current winding 中文意思是什麼
current winding
解釋
電流繞組-
In this thesis, the author analyses the deficiency in detecting and controlling function of the computer detecting and controlling system utilized in present transforming station. the strategy of design of software on operation and direction of 5 00kv transformer station is presented. it points out that we can deduce the mathematic analytical formula using the current, voltage and power of two terminals of transmission line as input. on this basis, we do realtime calculation of 500kv transmission line ' s parameter. we can also deduce the linear analytical formula of three - winding autotransformer ' s resistence using its current, voltage and power as input. the corresponding software is programmed on this basis
論文提出以輸電線路本端和對端電流、電壓、功率作為輸入量，導出了超高壓長線的波阻抗和傳播常數的數學解析式，在此基礎上進行了500kv輸電線路實時參數計算；提出以三繞組自耦變壓器的電流、電壓、功率為輸入量，導出了自耦變壓器繞組的電阻、電抗的線性解析式並進而對變壓器的實時參數進行計算；在此基礎上編制了相應的軟體。 -
The winding through which a current is passed to produce the primary source of flux in the machine is called the field winding
電流通過其在電機中產生主磁通的繞組稱為勵磁繞組。 -
Since the secondary winding is normally operated into a high-impedance circuit, the secondary current is quite small.
因為次級繞組通常輸入高阻抗的電路，因此次級電流很小。 -
By regulating the compensation current injecting into the compensation winding of the reactor, the reactor inductance at different harmonic frequencies can be independently and continuously adjusted
有源電抗器由一對耦合繞組和一個補償電流發生器組成，通過控制有源電抗器補償繞組中的諧波磁通補償電流，可以獨立且連續地調節電抗器在不同諧波頻率下的電感量。 -
In accordance with the driving characteristics of ac driving locomotive, the working status of its traction transformer is analysed. the questions that should be considered in the traction transformer design of ac driving locomotive are mentioned. these questions are the large short - circuit impedance of traction winding, higher harmonic current, over - excitation and dc magnetization caused by large variation of the network voltage, etc. some disposal methods are given
針對交流傳動電力機車的傳動特點，對其中的牽引變壓器的工作狀態進行了分析，指出交流傳動電力機車用牽引變壓器設計時需考慮的牽引繞組的短路阻抗大、電流的高次諧波、網壓波動大可能引起的過勵磁以及直流磁化等問題，同時給出了相應的一些解決方法。 -
Three parts are included as follows : first of all, the basic circuit equation of radial pm generator for autos is given. the effect of reciprocity of pm and winding ' s magnetic force upon winding ' s inductance and current upon magnetic circuit saturation are analysed. according to these, we can obtain optimized design
首先，從本課題採用的徑向式結構的三相永磁同步發電機的物理模型出發，得出其基本電路方程式，並分析了永磁磁動勢與繞組磁動勢間相對位置的不同而對繞組電感不同的影響，相電流對磁路飽和效應的影響，為車用永磁發電機的優化設計提供了理論依據。 -
Back face culling is affected by the current winding - order render state
背面剔除受當前頂點連接順序呈現狀態的影響。 -
For compensating the nonlinear error between winding current and the result magnetic field of stepper motor, the method of minimum square is adopted to fit and correct the error curve of subdivision step angle, and the subdivision precision is improved
為了補償步進電機相繞組電流與其產生磁場之間非線性引起的誤差，採用了最小二乘法對細分步距角誤差曲線進行了擬合與修正，提高了細分精度。 -
Considering the relations between idle load characteristics and armature winding parameters of the salient pole propulsive synchronous motor ( spsm ) with its structure, stator tooth and magnetic saturation, the analysis of numerical method for the back electromotive force calculation of spsm is given under various exciting current values
摘要針對凸極式同步推進電機的空載特性及其繞組參數與電機結構、定轉子齒槽、磁場飽和等緊密相關的問題，分析了在不同勵磁電流下同步推進電機相反電勢的數值計算方法，提出了採用電機磁場能量微動法計算相繞組的參數，並對一臺十二相同步推進電機的繞組參數及其空載特性進行了計算和測量。 -
The thesis realizes the control exciting winding method and the best exciting in towards polarity method provided in this thesis with singlechip ( at90s8535 ) and scr hardware. it proves these methods are accurate and available through the control exciting winding test. analyzing the stator current and exciting current test curves on a salient - pole synchronous motor with 2kw - 4 poles, it solves the starting - difficulty of salient - pole synchronous motors, and improves motors " starting capability
