discrete component 中文意思是什麼

discrete component 解釋
單個元件
  • discrete : adj. 1. 分離的,分立的;顯然有別的。2. 不連續的;【數學】離散的;【哲學】抽象的 (opp. concrete)。adv. -ly
  • component : adj 構成的,組成的,合成的,成分的。 component motion 【物理學】分運動。 component part 組成部分...
  1. A project's objectives are usually very clear cut and often divisible into discrete component parts.

    項目的目標通常十分明確,並且可以分解成若干個子項目。
  2. In many cases, only a complicated discrete component schematic is provided by the manufacturer.

    在許多情況下,廠家提供的只是復雜的分立元件原理圖。
  3. It is discussed that the present harmonic analyzers do n ' t satisfy the requirements of china standard for harmonic measure of quick disturbance harmonic load. the measurement error brought about by the harmonic analyzers adopting ft or fft algorithm is analyzed. a cycle discrete fourier algorithm that should n ' t be effected by aperiodic component is presented, and the results of simulation show that it has higher accureacy

    本文對電力系統諧波的測量方法,數據處理及電力牽引負荷對電力系統的影響進行了研究,論述了目前國內外生產的諧波分析儀用於快速波動諧波負荷的測量不滿足國標的要求,分析了諧波分析儀普遍採用的ft或fft演算法所產生的測量誤差,提出了一種不受非周期分量影響的全周波離散傅里葉演算法,模擬結果表明精度好。
  4. One is to use fourier transformation to convert the source signal from time domain to frequency domain and to discard high frequency harmonious components upwards of 19 ( gb / t14953 - 93 d5. 3 demanding ), then to have static huffman coding to the quantized char array which is composed of reserved direct current component and basic wave and each high frequency " s amplitudes and angles. the other is to use discrete wavelet transformation to convert the source signal from time domain to frequency domain and to set the high frequency coefficients that its absolute value is smaller than the given threshold to zero, then to have dynamic huffman coding to the quantized char array which is composed of multiple, wavelet ' s level, datum length, low frequency coefficients and reserved high frequency coefficients. mass simulinks and analyses under the two circumstances have done to show that data compression ratio is small and the relative error is also small and within the permission of engineering and the compression problem can be solved in theory of measured datum of power system

    第一種情況的壓縮方法為:採用傳統的傅立葉變換把原始信號從時間域變換到頻率域,舍棄20次及其以上的高次諧波成分(保證了gb / t14953 ? 93d5 . 3要求) ,然後對保留的直流分量、基波和各次諧波的幅值和相角數據量化后和量化時分別乘以的倍數系數構成一個數組,以字元形式保存,採用靜態huffman編碼對變換數據進行壓縮;採用離散小波變換把原始信號從時間域變換到頻率域,然後對分解得到的高頻系數進行閾值量化處理,對乘以的倍數系數、小波變換的階數、小波變換后的低頻、各級高頻以及原始數據長度、量化后的低頻系數以及保留的高頻系數大小、位置構成一個數組,以字元形式保存,採用動態huffman編碼對這個文件進行壓縮。
  5. The numerical results demonstrate that the larger the zone of timing jitter and the higher the frequency, the less proportion the discrete psd component is in the total psd

    數值計算結果表明,隨時間抖動范圍增大和頻率提高,離散功率譜分量所佔比例下降。
  6. The result shows that the psd of the electromagnetic pulses consists of a continuous component and a discrete component, with the total power of the two parts being conservative

    結果表明,這類電磁脈沖串的功率譜密度由離散譜分量和連續譜分量組成,它們組成的總功率守恆。
  7. A study on modeling, scheduling and optimal control problems for a class of hybrid manufacturing systems is investigated. in this framework, the discrete entities have a state characterized by a temporal component whose evolution is described by event - driven dynamics and a physical component whose evolution is described by continuous time - driven dynamics, thus it is a typical hybrid system. not only the optimal control for manufacturing process like that discussed in many references but also the optimal machining sequence are considered in this paper. the whole problem is solved by a two - level optimization method : at the inner loop, for any given machining sequence of the jobs, the optimal control for manufacturing process is considered ; while at the outer level, an improved genetic algorithm is used to decide the optimal machining sequence of a batch of jobs to be processed. finally, some examples are given to illustrate the validity of the algorithm

    研究了一類單階段混合製造系統的建模、分析與調度問題,這類系統既包含離散事件動態,也包含連續時間動態,前者用排隊網路描述,後者用微分方程描述.不僅考慮了a這類系統的最優控制問題,而且考慮了工件進入生產線的最優時間,並用一個復雜的優化模型描述,同時給出了一個兩層優化方法,內層給出對給定工件序列的最優控制,而外層用一改進的遺傳演算法求解工件進入生產線的最優時間序列.若干模擬實例說明了演算法的有效性
  8. Wp - le series intelligent electric power instrument is a kind of new electric power display control instrument developed and produced by wideplus company. it has adopted advanced micro - processor as its core component, it has many characteristics such as precise measurement, visual and clear display, perfect performance, good stability, strong anti - interference capability, high universality and reliability, superior performance and favorable price etc, can replace the point type instrument or normal digital display instrument including the digit display instrument constituted by electronic discrete components and universal integrated circuit

    Wp le系列智能電力儀表是上潤公司開發生產的一類新型電力顯示控制儀表,採用了先進的微處理器作為核心部件,具有測量精確,顯示直觀清晰,功能完善,穩定性好,抗干擾性能強,通用性和可靠性高,性能價格比優等特點,可替代指針式儀表或常規數字顯示儀表包括由電子分立元件和通用集成電路構成的數顯儀表。
  9. Principal component analysis applied in the discrete data of sustainable innovation ability on enterprises

    主成分分析在企業可持續創新能力的離散數據中的應用
分享友人