droplet distribution 中文意思是什麼

droplet distribution 解釋
液滴分佈
  • droplet : 帶菌飛沫
  • distribution : n 1 分配,分發,配給;分配裝置[系統];配給品;配給量;【經濟學】配給方法,配給過程;分紅;【法律...
  1. Using entropy theory, the droplet distribution of diesel spray is predicted in this paper as well

    運用最大熵原理,對柴油在不同噴油條件下的粒度分佈做了預測。
  2. A distribution function of droplet volume was derived using the information entropy

    採用最大熵原理,推導出噴霧場液滴體積分佈函數。
  3. For emulsions, interfacial structures, droplet sizes and distribution, and droplet motion and coalescence could be observed and recorded in situ by an integration device including a microscope, a pickup camera, a video tape recorder, and a computer with a gathering image card and a programme

    利用光學顯微鏡攝像錄像計算機圖像採集、處理集成系統,可實現對乳狀液界面結構,液珠大小及其分佈,液珠運動和聚並的動態過程進行實時觀測、錄像、圖像採集和處理。
  4. The obtained results showed that, after impingement the diffusion angle of fueldroplet changed much bigger than that of before impingement, and the same to the penetration, but the droplet size and distribution remained unchanged

    結果表明,燃油經撞擊后可顯著地增大油束擴散角、不同程度地影響了燃油束的貫穿度,但對燃油束撞擊前後滴徑變化的影響不大。
  5. This paper reports the droplet size and distribution, penetration and diffusionangle of fuel spray before and after impingement by multiple - picture overlapping photography and laser technology, as well as the fuel spray mixing and burning process in a direct injection diesel engine by high speed photography

    本文介紹了用多次噴霧疊加攝影與激光粒子分析技術對燃油噴霧撞擊前後的粒徑、貫穿度以及噴霧錐角等因素變化所進行的觀察和測量以及介紹了利用雙像高速攝影技術對燃油束撞擊霧化形成的混合氣以及燃燒過程特點的研究。
  6. The numerical simulation is carried out and the sauter mean diameter and the axial and radial size distribution of droplet of round jets and annular jets were obtained. numerical results are in good agreement with experimental data

    針對hy911圓柱形射流和環形射流,計算出霧化液滴sauter平均直徑以及軸向和徑向液滴尺寸分佈,計算結果與實驗數據吻合較好。
  7. Study of measurement for the liquid - droplet size distribution by using bpnn

    網路技術在液滴粒度分佈中的應用研究
  8. A model in which second atomization and collision among droplets was considered, for the droplet size distribution of energetic liquid jet was established on the basis of primary breakup model

    在此基礎上,考慮二次霧化以及液滴之間的碰撞,建立了含能液體噴霧場液滴尺寸分佈的數學模型,並進行了數值模擬。
  9. A lot of photographs of atomization field on high pressure jet were obtained by the use of the energetic liquid injection device and laser holographic system, so that the properties of axial and radial droplets size distribution were revealed. the relations of droplet size distribution with injection pressures, nozzle and viscosity were discussed

    利用含能液體噴射霧化模擬裝置及其全息攝影系統,得到了多種工況下液體藥射流噴霧場的全息照片,揭示了噴霧場中液滴軸向和徑向分佈規律,分析了噴射壓力、噴嘴形狀、液體粘度等對射流破碎的影響。
分享友人