different hardening 中文意思是什麼
different hardening
解釋
局部淬硬-
The results are summarized below : 1 ) study on soil science indicates that soil granular structure is the focus adjuster for soil fertility and it affects the space, water - grasp, aeration and anti - erosion of soil. and the percentage of aggregate is one of the key index that decides the speed and extent of soil erosion, hardening and degeneration because the soil degeneration will first lead to the disappearance of crumb - structure. so it is very important that the physical course and character of soil in different land use pattern are realized
現將主要結果摘要如下： l 、士壤學研究表明，團粒結構是土壤肥力的中心調節器，影響著土壤的空隙性、持水性、通透性和抗蝕性；任何土壤的退化首先將表現出團粒結構的消失；團聚體百分比是決定土壤侵蝕、板結等物理過程速度和幅度的關鍵指標之一，了解不同土地利用和土壤管理方式的物理過程和性質相當重要。 -
Direct - hardening unalloyed and low - alloyed wrought steel in form of different black products
不同黑色產品形式的非合金和低合金鍛造鋼的直接淬火 -
The age hardening characteristic of as - cast cu20ni20mn and cu20ni35mn alloys and the interface characteristic between the alloy and cast tungsten carbide were studied, and on the basis of this study, composites of cu - ni - mn alloy reinforced with different volume fraction ( 0 - 45vol. % ) and different size ( 42 - 362 m ) of cast tungsten carbide particles were made by vacuum hot - pressing liquid sintering technology. pin on disk two body abrasion tests have been performed with different size of sic abrasive under different loads
本文研究了鑄態cu20ni20mn和cu20ni35mn合金的時效硬化特性及其與鑄造碳化鎢的界面特性，並在此基礎上以不同尺寸（ 42 362 m ）的鑄造碳化鎢顆粒為增強體，採用真空熱壓液相燒結技術制備了不同顆粒含量（ 0 45vol . ）的鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料；以不同粒度的sic為磨料，在不同載荷條件下利用銷?盤磨損試驗機測試了復合材料的二體磨料磨損性能。 -
Most existing constitutive models do not take into account the interactions between different phases of pearlitic steel and cannot illustrate why such kind of materials has excerllent mechanical properties. it is, therefore, necessary to develop a new method, which can describe the macroscopic behavior, damage and failure of the materials and their micro structural dependence. in this paper, based on a non - classical theory of plasticity and the continuum damage mechanics, a damage evolution based on an ellipsoidal void model for mixed hardening materials is obtained
已有的關于珠光體鋼的本構模型多難以考慮珠光體材料的微結構及其相互作用，難以解釋珠光體材料何以具有較好的綜合力學性能，因此有必要發展一種多層次的細觀力學分析方法以研究此材料在復雜加載條件下計及微結構特徵的宏觀響應特性，使材料的強度、疲勞壽命的預測與其微結構及各組成相的損傷及微觀應力應變演化規律聯系起來，進而為材料微結構的設計提供依據。 -
The model revealed that different kinds of hydrates should be generated by hardening agent for different kind of soil, which is of important guiding significance for optimization design of hardening agent
該模型指出，對于不同土質類型，固化劑可能產生的水化物種類，對固化劑優化設計具有指導作用。 -
Test results show that the steel fiber in concrete have more effectiveness on improving the splitting tensile strength and the flexural strength in the early age than after its hardening ; the flexural modulus of elasticity of sfrc are higher than the plain concrete at different ages while their compressive modulus of elasticity are almost the same. it ' s also shown that, similar to the plain concrete, the early - age loading decreases the strengths of sfrc, but, with the increase of the contents of the steel fiber things are getting better, especially for the splitting tensile strength and the flexural strength
