flow-friction characteristics 中文意思是什麼

flow-friction characteristics 解釋
流動摩擦特性
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • friction : n. 1. 摩擦，阻力。2. 傾軋，沖突，不和 （between）。3. 擦熱皮膚。
  • characteristics : 產品性能描述
  1. Friction characteristics of oscillatory laminar flow in straight tube

    圓直管內層流振蕩流的摩擦特性
  2. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  3. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。
  4. In this paper, the working fluid is air. experimental study of the nine different structure parameters of 3 - d ift with staggered arrangement fins in the reynolds number range of 250 to 30000 is performed to investigate the characteristics of heat transfer and flow friction behavior. analyses and reduces the experimental data by the least square method, obtains the nusselt and fanning friction fitting criterion equations

    本文以空氣為工質，在re 250 30000范圍內對九根具有不同肋形結構尺寸的肋叉排三維內肋管的換熱及流動特性進行了研究，並運用最小二乘法分析和處理實驗數據，獲得努謝爾特數，范寧摩擦系數與雷諾數，肋幾何參數的準則方程式。
  5. Based on the measured data, the change of the friction velocity of turbulent flow and the characteristics of the wall shear stress under different sudden roughnesses and different water depths are analyzed herein

    通過實測資料分析不同糙率突變和不同水深的紊流摩阻流速變化情況和水流的壁面切應力的特點。
  6. Study on friction torque characteristics of flow distribution shaft

    油水兩相乳化液流動特性的實驗研究
分享友人
分享到 Line

分享到臉書