end shielding 中文意思是什麼
-
By starting with the analysis of generator end structure and overheat sources, it is presented that the technical key required to expand the capacity of the unit is to solve the electromagnetic leakage shielding problem. by proceeding with the analysis of the reasons causing the aging of the stator winding bars insulation, the necessity for stator winding bars to adopt class f insulation and relative fixing technological improvement are pointed out so as to extend the service life of the winding bars insulation
從分析發電機端部結構及過熱原因入手，提出了增容的技術要點在於解決端部漏磁屏蔽問題；從發電機線棒絕緣老化原因分析入手，指出為延長定子線棒絕緣使用壽命，線棒主絕緣採用f級的必要性以及相關工藝的改進。 -
After electric heating system is installed, check electrical insulation of all circuits. the insulation resistance between generatrix and shielding layer, core wires of series cable before connection at end not be less than 20 m. and then check if dc resistance of circuit is normal and phase resistance is banlance
電伴熱系統安裝完工後，應逐路檢查系統的絕緣電阻：各種電熱帶母線與屏蔽層之間、串聯帶芯線尾端末短接前的各芯線間絕緣電阻均應不小於20m ；然後再檢查電熱帶直流電阻是否正常，三相電阻是否平衡。 -
It has been widely used in windows and doors, the glass curtain wall, incline daylight ceiling and so on all commercial and civil construction, such as in - door swimming pool, skating - rink and other place requires comfortable temperature, condensation control, uv and solar heat shielding, it can also be used as glass doors for such as high - end refrigeration show cabinet, freezing and cold storage equipment for medical
廣泛應用於建築門窗、玻璃幕墻、斜面採光部位等一切商用及民用建築，如游泳館、室內滑冰場，或對溫度控制及防止結露、節能環保有很高要求的地方，如高級超市陳列櫃、醫療用冷凍冷藏設備。 -
This thesis analyzes the retrofit of the end part electromagnetic shielding and the stator winding bars, i. e. the 2 technical measures taken for the purpose of expanding the capacity of 300 mw qsf - 300 - 2 type of turbine - generator
本文分析了qsf - 300 - 2型300mw汽輪發電機增容改造採取的兩種技術手段：端部電磁屏蔽的改造和定子線棒的改造。
分享友人