differential calorimetry 中文意思是什麼

differential calorimetry 解釋
差示量熱法
  • differential : adj 1 差別的，區別的；特定的。2 【數學】微分的。3 【物、機】差動的，差速的，差示的。n 1 （鐵路不...
  • calorimetry : n. 量熱法，量熱學。
  1. Power - compensation differential scanning calorimetry

    功率補償型差示掃描量熱法
  2. Dsc. plastics - differential scanning calorimetry - general principles

    塑料.差示掃描量熱法
  3. Heat - flux differential scanning calorimetry

    熱流型差示掃描量熱法
  4. Differential scanning calorimetry dsc

    微差掃瞄熱卡分析法
  5. Differential scanning calorimetry, dsc

    差示掃描量熱法
  6. Dsc differential scanning calorimetry

    微分掃描量熱法
  7. Differential scanning calorimetry ds

    差示掃描量熱法
  8. The result shows that all these system are simple eutectic, at the same time, the entropy of phase change of every system in the eutectic point is determined by using differential scanning calorimetry ( dsc ) on the basis of experimental research, through the improved one - parameter margules equation by introducing a new variable temperature, the improved equation was designed to compute solid - liquid equilibrium

    測定結果表明，這幾組體系均為簡單低共熔體系；同時利用差熱掃描量熱法（ dsc ）對上面各組體系低共熔點處的相變焓進行了測定。在實驗研究的基礎上，通過改進單參數margules方程並引入新的變量溫度，達到了將此方程用於固液平衡計算的目的。
  9. This article choosed out organic phase change materials, and, the solid - liquid - equilibrium of eleven binary system including fatty alcohol / fatty acid, n - octadecane / fatty acid, n - octadecane / fatty alcohol system were determined by cooling curve, and, t - x phase diagrams of these systems were drawn. the result shows that all these systems are simple eutectic, at the same time, the entropy of phase change of every system in the eutectic point is determined by using differential scanning calorimetry ( dsc ). and n - octadecane / fatty acid systems were calculated theoretically

    本文初選出部分有機相變貯能材料，採用步冷曲線法測定了12醇-羧酸系列、 18烷-羧酸系列、 18烷- 12醇體系共11組體系的二元固液相平衡關系，繪制了這11組體系的t - x相圖，測定結果表明，這幾組體系均為簡單低共熔體系；同時利用差熱掃描量熱法（ dsc ）對上面各組體系低共熔點處的相變焓進行了測定；並對18烷-羧酸系列進行了熱力學理論預測。
  10. Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling

    首先，系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響，並通過提高轉速或乳化劑濃度獲得相變材料納膠囊；其次，系統研究了不同成核劑對微膠囊性能的影響，找到合適的成核劑抑制了相變材料微膠囊的過冷現象；再次，詳細研究了環己烷對膠囊性能的影響，並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。
  11. Some conclusions from simulating experiments are validated though the experiments of the hot stage polarizing microscopy ( hspom ) and differential scanning calorimetry ( dsc )

    同時，通過熱臺偏光顯微鏡、 dsc等實驗驗證了部分計算機模擬實驗得到的結果。
  12. Standard test method for heat of reaction of thermally reactive materials by differential scanning calorimetry

    用差示掃描量熱法測定熱反應材料的反應熱的標準試驗方法
  13. Plastics - differential scanning calorimetry - part 3 : determination of temperature and enthalpy of melting and crystallization

    塑料差示掃描量熱法dsc第3部分：熔融和結晶溫度及熱焓的測定
  14. Plastics - differential scanning calorimetry - part 1 : general principles

    塑料差示掃描量熱法dsc第1部分：通則
  15. Xrd, transmission electron micrograph ( tem ) and polarized optical micrograph ( pom ) were used to measure the structure of nanocomposites, the nonisothermal crystallization kinetics of pp / pp - g - mah / org - mmt was studied by differential scanning calorimetry ( dsc ), and their mechanical properties were tested

    採用熔融插層法制備了聚丙烯接枝物蒙脫土納米復合材料，通過xrd 、 tem 、 pom和dsc研究了納米復合材料的結構及結晶動力學，並測試其力學性能。
  16. Polyethylene ( pe ) / pe - g - mah / org - mmt nanocomposites were prepared by melt intercalation. xrd, and transmission electron micrograph ( tem ) were used to measure the structure of nanocomposites, the nonisothermal crystallization kinetics of pp / pp - g - mah / org - mmt was studied by differential scanning calorimetry ( dsc ), and their mechanical properties were tested

    採用熔融插層法制備了聚乙烯接枝物蒙脫土納米復合材料，通過xrd 、 tem和dsc研究了pe pe - g - mah org - mmt納米復合材料的結構及結晶動力學，並測試其力學性能。
  17. Kinetics of 8 " phase precipitation and influence of electric field applying during solution process are studied by differential scanning calorimetry ( dsc ) technique

    以示差量熱分析技術（ dsc ）研究相析出的動力學及固溶電場的影響。
  18. Standard test method for determining specific heat capacity by differential scanning calorimetry

    用差示掃描熱量測定儀測定比熱容量的標準試驗方法
  19. Standard test method for oxidation onset temperature of hydrocarbons by differential scanning calorimetry

    用差別掃描熱量測定法測定烴類氧化開始溫度的標準試驗方法
  20. The composites with different compatibilizers and nano - sio2 content were characterized by means of mechanical testing, differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), fourier transformation infra - red spectroscopy ( ft - ir ), transmission electron microscope ( tem ), scanning electron microscope ( sem ), etc. the relation between the structure and property of the composites was discussed in this thesis

    研究了不同增容劑、納米sio _ 2含量對復合材料的沖擊強度、拉伸強度等力學性能；並利用差熱掃描量熱分析（ dsc ） 、 x射線衍射譜（ xrd ） 、紅外吸收光譜（ ir ） 、掃描電鏡（ sem ）等分析，討論了復合材料結構與性能的關系。
分享友人
分享到 Line

分享到臉書