damping transient 中文意思是什麼
damping transient
解釋
阻尼瞬變過程-
A lumped parameter model was developed for predicting the transient motion of mirrors, taking into account electrostatic and tensile forces and viscous air damping via squeeze film theory
考慮靜電驅動力、張力和空氣阻尼衰減對變形鏡回復過程的影響，建立一種復合參數模型來預測變形鏡的瞬態行為。 -
In this thesis we use electromagnetic transient program ( emtp ) to simulate and study those two kinds of overvoltage ; and research how to use moa and rc devices to reduce them basing on multi - exponential moa model and principle of rc device. at the same time, based on l - r damping principle, researches are made on the feasibility of restricting overvoltage by l - r device. thus methods of ensuring the parameters of these devices are concluded
本文利用電磁暫態計算程序（ emtp ）對上述兩種過電壓進行了模擬計算研究；同時，基於moa多指數模型和rc裝置原理研究了如何使用moa和rc裝置來對過電壓進行限制；基於l - r阻尼原理探討了使用l - r裝置限制過電壓的可行性；並得出了以上保護裝置的參數確定方法。 -
For the purpose of determining the basic problems such as the computed field and the mesh sizes in the finite element method, the paper first deals with the problems of a semi - infinite soil domain with radiation damping and material damping through the transient response of a single pile, which are used in the finite element method
本文首先利用單樁的瞬態響應來考察有限元計算中處理半無限土體的輻射阻尼和材料阻尼問題，以便確定有限元計算區域大小，網格尺寸等基本問題。 -
In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research
在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。 -
The framework and results of this study is thus summarized as follows : 1. analyzing the effect of the nonlinear parameters on seismic response. so far the g / g _ max - ( transient dynamical shear modulus over the maximum shear modulus vs. shear strain ) and the - ( equivalent shear hysteretic damping ration vs. shear strain ) curves are widely employed in the experimental method in studying soil dynamic property, supposing under equiamplitude cyclic load
目前，人們利用實驗手段分析土體動力特性時給出的最基本的描述量是g g _ （ max ） ?曲線（等效動剪切模量與最大動剪切模量的比值隨應變幅值變化的曲線）及?曲線（等效剪切滯回阻尼比值隨應變幅值變化的曲線） 。 -
A novel strategy combined the fuzzy logic of linear multivariable feedback control to design a controller of statcom to meet the multi - objective demands of power systems is also proposed in this dissertation, and the controller is designed with this strategy, because of variational element, nonlinearity and multi - objective controlling demands of statcom, this paper designs the controller respectively aimed at continuous linear control for voltage maintaining, oscillation damping, improving the transient stability
根據電力系統變參數、非線性以及對控制要求多目標的特點，本文針對維持系統節點電壓、阻尼系統振蕩、提高系統暫態穩定性能等不同控制目標分別設計了控制器，然後將模糊邏輯和多狀態線性反饋相結合，提出了一種能滿足電力系統多目標要求的控制方法，並用該控制方法為statcom設計了控制器。 -
Because of strong nonlinearity of the elastomeric damper, analysis of a transient signal is necessary in order to study the stability. it is desirable to have damping identification techniques, which are be fast, can handle a reasonable amount of sensor noise. three analyses are presented here
故本文介紹了三種阻尼識別的方法，即基於傅立葉系數的移動矩形窗法和基於希爾波特變換的方法，以及傳統的基於fft的移動矩形窗法。
分享友人