differential (auto) 中文意思是什麼

differential (auto) 解釋
差速器
  • differential : adj 1 差別的,區別的;特定的。2 【數學】微分的。3 【物、機】差動的,差速的,差示的。n 1 (鐵路不...
  • auto : n. (pl. autos) 〈美口〉汽車。vi. 坐汽車。
  1. The result of the simulation indicates that auto - anti slide differential gear system based on fuzzy logic control has a perfect anti - slide quality, its antomaticity and practicality are well -

    結果表明:基於模糊控制的自動防滑差速系統防滑性能好,自動化程度高,可實施性好。
  2. Aimed at the flaw of weak anti - slide function in traditional engineering machine, the thesis puts forward a new auto - anti - slide differential gear system controlled by intel 8751 microcontroller, which adopts the fuzzy logic as its control algorism and the best slide ration ( s ) as system ' s control target

    針對傳統工程機械差速系統存在防滑功能不強的缺陷,提出以intel8751單片機為控制晶元,以最佳滑移率s為控制目標,採用模糊邏輯控制為控制演算法的自動防滑差速系統。
  3. Realizing the auto - selected mating of differential chain change gear in the gear processing by self - programming

    用自編程序實現齒輪加工差動鏈掛輪的自動選配
  4. The water turbine regulation system is a complicate auto - controlling system, it ' s small fluctuation dynamic course means : when the water turbine regulation system is interfered by tiny disturbance of load or command signal, the change of different parameters in the system is less, we can thought they are subtle change near by the discussing conditions, so we can make each tache in the system linearization, that is, describe the dynamic specialty of each tache and the whole system by means of linear differential equation

    水輪機調節系統是一個復雜的自動控制系統,其小波動過渡過程是指水輪機調節系統在受到微小的干擾(負荷或指令信號擾動)時,系統中各參數的變化都較小,可以認為是在所討論工況點附近作微小變化,則可將調節系統各環節加以線性化,用線性微分方程式來描述各環節及整個系統的動態特性。
  5. Researches on differential auto - correlation technique for two - phase flow measurement

    用於兩相流測量的差動自相關測量系統研究
  6. This dissertation uses the theory of differential coefficient and makes a amending arithmetic modeling which get amending curve through dealing with the collected data. according to the amending curve, realize potentiometer auto - measuring and amending

    通過對採集到的電阻數據進行處理,獲得修刻時所需的控制量,為電位計的非線性誤差測量和修刻提供了依據。
分享友人