double-transmission method 中文意思是什麼

double-transmission method 解釋
雙透射法
  • double : adj 1 兩倍的，加倍的。2 雙的，二重的，雙重的；對，雙，兩，復。3 雙人用的；折疊式的。4 （意義）雙...
  • transmission : n 遞送；傳遞；傳達；傳染；移轉；【機械工程】傳動；傳遞；變速器；聯動機件；【無線電】傳送；發射；...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. In the brief introduction to geographical information system ( gis ), this dissertation proves that by combining reliable management with gis technology, presents a method which built the power structure model and math calculation model by using spatial data in a good interface between computer and user. this dissertation makes a number of target for calculating the distribution system, mainly aimed at circumstances which have an effect on power station repair, switch breaker, type of t connection, and double lines supply via the usage of system reliability calculation. at the same time, it provides the projected estimatio n when power station or transmission line will be added into the power system, and furnishes the theoretical information that the professional needs for power structure programming, design and equipment management

    通過建立輸變電設施管理信息系統（ mis ） ，真實地反映出油田電網輸變電設施的運行管理現狀，為網路可靠性計算提供可靠的計算依據；在簡述地理信息系統（ gis ）技術的基礎上，論證了可靠性管理與電力gis技術結合的可能性，創立了在簡潔的人機圖形界面下利用空間數據建立網路結構模型及可靠性計算模型的方法；通過建立網路可靠性計算系統，進行了計及變電所檢修影響、切換開關、 t接點及雙回線供電情況下的可靠性指標計算分析，對油田電網及變電所（線路）的改（擴）建方案、增強性措施及接入系統的可靠性給予了工程評估，為電網規劃、設計及日常的設備管理提供分析決策依據。
  2. This can fully consider the effect of the structure of transmission line and the selection of lighting parameter etc. by calculating and analyzing various of factor that affect the lightning tripping probability of 500kv double circuit transmission line, we can draw the conclusions : the result by intersecting method is more accord with the practicality circumstance than by existing standard methods, using unbalance high insulation and reverse sequence of wire can reduce the contemporary outage rate of double circuit line, reducing the footing resistance is one of the most efficiency method to reduce the back stroking rate of double circuit transmission line, the double back stroking rate and the single back stroking rate will fall by three ground wire, when the footing resistance is 10 ohm, the back stroking rate by three ground wire is 83 percent of by two ground wire

    在分析輸電線路繞擊耐雷性能時，對線路的雷電屏蔽問題進行了分析，提出對擊距法進行改進，充分考慮了風速的影響因素，編寫了具有工程實用價值的計算線路繞擊耐雷水平的程序，此方法可以充分考慮線路結構和雷電參數等對繞擊率的影響。通過對影響500kv同桿雙回線路雷擊跳閘率的各種因素進行了計算和分析，得到以下結論：採用相交法的計算結果比定義法更符合實際運行情況。採用不平衡高絕緣方式和導線逆相序排列可以大大降低雙回同時跳閘率。
  3. 2. the splitting method, enclosed planetary transmission sketch method and structure sketch method are used to deduce the transmission ratio formulas on several structures of the single - stage and double - stage spatial - cycloid - ball gearing respectively. further more, the simplified calculating formulas on one - tooth - difference and two - tooth - difference spatial - cycloid - ball gearing are given

    2 、分別運用拆分法，封閉行星機構的傳動簡圖和結構簡圖推導出單級和雙級的多種結構的傳動比公式，並給出一齒差、二齒差球面擺線鋼球傳動機構減速比的簡化計算公式。
  4. The design method of double crank mechanism and optimum transmission double crank mechanism are presented according to the conditions of minimum transmission angle, the time ratio, the factor of velocity variety or the minimum size

    摘要研究了按照最小傳動角、速度變化系數、行程速比系數以及尺寸和最小等條件設計雙曲柄機構以及最佳傳動雙曲柄機構的方法。
  5. Obtained by emtp program and the egm, this paper studies on lightning protection performance on 500kv double circuit transmission line the distributed parameter model of tower is built when analyzing the back stroking lightning protection performance for double circuit line, it can truly reflect the spreading course of lightning current on the tower, furthermore, considering the randomness of working voltage ' s phase when lightning strokes the top tower and supposing the probability of lightning appearing arbitrary phase in a cycle of ac is equal, this paper brings forward the statistical method to calculate the rate of back stroking on double circuit line

    本文利用emtp程序、擊距法對500kv同桿雙回線路的耐雷性能進行了研究。在分析同桿雙回線路的反擊耐雷性能時，建立了桿塔的分佈參數計算模型，此模型可以真實地反映雷電流在桿塔上的傳播過程。並針對雷擊塔頂時，導線運行電壓相位角的隨機性，本文假定雷擊出現于交流一周期的任一角度區間內的概率相等，提出了利用統計法計算同桿雙回線路的反擊跳閘率。
  6. It has many advantages such as several couples of teeth meshsing simultaneously, double touching lines on each interacting surface, high transmission ratio and heavy load, etc. and it ' s easy to form elastohydrodynamics lubricant film between two interacting surfaces. but this kind worm gear drive is not used widely in china. the reason is that its manufacturing method - dual generating method - is outdated

    但是，由於目前加工該型蝸桿副的方法為對偶法，必須專門加工蝸桿和專用蝸輪滾刀，對于不同參數的蝸桿副蝸輪滾刀不能通用並且在加工中需多次對刀，導致平面二包蝸桿副加工成本高而精度低。
分享友人
分享到 Line

分享到臉書