dead-load test 中文意思是什麼
dead-load test
解釋
恆載試驗；靜荷載試驗-
Analysis on dead load and dynamical load test on third bridge of yiyang zijiang river
益陽資江三橋靜動力荷載試驗分析 -
Standard test method for heat resistance of hot - applied sealants under dead load shear
最大承載剪切下熱應用密封劑耐熱性的標準試驗方法 -
Standard test method for maximum media density for dead load analysis of green roof systems
新暴露頂層系統靜荷載分析用最大介質密度的標準試驗方法 -
In this test, a special bolt - jack is used to exent of prestressing force to brace angles as the whole structure is under dead - load. in this state brace angles withstand partly load before twice - load and the stress and strain of concrete are decreased. in this way the aim of removal of load and strengthening can be reached
本試驗中採用專用螺栓千斤頂在恆定荷載水平下對混凝土柱角鋼撐桿施加預壓應力，使外包角鋼在二次受力前即分擔部分荷載，使混凝土應力水平和應變水平降低，達到卸載與加固同步進行的目的。 -
Modeling the general solid web continuous box girder and opening - in - web ( open web ) continuous box girder by ansys finite element modeling tool, node stress of governing section and corresponding shear lag values are analyzed. the solution is validated by comparing with variational results and modeling test values. based on the model, the section shear lag induced by dead load, prestress tendons and car loads under the most unfavorable condition and lateral symmetry are also approached. the influence of shear lag effect in double - level continuous box girder is considered with opening - in - web and the web location. the analysis indicates that double - level - load arouses less shear lag effect than one - level - load. when self - weight and prestressed tendons act on together, the shear lag effect on box girder take on a evidently change
基於所建立的有限元模型，本文分別對實腹和腹板開孔兩種箱梁在恆載、車載、預應力荷載作用時，各主要截面的剪力滯效應進行分析，通過施加縱向最不利的和橫向對稱的車輛荷載，研究實腹連續箱梁和空腹連續箱梁在承受雙層荷載和單層荷載時引起的剪力滯效應，並考慮腹板開孔及開孔位置對于連續箱梁剪力滯效應的影響。分析表明，雙層車載對于箱梁引起的剪力滯系數比單層車載的影響要小，對于箱梁中存在引起的剪力滯后現象有一定的改善作用。 -
Abstract : the results of hi - lo strain - gauge test on 9 dead - load testing piles are analyzed. the bearing strength of single piles is evaluated preliminarily by using high strain and low strain process and conditions for correlating dynamic and dead loads and technical factors affecting the test accuracy are discussed
文摘:通過對一組靜載試驗樁高低應變動測結果的分析，對高應變法、低應變法檢測單樁承載力的可靠性作出了初步評價，並對動靜對比成立的條件及影響其測試準確性的一些技術因素進行了探討。 -
Dead - load test
恆載試驗 -
Timely monitor of their stress in each working conditions can ensure the safe of support and main arch circle with full - automatic data acquisition system. the results of dynamic - load and dead - load test of the bridge indicate that the main arch has enough strength and rigidity and reachs design requirements
使用全自動數據採集設備和處理系統，對每一工況下的支架、拱圈應力進行適時監控，確保了施工過程中支架和主拱圈的安全。成橋靜動載試驗表明許溝大橋主拱結構具有足夠的強度和剛度，達到了設計要求。 -
Based on the geometrical non - linear finite element theory, a fine iterative method of simulating all construction stages of self - anchored suspension bridge is proposed and used to pingsheng bridge. the construction plans of suspension rod and second dead load are discussed in details. the model test of pingsheng bridge is completed
此外，對平勝大橋的整體穩定性及極限承載力進行了分析，並在全橋模型上進行了超載試驗研究，結果表明，平勝大橋的總體穩定是有保障的。 -
Through testing eight composite beams with partial shear connectors under dead load and repeated load, the effect that repeated load acts on composite beams is analyzed on the basis of the test process, phenomena, and result
摘要通過8根部分剪力連接組合梁的靜載和重復加載試驗，在對試驗過程、試驗現象以及試驗結果分析的基礎上研究了重復加載對部分剪力連接組合梁受力性能的影響。 -
The damage capacity is estimated by test data. the randomness of materials and earthquake are considered during process of analysis. influences of dead load on the structural reliability were considered too
採用montecarlo隨機模擬法，分別分析了只考慮地震作用隨機性以及同時考慮材料強度和地震作用的隨機性時對結構的失效概率的影響，表明了材料強度的隨機性對結構總體失效概率有一定的影響。
分享友人