elastic after work 中文意思是什麼

elastic after work 解釋
彈性後效
  • elastic : adj. 1. 有彈力[彈性]的。2. 伸縮自如的,靈活的。3. 機變的,輕快的。n. 橡皮線,松緊帶,橡皮圈。adv. -ally
  • after : adv 在後;繼后;后來。 follow after 跟著。 look before and after 瞻前顧后,前思後想。 soon after ...
  • work : n 1 工作,操作,勞動,作業;工件;功課;努力;行為,作用。2 (待辦的)事務,業務;職業。3 〈前有...
  1. Rotation - cavitation mechanism was outlined based on the experiment results and the essential conditions for the occurrence of auxetic properties in polyolefin blends were concluded as followed : firstly there must be at least two phases, the matrix can be soft materials which were able to be networks when being stretched, as well as suitable consistence must be provided between two phases. fracture stress work measurement was optioned to characterize the force between two phases. finally, the auxtic property repeatability of the blends was measured and the fact that the auxetic property could only occur in the elastic range was certificated by the result that only the specimens which were stretched for 5s, 10s had repeatability after being retained for 1 months

    實驗工作的最後一部分研究了體系負泊松比效應的可重復性,選取穩定的負泊松比共混體系在測試數據採集時間為55 、 105 、 155 、 205條件下進行測試,將樣條放置l天、 10天、 30天進行測試,測試結果表明,在5s 、 105條件下測試的試樣在放置一個月後泊松比測試結果具有可重復性,證實了體系的負泊松比現象發生在材料的彈性形變范圍內。
  2. Starting from virtual work principle, with the combination of fem, the author led into elastic stiffness practical formulation of bi - direction cellular slab. after comparing the bi - direction elastic stiffness formulation with the approximately stiffness formulation, the author drew such a conclusion that if the hole - rib is comparatively big, the elastic stiffness of bi - direction cellular slab calculated by approximately formulation would be comparatively small, and therefore the elastic stiffness could calculated by the formulation illustrated in this paper

    本文從虛功原理出發,結合有限元方法,給出了雙向空腹板的彈性剛度實用計算公式,並與近似剛度公式進行對比分析,並得出結論:在雙向空腹板孔間肋較大情況下,利用近似公式計算雙向空腹板的彈性剛度偏小,可按本文提出的彈性剛度公式進行計算。
  3. The reason is that the elastic energy increases the nucleation work while the formation of primary martensite can excite the release of elastic energy in austenite to promote the formation of after martensite and intensify the tendency towards homogeneous nucleation

    其原因是彈性能的存在增大了初生馬氏體的形成功,而初生馬氏體的形成則會激發奧氏體內彈性能的釋放,彈性能的釋放可促進繼生馬氏體形成,並增大其均勻形核傾向。
分享友人