth system. a new combination idea of the thermo - field design obtained by means of the united design of the thermo - insulator and blind holes has been presented

    採用有限元分析方法對線圈匝數、電流強度、電流頻率等對焦耳熱產生速率的影響進行了詳細的分析討論;採用不同的熱輻射分析策略,對不同坩堝形狀、坩堝頂部開設不同深度的盲孔以及線圈的位置等對熱場分佈的影響進行了數值分析,解決了感應加熱碳化硅晶體生長系統熱場設計的主要問題,提出了通過絕熱層與盲孔的聯合設計獲得所需熱場設計的思路,給出了根據軸向溫度梯度的波動對線圈位置實行動態調節以控制熱場的理論依據。
  16. When the system is working, the photoelectric coder checks the speed of doubly - fed vscf wind power generator ; according as the principle formula of vscf, the excitation current frequency of rotor is calculated to satisfy the aim of vscf control

    系統工作時,用光電編碼器檢測出發電機的轉速,依據變速恆頻的原理公式計算出應饋入轉子勵磁電流的頻率,達到變速恆頻控制的目的。
  17. The epmi can measure voltage, current, frequency, power, energy and other electrical parameters synchronously, and display the measured parameters on lcd. furthermore, the epmi can transmite the measured data to the surveillance room through rs485 bus interface. if there are many epmis, they can be formed as a controlling network and managed easily

    本測試儀可以同時對電壓、電流、頻率、功率和能量等電參數進行測量,參數顯示採用液晶顯示技術,並配有rs485通信介面,可以將測量的數據傳送到監控中心,多臺測試儀表還可以形成控制網路,便於管理。
  18. On the base of it, a piece of data collection special chip with a core of fft is designed with vhdl ( vhsic hardware description language ) in the way of top down system design method, which can finish harmonic analysis and measure the voltage, current, frequency and power of the electric power system

    在此基礎上,使用標準的硬體描述語言vhdl設計出一個fft變換內核,並以該內核為核心、採取自上而下的系統設計方法完成了一個電力系統數據採集專用晶元的設計,實現對電力系統的電壓、電流、頻率、有功和無功功率等參數的測量以及各次諧波分析。
  19. In order to get suitable algorithms which are accuracy, feasible, practical and convenient to be realized by virtual instrument, this paper firstly analyzes measuring algorithms of major power quality parameters, such as voltage, current, frequency, harmonics, flicker, unbalance factor etc. then two algorithms, the one for basic power quality parameters measurement based on spectrum correction and the other one for flicker measurement based on fft, are presented

    基於虛擬儀器技術的電能質量測試儀應用靈活,升級方便, 「軟體就是儀器」的特色使測試儀各種通用功能和預期功能的方便實現成為可能。文章對電能質量的一些主要指標:電壓、電流、頻率、諧波、電壓波動和閃變、三相電壓不平衡度等的測量演算法進行了分析,尋求適合虛擬儀器實現的,切實可行、計算精確、實用性強的計算方法。
  20. Studies the shield and anti - jamming techniques and designs the shield shell. designs the transmit microcircuit adapts to the far distance transmission. using the passive high - precision current transformer founds a method to measure dielectric loss based on fft which can eliminate effects of harmonic and current frequency excursion and conducts an experiment

    利用所研製的高精度無源單匝穿心式小電流互感器,建立了一種基於fft的介質損耗測量方法,它可以有效地消除諧波和工頻信號波形不工整的影響,並進行了實驗驗證。
分享友人