diameter under load 中文意思是什麼

diameter under load 解釋
負荷直徑
  • diameter : n. 1. 直徑。2. （顯微鏡等的）放大倍數。
  • under : adv 1 在下，從屬著，服從著。 bring under get under keep under 等〈參看各該動詞條〉。 The ship wen...
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. Nowadays, the ways to detect the piles are various, and all of them are limited in some aspects. for instance, coring test do large scathe on the piles, and static load test will waste much time, money and energy, while some ways are hard to operate as the limitation of the length and the diameter of the piles, and the special condition on the spots, such as high - strain, low - strain, and so on. furthermore, the result can only be gained under the complex analysis of the collected wave, and under the validation of the coring test

    目前，工程中常用的樁基檢測方法很多，但都存在著一些弊端：有的對樁破壞性嚴重，例如抽芯檢測；有的耗時、耗財、耗力，例如靜載荷試驗；還有的如低應變、高應變等檢測技術由於受到樁長、樁徑以及現場一些特殊情況的限制，操作很不方便，而且採集到的波形要經過比較復雜的處理分析方能得出結論，而這個結論卻還要輔助取芯手段加以驗證。
  2. According to the analysis of the table lookup, the graph method and the simulating formula method of selecting bolt diameter without controlling pretightening force under dead load were presented in this paper

    摘要通過對查表法資料進行分析，提出了靜載時選擇不控制預緊力的緊螺栓聯接螺栓直徑的圖線法和模擬公式法。
  3. When the transportation load is long - term evenly distributed, the influences of each relevant factor, i. e. pipeline depth, diameter, deformation module of foundation, poisson ratio of soil and tyre pressure of vehicles, toward mises stress and vertical displacement of pipelines are discussed. when the transportation load is movable and invariable, the changing rules of mises stress and vertical displacement during the vehicle ' s movement are calculated and analyzed, and effects of vehicle velocity and tyre pressure toward these two mechanical characteristics are discussed. when the transportation load is stable and simple harmonic, the changing rules of mises stress and vertical displacement during the time of load function are calculated and analyzed, and effects of vehicle velocity and tyre pressure toward these two mechanical characteristics are also discussed. in three - dimensional analysis, mises stress and vertical displacement of pipelines under three kinds of transportation loads are calculated, and the analysis and discussion of correlative factors are also made

    當交通荷載為長期均布荷載時，討論了各相關因素，包括管道埋深、管徑、地基變形模量、地基泊松比和車輛輪壓大小分別對管道mises應力和豎向位移的影響；當交通荷載為移動恆載時，計算並分析了車輛行駛過程中管道mises應力和豎向位移的變化規律，討論了車速和車輛輪壓對這兩個管道力學性狀的影響；當交通荷載為穩態簡諧荷載時，計算並分析了荷載作用時間內管道mises應力和豎向位移的變化規律，討論了車速和車輛輪壓對管道力學性狀的影響。
  4. The experiments show that the bearing capacity of super - long and large - diameter bored piles is mainly contributed by side friction, especially by their upper and middle parts, even under the bearing limitation, the ratio of base resistance to the total load is very low because of the soil residue at the bottom of piles, so this type of piles is friction ones

    試驗表明:即使在極限荷載下，超長樁的豎向承載力仍主要由樁側摩阻力提供，且主要集中在樁的中上段，下段摩阻力很小，樁的端阻力由於樁底沉渣的影響也難以發揮出來，所以超長樁為典型的摩擦樁。
  5. Review on stability analysis of deeply embedded large - diameter cylinder structure under wave load

    在波浪荷載作用下插入式大圓筒結構穩定性分析評述
  6. Thermoplastics piping systems - end - load - bearing joints between small diameter pressure pipes and fittings - test method for leaktightness under internal water pressure, including end thrust

    熱塑管道系統.小直徑壓力管和配件間端部負荷軸承接頭.在包含端推力的內部水壓下密封性的試驗方法
  7. On the basis of construction technique of large diameter bored hollow pile of prestressing force concrete, through the program of marc, this paper analyses the pile vertical bearing capacity under different lengths, diameters and strength parameters of mediators as well as the inner force and displacement under lateral and combined loads, giving the criterion of rigid pile and flexible pile. with elastic theory, the paper establishes the inner force calculating formula under eccentric load. this research findings will set a firm theoretical foundation for its widely application

    本文在對大直徑鉆埋預應力混凝土空心樁施工工藝分析研究的基礎上，運用marc軟體，對豎向荷載作用下不同樁長、樁徑及樁周介質強度參數時空心樁的承載力性狀，以及水平向荷載及其組合荷載作用下空心樁的內力、位移變化規律進行了模擬分析，提出了大直徑鉆埋預應力混凝土空心樁的剛性與柔性界定標準。
  8. By means of numerical emulation, it analyses the pile vertical bearing capacity under different lengths, diameters and strength parameters of mediators as well as the inner force under lateral and combined loads, giving the criterion of rigid pile and flexible pile. with elastic theory, the paper deduces the inner force calculating formula under eccentric load and the bearing capacity calculating formula under vertical load ; establishes a complete design and calculating method of large diameter pile

    通過數值模擬，對樁在豎向荷載作用下不同的樁長、樁徑及樁周介質強度參數變化時樁的承載性狀進行了分析，並對樁在水平向荷載及其組合荷載作用下樁的內力變化規律進行了分析，提出了大直徑鉆埋預應力混凝土空心樁的剛性與柔性界定標準。
  9. Thermoplastics piping systems ; end - load bearing joints between small diameter pressure pipes and fittings ; test method for leaktightness under internal water pressure, including end thrust ; german version en 715 : 1994

    熱塑塑料管道系統.小直徑壓力管和管接頭之間承載端部
  10. Thermoplastics piping systems. end - load bearing joints between small diameter pressure pipes and fittings. test method for leaktightness under internal water pressure, including end thrust

    塑料管道系統.小直徑壓力管與配件間的端負荷軸承連接.包含軸向推力的內部水壓下密封性試驗方法
分享友人
分享到 Line

分享到臉書