試驗結果表明：與性能穩定之後相比，在混凝土中摻入鋼纖維對它的早期劈裂抗拉強度和抗折強度有尤為顯著的提高作用；對各齡期的受壓彈性模量影響不大，而對提高抗折彈性模量有一定的效果；與素混凝土試件相同，在早期（強度達到28天強度的85前）對鋼纖維混凝土試件施加荷載會對它的各種強度產生一定的不利影響，但是摻入鋼纖維可以減輕這種不利影響，尤其對劈裂抗拉強度和抗折強度作用突出，並且含纖率越高，效果越明顯。 -
This machine fits for mixing moulding sand in large scale and medium scale foundry workshop, as well as system sand for machine moulding, fired mold sand, self - hardening sand, face sand and core sand, also fit for mixing different powder materials for industries of glass, porcelain and fireproofing materials
該機主要用於大中型鑄造車間型砂的混制，既可混制機器造型用的單一砂，又可混制干模砂自硬砂面砂和芯砂，也可用於玻璃陶瓷耐火材料等行業混制各種粉粒狀物料。 -
The tensile and compression experiment on bulk nanocrystalline ag prepared by igc method was carried on mt810 with different grain sizes and zwick 10tn2s machine at different strain rates under normal temperature respectively. the stain rate sensitivity m was found to be 0. 025, which was extremely lower than the ordinary values. also the work hardening exponent is very low
本文從用惰性氣體蒸發冷凝和真空原位壓結法（ igc ）制備得到的直徑80mm ，厚度7 . 6mm的大尺寸納米晶金屬ag樣品上切割得到符合力學實驗要求的拉伸和壓縮試樣，在mts810和zwick精密力學測試機上分別精確測定了拉伸和壓縮應力?應變曲線與晶粒尺寸和應變速率的關系。 -
The influence of different technological conditions including ph. mass ratio of gelation, the time of gelation, as well as the hardening time on yields of microcapsulation the efficiency of encapsulation were studied respectively. the microencapsulation condition were also optimized
採用光學顯微鏡、 tem 、 sem 、激光粒度分析儀研究了微膠囊的表面形態、包覆效果和粒徑分佈；採用tg和dsc研究了微膠囊的熱穩定性和儲熱調溫效果。 -
Based on above, the characteristics of hydration hardening process and microstructure of hsc as well as the interfacial layer between cement paste and coarse aggregate are investigated under low water cement ratio, high content superplasticiser and with one kind or more than one kind of mineral materials condition, the reaction mechanisms of different mineral materials are also discussed
研究了不同水膠比、復合緩凝成分高效減水劑及礦物摻合料的摻加方式、摻量對高強混凝土水泥漿體水化放熱過程和水泥漿體的水化熱、水化放熱速率以及最高溫升的影響規律。探明了高強混凝土中水泥漿體的水化硬化過程、礦物摻合料之間的相互作用機理。 -
The cyclic hardening behavior under different loading paths and different load conditions was studied
討論了材料在不同加載路徑及不同工況下的循環硬化特性。 -
In order to eliminate the beam - hardening artifacts, most current correction algorithms have to assume that the x - ray beam spectra are known and the mass attenuation coefficients of the detected object related to different energy are given
目前的多數射束硬化校正演算法需假設已知ct系統的x射線能譜，並已知構成被測物體的物質關于不同能量的光子的質量衰減系數。 -
Quenching systems for induction hardening may utilize various agitation modes including : conventional immersion quenching, open spray and submerged spray processes. these are not equivalent processes and proper engineering dictates that they be appropriately addressed. an overview of these different agitation systems is provided
感應淬火冷卻系統可能採用各式各樣的攪拌方式，包括傳統的浸淬、開放式噴霧冷卻和浸沒狀態下的噴射冷卻.這些工藝並不等效，而是要根據正確的技術要求來恰當地選用這些方法.本文對這些不同的攪拌系統進行了綜述 -
Using continuous and border conditions of each layer, the negative friction will be attained. the character of soil which is around an in the tip of the pile varied greatly. we must select different hardening or soft model
由於樁側和樁尖土性質變化較大，因此對多層土各土層可依據實際情況選擇是採用雙折線模型的硬化模型還是軟化模型。
分享友人