first order vibration 中文意思是什麼
first order vibration
解釋
一階振動-
Because the method of structure vibration which based on syntony stimulation and blasting vibration is not a simple one, in order to decompose the syntony stimulation of blasting vibration, fourier transform of blasting vibration is introduced at first
由於結構震動理論是以諧激勵為基礎的，而爆破震動並不是簡單的諧激勵，因而首先介紹爆破震動的傅氏變換理論，以便於分解爆破震動中的諧成份。 -
2 ) the value of base frequency, which is the first order vertical - bending vibration, is bigger in box girder bridges than those of t - beams. it shows that the vibration performance of box girder bridge is better than t - beams. 3 ) when considering the shear deformation of beam, the vibration frequency calculated by is bigger than those not considering the shear deformation
T型梁的基頻為橫向振動，而整體箱梁的基頻為豎向彎曲振動；整體箱梁的一階豎彎振動的頻率比t型梁得到了提高；整體箱梁的動力性能優于t型梁；考慮剪切變形后，梁的自振頻率降低，對于整體箱梁其降低值接近於5 ，在分析時不應忽略。 -
Jacket is the most widely used offshore platform structural style. first of all, the paper summarizes the present achievements of dynamic analysis for offshore platform, and studies both the vibration isolation system for jacket and vibration - suppressed effectiveness. considering the style and character of jacket, and in order to make best use of dampers to reduce vibration, a damping isolation scheme, in which the damping layer is laid between the jacket cap and deck is put forward
本文在總結國內外對海洋平臺結構動力分析研究現狀的基礎上，針對淺海導管架式海洋平臺的型式與結構特點，研究了導管架式海洋平臺結構阻尼隔振體系及其減振效果，為了充分發揮阻尼器的耗能減振作用，提出了在平臺結構導管架端帽和甲板之間設置柔性阻尼層的新型阻尼隔振方案。 -
In order to set up the dynamic model of swimming micro robot, this dissertation builds up the statics model and analyses the micro motion amplifying performance of micro robot mechanism, builds up the vibration model of micro robot and analyses the vibrating performance without and with damp, researches the propelling force of driven wing and the resistance of micro robot in liquid based on the theory of flat board resisting stream, builds up the dynamic model of swimming micro robot for the first time in nation and analyses its swimming performance which is influenced by driving signal frequency, amplifying performance of main machanism, area of driven wing, character of fluid and so on. this dissertation manufactures the micro robot and sets up the experimental environment and tests the amplifying effect and the vibrating performance
本文建立了主體機構靜力學模型，研究了主體機構的結構參數對微位移放大性能的影響；建立了主體機構振動模型，研究了主體機構在無液體阻尼和有液體阻尼情況下的振動特性；根據流體力學平板繞流理論，研究了驅動翼產生的推進力和微機器人在流體中受到的阻力；在此基礎上國內首次建立了泳動微機器人的動力學模型，並對模型進行了深入的研究，詳細闡明了驅動信號頻率、主體機構放大性能、主體機構振動特性、驅動翼面積、液體性質等因素對微機器人泳動特性的影響。 -
In practical application, the m10 180 bolts, which are installed in the head cover of the torque divider of ts5560 special automobile, sometimes fracture all of a sudden. according to the tests of acceleration, stress and strain, and the exciting test, it is resonance vibration that leads to the compound - bending fatigue fracture of the bolts. the exciting force caused by drive system, transmitted through the torque divider, produces a 1000 - 1500hz cyclical excitation at the junction of the bolts and head cover, which causes the first order bending resonance vibration of the bolts
通過加速度、應力應變測試實驗和激振試驗的研究，發現ts5560特種車分動器取力器氣缸端蓋m10 180螺栓斷裂問題是由於共振引起的雙向彎曲疲勞斷裂：傳動系統工作所產生的激勵，經過分動器結構的傳遞（特別是分動器一階扭轉模態的放大） ，在螺栓的連接處產生1000 1500hz的振動激勵，其導致螺栓一階彎曲共振，在螺栓一階彎曲模態的阻尼比較小的情況下，使得螺栓產生較大的共振響應，導致螺紋處的彎曲動應力較大，疲勞壽命較低。 -
Then, the program based on complex eigenvalue method was employed to investigate the influence of three parameters on vibration - controlled of cables. final, in term of character of vsd which is strongly dependent on temperature, the method based on lowermost damper of first order vibration - controlled aim at design tiptop temperature and checked at minimum temperature is presented, in which available shear area of damper is calculated
最後，在學習國內外研究成果的基礎上，根據粘性剪切型阻尼器的溫度依賴性強的特點，提出在設計最高溫度下，以滿足一階制振目標的阻尼值下限為標準設計阻尼器插板的有效剪切面積，最後在設計最低溫度下復核拉索各階制振目標是否滿足的設計方法。 -
The elastic vibration curves of generalized coordinates in a motion ' period are obtained ; the dynamics stresses in the links are calculated ; the change conditions, of vibration model of the first to fourth order are also obtained. a post - processing method, including color mapping and animation technique and so on, is used in the kinematics and dynamics analysis of planar linkage. the results of the application are favorable
充分運用matlab軟體強大的圖形顯示功能，將運動學、動力學分析結果進行了可視化處理，將色彩映射運用到圖形之中，並運用動畫技術，實現了動畫效果的圖形顯示，取得了較好的直觀效果。 -
Consequently using 0. 5 order torsional vibration to first and third stage diagnosis has much engineering utility values
因此，利用0 . 5諧次扭振對內燃機進行一級診斷和三級診斷具有較強的工程應用價值。 -
In order to decrease the size of fragmentation and reduce blasting vibration effects on the stability of eastern open pit slope of tongshankou copper mine < this work involved two steps. first of all, based on the experiment in laboratory, this paper presented the optimum blasting parameters and applied it in practice
為降低銅山口礦露天采場生產爆破的大塊率和地震波振動強度，保證采場東幫陡邊坡的穩定，本文在對國內外大量文獻綜合調研的基礎上，首先採用正交設計對現場爆破參數進行了室內模型實驗，得出優化的模型爆破參數后又應用於生產。 -
The principal work in this paper is to investigate the third - order nonlinear optical properties of three new organometallic complexes with z - scan technique, and study the molecule structural vibration of these complexes. in order to further understand their nonlinear optical characters there are six chapters in this paper, which can be divided into three sections : in the first section, i. e. chapter one, the current status of the development and practical applications of nonlinear optics are introduced briefly the third - order nonlinear optical effect is introduced particularly
本文的工作主要是利用單光束z掃描技術研究了三種新型金屬有機化合物的三階非線性光學特性，並且利用拉曼光譜技術探索了這些化合物的結構振動信息，試圖從結構方面更深入的了解其非線性光學性質。論文共分六章，其主要內容概括為三個部分：第一部分，即論文的第一章，簡單介紹了非線性光學發展的現狀以及非線性光學的現實應用和意義，著重介紹三階非線性光學效應，用z掃描方法測量三階非線性光學系數的方法和理論。 -
An fem model of rotor - bearing system was set up for a single - span - two - disc test rig to obtain such model parameters as the first and second order natural frequency and vibration mode vectors
摘要以某單跨雙盤模型轉子實驗臺為例，建立了該轉子軸承系統有限元模型，得到轉子系統前兩階固有頻率和振型向量等模態參數。
分享友人