evaporation temperature 中文意思是什麼

evaporation temperature 解釋
蒸發溫度
  • evaporation : n. 1. 蒸發（作用），發散，升華沉澱作用。2. 脫水（法）。3. 蒸氣。4. （電子的）發射。5. 蒸發量。6. 消散。
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. The hydrology and aerography indexes change in the middle of the rainy season in dry - hot valley are explored in this paper, which involves the mean ground temperature, relative humidity, runoff on trunk, rainfall, evaporation quantity, etc

    摘要對雨季中期乾熱河谷加勒比松林林中與林邊平均地溫、空氣相對濕度、樹幹流量、降雨量、蒸發量等水文氣象指標進行了研究。
  2. Under the assumption that the inner surface of stator sleeve and outer surface of rotor are smooth, taking the fact into account that the temperature of stator sleeve of evaporation cooling motor keeps almost the same, horizontal evaporation cooling motor is simplified as a physical model of two coaxial sleeves, with outer sleeve ( the stator ) holds still and keep at constant temperature and inner sleeve ( the rotor ) is rotating and heated

    本文通過數值和實驗手段研究了臥式蒸發冷卻電機楔形氣隙中的流體流動、傳熱現象。本文在定子套筒和轉子表面光滑的假設下，針對蒸發冷卻電機定子套筒壁面基本恆溫的特點，將實際蒸發冷卻電機簡化為同軸套筒內筒加熱旋轉、外簡靜止定溫的物理模型。
  3. Taking the lest total internal losing exergy for target function, the distribute of difference in temperature among the three - effect is also acquired. an experimental device for three - effect falling - film evaporation was designed and constructed. the experiments of potassium carbonate solution was finished under different temperature of vapor and different input material liquid volume

    建立了三效降膜蒸發的實驗裝置，以碳酸鉀溶液為原料進行了不同加熱蒸汽溫度、不同進料量的實驗研究，得到了實驗設備的（火用）損分佈，並研究了各部分損失的（火用）及有效利用的（火用）值與加熱生蒸汽溫度與進料量的關系。
  4. The evaporation of sodium tellurite glass in low gravity is explored and the formation and growth processes of teo2 microspheres are explained. the size of teo2 microspheres from low gravity is much larger than that from ground experiments and it is affected mainly by the temperature of melt in the heating coil and the duration time of vapor cloud during drop experiments

    探索了微重力對亞碲酸鈉玻璃熔體氣化的影響，分析了微重力下由於玻璃熔體氣化而生成teo _ 2玻璃微球的過程，解釋了微重力下形成的微球尺寸遠遠大於摘要地面模擬實驗所得微球的原因。
  5. Sodium tellurite glasses are considered as potential candidates for non - linear optical applications because of high refractive index values and wide infrared transmittance. on the other hand, because the glasses have relatively low melting temperature and low viscosity after melting, they are often chosen to study the melting, evaporation and solidification of glasses in low gravity

    另一方面，由於這類玻璃的熔融溫度較低，在溫度較高時會揮發產生氣體，熔融后熔體的粘度較低，玻璃形成能力強，因此被用來研究微重力下玻璃的熔化和氣化，和微重力對玻璃析晶能力的影響。
  6. Evaporation : two u. s. weather bureau class a pans are operated at king s park. the mean water temperature is taken to be the mean of the daily maximum and minimum surface water temperature

    蒸發：天文臺使用兩個美國氣象局甲級蒸發皿于京士柏氣象站量度蒸發量，以皿內每日量得的最高及最低水面溫度之平均數作為當日的平均水溫。
  7. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統，電子膨脹閥應該根據具體製冷劑的熱力性質選取；電子膨脹閥流量系數對孔徑和脈沖數比較敏感；在結構固定時，流量系數隨蒸發溫度的降低而升高，隨冷凝溫度的增加而增大，受過冷度變化的影響較小；電子膨脹閥的容量受孔徑影響最大。
  8. On the basis of the investigation on the related literatures of new refrigerants substitutes and new refrigerant oil, the in - tube evaporation of refrigerant and refrigerant - oil mixtures. this paper make a experimental research on the saturated temperature of propane ( r290 ) and lubricant oil ( suniso 3gs ) mixtures, evaporation heat transfer and pressure drop characteristics in a horizontal micro - fin tube

