equilibrium beam 中文意思是什麼

equilibrium beam 解釋
平衡束
  • equilibrium : n. 1. 平衡，均衡，均勢，相稱。2. （心情的）平靜。3. （判斷的）不偏不倚。
  • beam : n 1 梁，棟梁，桁條；（船的）橫梁。2 船幅；（動物、人的）體幅。3 （秤）桿，杠桿，（織機的）卷軸，...
  1. Based upon virtual displacement method and the updated - lagrangian approach, stiffness matrices for two - dimensional elastic - plastic beam model in large displacement were proposed, in the derivation of which transverse stress was included because it was believed that part of the 2nd order effects of various stresses, which are in equilibrium with each other and with the external loads, will counteract each other and neglecting either part would possibly lead to incorrect results

    利用虛位移原理和更新的拉格朗日方法，導出了大位移彈塑性梁單元剛度矩陣的顯式表達式，在剛度矩陣推導中引入了截面內非線性剪應力和橫向應力的影響，剛度矩陣通過了剛體檢驗。之所以要引入橫向應力的影響，是因為本文認為，保持平衡所需的所有應力，它們各自的二階效應會相互抵消，因此忽略其中的任何一項都可能導致不正確的結果。
  2. ( 2 ) from the equilibrium conditions of the isolated segment from a beam - column sub - assemblage, it is clarified for the first time that the bond stress along the beam rebars passing through the joint transfers into the column end to balance shear at this column end at the same ratio as that of the compression force in the compressed concrete at beam ends

    通過對樑柱組合體柱脫離體的平衡條件，首次明確了貫穿節點梁筋粘結應力和梁端受壓混凝土的壓力以相同的比例傳入柱端以平衡柱端剪力，從而對節點區的傳力機理重慶大學博士學位論文結出了完整的和具有說服力的解釋。
  3. During calculation of the ultimate flexural capacity of composite beams, it assumes steel beam, concrete board and connecter are plastic, calculates them by ultimate equilibrium method

    在組合梁受彎極限承載力計算中，認為鋼梁、混凝土板和連接件完全塑性，採用極限平衡法計算。
  4. As regards to the spheric thin shell structure under external hydro static pressure, basing on flat - plate theory and by using basic von karman equations for large deflection, the equilibrium problem of axisymmetric bending of the spheric shell under uniform external pressure is simplified to an equilibrium problem of bending of elastic basic flat - plate and further converted into an equilibrium problem of beam on elastic fundation taking into consideration of the deformation characteristics

    對球形薄殼結構隨靜水外壓的情況，應用平板理論中的vonkarman大撓度基本方程，將球形薄殼在均勻外壓下的軸對稱彎曲平衡問題簡化為彈性基礎平板的彎曲平衡問題，進而再根據變形特點將其轉化為彈性基礎梁的復雜彎曲平衡問題。
  5. At first, the mechanical model of joint is discussed, and the constitutive relation of the rough joint, especially the bolt - supported joint, is given. then bedding slide of bedding stratified rock slope is studied adopting limit equilibrium method, and a formula of stability is brought forward. at last, the bedding stratified rock slope ' s buckling deformation and failure mechanism and its evaluating method of stability is investigated, a corresponding mechanics model is established, then detail research to this failure mode is made in theory combining the energy law and elastic stability theory of plate and beam, and an analytical solution of the yielding curve is educed from this model

    文中首先對結構面的力學模型進行了一定的探討，提出了粗糙結構面尤其是加錨結構面的本構關系；然後採用極限平衡法，研究了順向層狀巖質邊坡的順層滑動失穩，提出了其穩定性計算公式；最後，結合能量定律和彈性板梁穩定理論，探討了工程中常見的順向層狀巖體邊坡潰屈失穩時的破壞機理、變形規律和穩定性定量評價方法，建立了相應的力學模型，求出了其相應的解析解，並提出了臨界坡長與最大彎曲位置的確定方法。
  6. Firstly, the study of real two - channel data recorded by the airborne battlefield radar is made based on the methods of gmti, which including the study of methods of two - channel equilibrium, that of the precious estimate of beam scanning angle, that of the doppler center, that of the compensation for pattern error and that of gmti and that of location of the moving target using the phase - comparison mono - pulse method

