fan inlet flow 中文意思是什麼

fan inlet flow 解釋
風扇進口氣流
  • fan : n 1 扇子;風扇,鼓風機。2 簸箕;揚谷機;(風車的)定風翼;【航空】螺旋槳,螺旋槳葉片。3 扇狀物(...
  • inlet : n. 1. 進口,入口。2. 【電學】引入,輸入,輸入線。3. 水灣,小港。4. 插入物,鑲嵌物。vt. (inlet, inletting)1. 引進。2. 嵌入,插入。
  • flow : vi 1 流,流動。2 (血液等)流通,循環。3 流過;川流不息;(時間)飛逝;(言語等)流暢。4 (衣服、...
  1. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀,在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響,並在此基礎上採用無節流方法測量流量,以風機調節性能曲線為依據,建立了基於徑向基函數( rbf )神經網路的風機流量全程監測模型;以實驗室4 - 73no . 8d離心風機為研究對象,探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律;最後用visualc + +語言開發了風機性能在線監測系統。
  2. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案:主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量;模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變;實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  3. On the basis of analyzing the theory of gas - solid two - phase flow, the paper put forward two ways of lightening the erosion of centrifugal fan from the point of view of initiative preventing erosion : changing fan ' s inlet and changing fan ' s impeller

    本文在分析離心風機氣固兩相流動理論的基礎上,從主動防磨角度提出了兩種減輕風機磨損的方法:改造風機進氣箱和改造風機葉輪。
  4. Vortexs are observed after the beams, which greatly influence the inlet air - flow of fan, reduces the air - flux, causes noise and wastes energy

    支承結構造成的流體繞流現象在風機進口處形成渦流,造成風機風量減少,噪聲增加,浪費能源。
分享友人