diagonal tension 中文意思是什麼
diagonal tension
解釋
對角張力-
The results reveal that the force in the members and the displacement are small when two structures are under seismic load. that the ideas of designing cable dome change from " continuous tension, discontinuous compression " to " discontinuous tension, discontinuous compression " and that the ideas of construction technique change from " moving diagonal cable " to " moving outer diagonal cable or ridge cable " is proposed
提出索穹頂結構的設計思想已經從最初的「連續拉，間斷壓」 ，發展為「間斷拉，間斷壓」 ；施工成形技術也從原來的張拉斜索，演變為張拉最外圈的脊索浙江大學申請博士學位論文葵花型索育頂結構的理論分析和試驗研究或者最外圈的斜索。 -
Make using of the critical point of the arch failure transiting to the tooth failure ( which is also the point when the non - stirrup beam ' s shear bearing capacity arrives to its minimum ) which is advanced in the arch - tooth theory of beams without shear reinforcement by g. kani and the critical point of the diagonal - tension failure transiting to the shear - compression failure which is advanced in the anti - theory, the minimum shear resistance of general bea ms which is destroyed in the range of shear - compression failure is advanced
利用g . kani提出的拱?齒理論中的無腹筋梁的拱齒破壞的分界點（也就是無腹筋粱的最小抗剪承載力點） ，再結合前述理論中所提出的梁剪壓破壞和斜拉破壞的分界點，提出了梁在延性的剪壓破壞范圍內的最小抗剪承載力，並與混凝土結構設計規范gb50010 - 2002比較，結果吻合較好。 -
Analysis of rc beam failure in diagonal tension with meshless method
利用無網格方法分析斜拉破壞鋼筋混凝土梁 -
The creative results are as follows : ( 1 ) behavior of the stirrup legs in the loading direction in the joint core ( along the loading direction for circular stirrups ) is different from that perpendicular to the loading direction. the stirrup legs in the loading direction acts as the tension chords in the truss model to resist shear, in the meantime, they confine the compressed diagonal strut from lateral expam - sion
沿受力方向箍肢（或部位）既作為桁架機構的拉桿參與抗剪又對斜壓桿受壓后沿受力平面側向膨脹的水平分量起約束作用；垂直受力方向箍肢（或部位）原則上僅對斜壓桿沿垂直受力方向側向膨脹起約束作用。 -
A method is presented to find these stretchy members and calculate their length in folded state. the result of the geometric analysis of the model made in my lab is presented. the impact response produced by the tension springs in the diagonal members is very serious and a stowing mechanism is designed for the control of the impact
由於可展天線結構展開動力來源於對角桿中拉伸彈簧，所以結構在展開過程中沖擊力比較大，為了控制其展開速度，同時為了完成天線的收攏過程，需要電機來進行控制，本文提供了一種電機控制機構的設計方案。 -
Making use of the " truss + arch " mechanical model, the range of the three shear failure models ( shear - compression failure, diagonal - tension failure and arch - rib failure ) is divided quantitatively, and the theoretical formula of shear resistance of beams and columns is educed
利用修正的桁架+拱抗剪力學模型，定量的劃分了樑柱構件受剪破壞三種狀態（剪壓破壞、斜拉破壞和斜壓破壞）的范圍，並由此推得樑柱構件抗剪的理論公式。
分享友人