    首先，結合動目標檢測方法，對機載遠程戰場偵察雷達實驗系統錄取的雙通道數據的處理進行了研究。內容包括兩通道均衡方法研究，波束掃描角精確估計方法研究，多普勒中心估計方法研究，方向圖誤差補償方法研究，動目標的檢測和干涉定位方法研究。
  7. In the analysis, a cfst arch ( single tube ) is first divided into a finite number of straight beam elements. according to the virtual work principle and the modified newton - raphson iteration method the tangent stiffness matrix considering double nonlinear properties is established. with regard to the non - equilibrium forces, the material nonlinear property along the height of the section and the length of the element is considered and the computation accuracy is improved as a result

    本文首先將拱肋劃分為一系列的直梁單元，運用虛功原理和修正newton - raphan數值迭代演算法的基本原理準確推導了拱肋直梁單元的非線性切線剛度矩陣；在不平衡力方面考慮了沿截面高度和單元長度方向材料非線性的發展過程，提高了計算精度；再根據得到的切線剛度矩陣採用荷載增量步內修正newton - raphan迭代的增量迭代法進行了求解。
  8. From the point of the behavior of spandrel beam in the course of test, there are four clearly stages based on the three characteristic points : bending cracking of floor beams through the column, diagonal cracking of spandrel beams and / or bending cracking of floor beams above the spandrel beams ( including floor ) and bending yield of floor beams through the column. in the last stage, the torque of spandrel beams seems more like an equilibrium torque than a compatibility torque. the law of

    從邊主梁的受力看，以過柱子次梁的彎曲開裂、邊主梁的扭剪開裂以及樑上次梁（包括樓板）的彎曲開裂和過柱子次梁的彎曲屈服為受力特徵點劃分為四個受力階段，其中邊主梁在過柱子次梁的彎曲屈服后的受扭則更多地具有平衡扭轉的性質，而在這以前是協調扭轉。
  9. The equilibrium path is traced using the arc - length scheme with the rigid - pin - joint model in which the spatial beam elements are used in single - layer parts and spatial truss elements are used in the double - layer parts. thus the stability behavior is summarized and the critical load is obtained. 2

    本文採用鋼、鉸接模型，即單層部分採用空間梁單元，雙層部分採用空間桿單元，應用弧長法跟蹤了網殼結構的平衡路徑，總結了此類網殼結構的失穩規律，並且得出了結構由單層過渡到雙層時臨界荷載的變化規律。
  10. ( 2 ) though a group of transducer laid to beam, it can test horizontal signal and vertical direction signal. so testing the equilibrium amount only need to install workpiece once

    通過懸臂樑上安裝的一組傳感器，可同時採集水平和垂直兩個方向上的振動信號，實現了一次安裝條件下測出一周不同相位上的動平衡量。
  11. A mixed finite volume element method for solving the beam equilibrium equations

    解梁的平衡方程的混合有限體積元方法
  12. The distance from figure center of the parabola to the potential slide surface is less than half of the section length. mechanical conditions of this method include not only force equilibrium but also moment equilibrium. as for the beam - on - foundation, its pressure can be calculated by homogeneous hypothesis or winkler foundation hypothesis or infinite half elastic foundation hypothesis on the pulling anchor - cable step and by coulomb active earth pressure theory approximatively on the long term working step

    對于樁在滑面以上段所受的坡體荷載，提出可按形心偏下的拋物線型分佈模式計算，並在滿足力的平衡條件的同時還滿足力矩平衡條件；對于地樑上作用的坡體荷載，提出在錨索張拉階段可按均布或溫克爾（ winkler ）地基假定或彈性半無限體地基假定來計算，在工作階段則一般可以近似按庫侖主動土壓力理論計算。
分享友人
分享到 Line

分享到臉書