diode probe 中文意思是什麼
diode probe
解釋
二極體微波探測器-
In the paper, prescale technology, interpolate method, averaging method and multiple period synchronization method are used to measure the frequency accurately. diode demodulating technology, and power attenuated method or probe coupling & water load technology are employed to measure the power of high power microwave. isothermal technology is used to improve the stability of demodulator and to expend the range of square linear region
本文採用預分頻法、內插法、多周期同步法、平均法實現了頻率的精確測量;利用二極體檢波技術，結合衰減法或探針耦合+水負載技術實現了大功率微波功率的測量;採用恆溫技術提高了二極體檢波器穩定度;完成了單片機串口通信協議設計和系統電磁兼容的分析和設計。 -
Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too
本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
分享友人