disc thickness 中文意思是什麼
disc thickness
解釋
制動盤厚度-
The bursting disc devices automatic design module can calculate the thickness of the bursting disc, select right frock, design the structure and dimension of the holder, select standard accessory and design other needed parts automatically according to the set design conditions
繪圖參數自動設計模塊能夠根據爆破片裝置原始設計條件進行爆破片厚度的自動計算、工裝的自動選擇、夾持器結構尺寸的設計、標準件自動選擇以及其它零件的設計。 -
The paper deduced the seal torque of the tri - eccentric butterfly valve and gave it a qualitative analysis. the results indicated : for the tri - eccentric butterfly valve with the same caliber, theseal torque would decrease with the butterfly disc thickness increasing ; the seal torque would increase with the radial eccentricity increasing ; however, the axis eccentricity effected on the seal torque minutely ; the seal torque would increase with the half cone angle increasing appreciably of the cone which the butterfly disc belonged to
本文還對三偏心蝶閥的密封力矩作了推導並進行了定性的分析，結果表明，對于同一口徑的三偏心蝶閥，密封力矩與蝶板的厚度近似成反比；與徑向偏心距近似成正比，變化也很明顯；而軸向偏心距對密封力矩的影響不是很大；密封力矩隨著蝶板所在的圓錐半錐角的增大而有所增加。 -
The thinner uranium foil is better for neutron measurement, so the standards is designed to be made into thin disc ( thickness 1mm and diameter 40mm ) and will be combined with matrix properly to simulate the item which to be measured
根據中子測量的經驗，認為做成片狀較好，且鈾層的厚度越薄越好，但現在所具備的製作金屬鈾片的條件最薄只能做到1mm厚。 -
The paper analyzed the struture of the tri - eccentric butterfly vavle at length, defined the tri - eccentric butterfly valve, educed the geometry function and its characteristic about the section of the butterfly disc. the results indicate : the parallel contour line across butterfly disc thickness is normal ellipse, thereby eslablished function relations between its geometry parameters ( long axis and short axis ) of three primary sections of the butterfly disc and the tri - eccentricity ; in order to avoid interference between the butterfly disc and the valve seat as well as the valve body, combining the torque, we obtained the feasible range about the rotation center of the tri - eccentric butterfly vavle
本文主要分析了三偏心蝶閥的結構，給出了三偏心的定義，推導出了蝶板截面的幾何方程及其性質，結果表明，沿蝶板厚度的平行截面輪廓線為標準的橢圓形，進而推導出了蝶板幾個主要截面的幾何參數（長軸、短軸）與三個偏心之間的函數關系；考慮到蝶板啟閉過程中避免與閥體及閥座發生干涉，結合蝶板的啟閉扭矩，確立了三偏心蝶閥回轉中心的適宜區域。
分享友人