dispersed gas 中文意思是什麼
dispersed gas
解釋
分散氣-
A foam is a colloidal system in which gas bubbles are dispersed in a liquid or solid.
泡沫也是一種膠體體系，其中氣泡分散在液體和固體里。 -
Liberation of hydrogen gas would be increased rapidly and sic particles on the surface might be dispersed if the current density exceed the upper limit. furthermore, nickelous hydroxide would be deposited because the ph of plating solution nearby the surface rapidly increased. all of above might result in coating deterioration
若電流密度過大，超過所允許的上限值，會析出大量的氫氣，可能沖散表面覆蓋的sic微粒，而且易使磨頭表面鍍液ph值急劇上升而形成氫氧化鎳沉澱，導致鍍層質量惡化。 -
The explanation could lie in the sharp temperature jump a particle experiences when it becomes dispersed in a bubble of reactant gas.
其解釋是當顆粒被分散於反應氣體的氣泡中時，經受著溫度的突然躍升。 -
There are two types furnace coal gas or dispersed coke, three fuel adding method : middle, left and right type, while 90obetween blasting direction and fuel adding direction should be kept ; it can also be collocated agilely in line with demand of the users
其燃燒爐有兩種爐型燃煤氣或碎焦炭加燃料的方式分正左右三種，但是鼓風方向始終與加燃料的方向呈90 -
Using digital image processing technique to process the solid - gas - water three - phase flow image and separate dispersed phase from the three - phase flow image, author calculated the bubble number, particle number in instantaneous image, area of bubble image and other parameters, and analyzed the effect of image enhancement, image segmentation, image analysis and other problems existed in bubble image processing
應用數字圖像處理方法對水氣固三相流圖像進行處理，將其中的分散相分別提取出來，計算得出瞬時圖像范圍內的氣泡個數、粒子個數，氣相所佔流動截面比等參數；分析了圖像增強、圖像分割、圖像分析等方法在多相流圖像測量上的作用以及氣泡圖像處理中存在的問題。 -
Many researches have showed that the mechanical properties of al2o3 - matrix ceramics in which ti ( c, n ), tic or tin was dispersed could be improved a lot, which might be widely used in the field of machining. al2o3 - matrixed ceramics were fabricated by gas pressure sintering ( gps ) and gps with post - hip based on current techniques in this experiment. for al2o3 - ticn composite ceramics, the densitification process was controlled by the mechanism of solid phase sintering.
大量研究表明：採用ti （ c ， n ） 、 tic或tin作為第二相彌散顆粒所制備的氧化鋁基復相陶瓷相對al _ 2o _ 3單相陶瓷而言，性能有了顯著的提高這類復相陶瓷性能優良，在機械加工領域有著廣泛的應用前景本實驗採用氣壓燒結（ gps ）以及gps結合熱等靜壓（ hip ）后處理兩種工藝制備氧化鋁基復相陶瓷。 -
Influence of motionless mixer on gas holdup and dispersed phase holdup
靜態混合器對氣含率及滯液率的影響 -
The final result is a polyphasic colloidal system, in which water molecules are bound to the dispersed gas bubbles, oil droplets and solid fragments, all of which are less than five microns in size
最終的成品是由多相膠體所組成的液體，里頭散布著大小不超過五微米的氣泡、油滴及固態碎片，與水分子結合在一起。
分享友人