exterior-protected construction 中文意思是什麼

exterior-protected construction 解釋
圍護結構
  • exterior : adj 1 外面的,外部的;外表上的,表面的 (opp inward)。2 外界的,外在的 (opp internal intrinsic...
  • construction : n 1 建築,結構,構造,架設,鋪設;建設;設計;工程;建築法,構造法,建築物;【戲劇】搭置,布景,...
  1. On the basis of expound the theory of building exterior - protected construction energy consumption and the gene of influence the building energy, set up mathematics model, this article discuss the mechanism of dispelling the heat of the buildings " thermal bridge and the complication that influence it, and then synthetic analysis and calculate the influence range of building thermal bridge in exterior - protected construction column thermal bridge to the building outer wall get the conclusion that when the construction column can satisfy the building stress - area, in bulgy construction column dispel less heating than out bulgy construction column. but if the pole stuck out more than 100mm, in bulgy or out bulgy make no difference

    本文在闡述建築圍護結構耗熱原理以及影響建築能耗因子的基礎上,採用數值模擬方法,探討了建築熱橋傳熱的基本機理和影響建築熱橋傳熱的因素,進而對建築熱橋在圍護結構傳熱中的影響范圍進行了綜合分析和計算,研究了構造柱熱橋型式對建築外墻能耗的影響,得出了構造柱在滿足建築受力面積要求的情況下,內凸構造柱較外凸構造柱略能減少散熱量的結論,但是凸出過大( 100mm )無論內凸還是外凸對建築耗熱都沒有大的差別。
  2. Adopt ansys software, mimic calculate and then economy analysis, work out that building outer exterior - protected construction

    最後通過實驗驗證了對建築熱橋理論分析的正確性。
  3. Study the design factor such as site selection, layout, depth, exterior - protected construction act, which must be considered in design period, and make relevant conclusion

    對設計過程中遇到的選址及基地規劃、建築布置、進深、維護結構等設計要素進行重點研究論述,並得出相應結論。
  4. Focusing on this, the thesis points out the designer should consider not only capacity of heat transmission of exterior - protected construction, but also its absorption of heat duting the choice and design of exterior - protected construction

    這一特點也決定了辦公建築設備在運行上的不連貫性,針對這一點,本文提出在選擇和設計外維護結構時,不僅要考慮維護結構的傳熱量,還要考慮它的吸熱量。
  5. Present thermal bridge influence area to the building out exterior - protected construction. for the construction column thermal bridge, the influence area increase 100mm along the thermal bridge. the position of maximum heat - flux is between the thermal bridge and the outer wall

    給出了熱橋對建築外圍護結構的影響區域,對于構造柱熱橋其影響范圍為熱橋邊沿向外100mm ,熱流量最大的位置在於熱橋與外墻交界處。
分享友人