    本論文在參考研究國內外有關製冷工質、替代製冷工質及其含潤滑油混合物在水平管內流動沸騰換熱研究現狀的基礎上，對丙烷（ r290 ）與潤滑油suniso3gs的混合物的飽和溫度、水平微肋管內流動沸騰換熱及壓降進行了實驗研究與理論分析。
  9. C ) the evaporation temperature has negligible effect on the average evaporation heat transfer coefficient at the same oil concentration

    C ）同一含油率下，蒸發溫度對平均換熱系數影響不大。
  10. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。
  11. Tests the operation status of an air - cooled heat pump air conditioner under defrosting conditions, and records the evaporation temperature and exhaust fan current at different voltages

    摘要實驗測定了一臺空氣源熱泵空調機組除霜工況下的運行狀況，記錄了蒸發溫度和不同電壓下的排風機電流。
  12. When the energy distribution of secondary neutron are represented by evaporation spectrum ( lf = 9 ), care must be taken in describing the nuclear temperature near the threshold

    通過分析發現，評價次級中子能譜數據所採用的蒸發譜模型大都忽略了能級密度參數與激發能之間的關聯。
  13. Numerical calculation is carried out and the figures of temperature - rise and water - evaporation are obtained

    在此基礎上通過數值計算，得到了磚坯溫度上升和水分蒸發的曲線。
  14. Fully as much care in design is required to store these fluids at room temperature without excessively rapid evaporation.

    要在室溫下儲存這些流體而又不過快地蒸發也需要十分精心的設計。
  15. The temperature - rise and water - evaporation rates are compared for different positions of brick dried and the main factors that affect the drying time are analyzed

    對比了不同位置的溫度上升和蒸發速率變化，並簡要分析了影響乾燥時間的主要因素。
  16. The rate of evaporation depends on the material and such factors as the temperature, the surface area, amount of ventilation, and the pressure exerted on the surface

    蒸發速率取決于材料及諸如溫度、蒸發面積、通風量和施加在此蒸發面上的壓力等因素。
  17. The parameters mean the evaporation capacity or the volume, pressure, and temperature

    介質參數是指蒸發量或容積、壓力、溫度。
  18. The ultra - thin er layers with the thicanesses in the range of 0. 5 ~ 3 monolayer ( ml ) are formed by electron beam evaporation on si ( 00l ) substrate at room temperature in an ultra - high vacuum system. after annealing at lower temperatures, ordered simcfores form on the surface. the trallsition of the surface reconsmiction pattem from ( 2 x l ) to ( 4 x 2 ) with the increase of er coverage up to l ml is observed by the reflective high energy electron diffraction ( rheed ) and low energy electron diffraction ( leed )

    本文是關于硅（ 001 ）襯底與電子束淀積的鉺、鉿原子反應形成的超薄膜的界面與表面性質的研究，以及在該襯底上出現的共振光電子發射現象，包括了以下四個方面的工作： 1鉺導致的硅（ 001 ）襯底上的（ 4 2 ）再構研究利用反射高能電子衍射和低能電子衍射，在室溫淀積了0
  19. In this paper, we applied the vapor - liquid - solid three - phase circulating fluidized bed evaporator to condense glucose solution considering its advantage. in the experiment, we changed the parameters such as evaporation temperature, difference in temperature of the fluid heating and heated, liquid flux, liquid thickness and the ratio of inert particles to analyze and study this kind of equipment ' s heat transfer properties in different operational conditions

    通過改變蒸發溫度、傳熱溫差、料液流量、料液濃度以及惰性粒子的體積分率等參數，研究了其在不同操作條件下的傳熱性能，並給出了汽-液-固三相循環流化床蒸發器沸騰傳熱的數學模型，模型預測值與實驗值吻合較好。
  20. The results show that the exhaust fan current increases with frosting enhancement, while the increasing speed gets slower in the end of frosting, and the curves of current are slightly different at different voltages ; that the evaporation temperature decreases with frosting enhancement, and the decreasing speed becomes increasingly faster ; and that misoperation of defrosting can be avoided by using the intelligent defrosting control method based on exhaust fan current combined with evaporation temperature presented according to the experimental results

    結果表明，排風機電流隨結霜厚度的增加而增大，增加速率在結霜後期趨緩，不同電壓下電流變化曲線略有不同；蒸發溫度隨結霜厚度的增加而降低，下降速度越來越快；使用根據實驗結果提出的基於排風機電流和蒸發溫度聯合控制的智能除霜方法可以基本避免誤除霜動作。
分享友人
分享到 Line

分享到臉書