通過在一臺2kw 、 4極凸極同步電動機上進行異步起動試驗和分析試驗過程中的勵磁繞組電流和定子繞組電流的波形，證明了本文提出的勵磁控制線路的正確性和可行性，較好地解決了凸極同步電動機起動難的問題，同時改善了電機的起動性能。 -
The current transformer is fully enclosed structure. the terminal p1 of the primary winding is as the static contact of the switch cabinet and placed inside the epoxy - resin insulation cavity
本型電流互感器為全封閉結構，其一次繞組的p1端子，直接作為開關櫃中的靜觸頭被設置在環氧澆注的絕緣空腔內。 -
Under the conditions of high safe coefficient of insulated electrical strength of the stator winding of the generator, the selection of earthing resistance value should meet the needs of matching one - point earthing protection of the stator and limiting the fault current
在發電機定子繞組絕緣電氣強度有較高的安全系數的情況下，接地電阻值的選取應主要服從與定子一點接地保護的配合及限制接地故障電流的需要。 -
The series of current transformers are resin insulated ， fully enclosed and busbar type. the iron core is circular and the secondary winding goes around the core before casting by epoxy
本型電流互感器的鐵心為圓環形，二次繞組勻繞制在鐵心圓周上，用環氧樹脂混合料澆注成形。 -
The power lost by current flowing through the winding, the power loss is equal to the square of the current multiplied by the resistance of the wire ( 1 2 r ). this power loss is transferred into heat
電流流以線圈所產生之能量損失，此能量損失等於電流大小的平方乘上線圈的電阻（ 12r ） ，這些能量損失轉換成熱能。 -
The new black dragon 3 powercord provides greater ac current capacitance with the conductor winding twice as large as the silver dragon power cord
黑龍3電纜提供更強大的交流電負載能力，因為它的導體纏繞達到了銀龍的兩倍 -
Ac motor starting current is big, but it can bear usually, if it starts unusually, it could produce heating winding and burn. the large capacity motor must use starting equipment
交流電動機起動電流大。正常起動時，電動機能夠承受，但非正常起動時，會產生繞組過熱而燒毀；通過分析指出較大容量的電動機必須採用起動設備。 -
By close study on the average temperature rise, temperature distribution, and tune constant of the class f resin dry type power transformer ' s high voltage and low voltage winding under self - cooling and wind - cooling mode, we find out the connection between the variation of the load and the items, mentioned above. the results of the experiments can be reference to both thermal design optimization of dry type power transformer and the revision of current standards. meanwhile, we develop the software, which can predict the overload ability of the dry type power transformer
本文對f級樹脂澆注式乾式變壓器的高、低線圈的平均溫升，內部溫度分佈和時間常數在自冷和風冷，兩種冷卻方式下隨負載變化的規律進行了研究，得出了平均溫升、熱點溫升和時間常數隨負載變化的相互關系和有關計算用參數和公式，試驗結果可作為改進乾式電力變壓器的熱設計的依據和對現行標準進行修改的參考。 -
The relation among all short - circuit current in each winding is described, and the rms value and peak value equation of short circuit current are concluded in this paper
本文從平衡變壓器的工作原理入手，建立平衡變壓器各繞組中電流之間的電流映射關系矩陣和矢量關系，推導平衡變壓器短路電流有效值和峰值的計算公式。 -
Through the monitoring on the frequency performance and square - wave response performance of manganese - zinc ferrite coil with different sizes., different ratios of winding and different matching impedances, the result shows that manganese - zinc ferrite coil with proper ratio of winding and matching impedance can effectively restrain the interference and damage which the over - voltage and large - current signals of the power system do to the on - line monitoring system
通過對不同尺寸、不同匝數比和不同匹配阻抗下的錳鋅鐵氧體線圈的頻帶性能、方波響應性能測試實驗，結果表明：適當匝數比和匹配阻抗的錳鋅鐵氧體線圈可以有效地抑制系統過電壓和大電流信號對在線監測系統干擾和破壞。 -
In conclusion, when the current of the winding is increased, the tendency of the end effect - thrust is unchangeable, the no - load end effect is the main part of the pm linear motor ' s end effect
從以上的分析和計算得出，隨繞組電流幅值的增加，端部效應影響電機推力的波動趨勢不變，空載端部效應是永磁直線電機端部效應的主要部分。
分享友人