flow-rate range 中文意思是什麼

flow-rate range 解釋
流量范圍
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  • range : vt 1 排列；整理（頭發等）。2 使歸類[班、行、隊]；把…分類。3 〈用被動形或反身形〉加入，站住…的一邊...
  1. Increasing ultrasound intensity in the range of cavitation threshold and cavitation peak value, decreasing monomer concentration and increasing the temperature make the induction period shorter. under optimized reaction conditions, the conversion of ba can reach 90 % in 11 min at high n2 flow rate the viscosity average molecular weight of the obtained pba reaches 5. 24 106. the molecular weight of pba varies with ultrasonic irradiation time, indicating that the ultrasonic induced emulsion polymerization is dynamic and quite complicated, polymerization of monomer as well as degradation of polymer occurs concomitantly

    一、實現了無常規化學引發劑存在下的超聲輻照引發丙烯酸正丁酯（ ba ）間歇乳液聚合，制備了pba納米粒子，在11min內轉化率達到90 ，分子量達5 . 24 10 ~ 6 ，隨反應時間的延長而降低，表明超聲輻照引發乳液聚合是一個動態的復雜過程，單體的聚合和聚合物的降解同時發生。
  2. Finally, we can not use electric power but the engine of bus or subsidiary engine to drive air compressors of bus air conditions. because the change range of turnaround speed of engine is very wide, that brings difficulties in controlling the rate of flow of cold - producing medium. in the control of bus air - conditions, preventing evaporator from freezing to make the air - conditions work with high efficiency and controlling the temperature of railway carriage are the basic tasks in air - condition control

    與一般的建築空調相比，汽車空調的工作環境惡劣，條件差，控制難度要增加很多，主要體現在以下幾個方面：一是車外熱負荷變化大，難以確定控制參數；二是要求空調負荷大，而且要控制空調使其降溫迅速：三，不便於用電力作為動力源，必須用汽車發動機或輔助發動機來帶動壓縮機，當採用汽車發動機作為動力源時，由於汽車的車速變化大，發動機轉速的變化可從600r min到4000r min ，壓縮機轉速與發動機轉速成正比，其轉速變化高達7倍，給空調系統製冷劑流量控制帶來困難。
  3. According to the experimental data of droplet size 、 particle spectrum range 、 droplet cone shape 、 flow rate 、 cover area and cover area rate which obtained through changing the pressure of power sprayer and the nozzle diameter in greenhouse ， this paper made comparative analysis on atomizing performance in same pressure and different nozzle type between same nozzle type and different pressure. the conclusion is that : the ejection rate and the droplet cone shape change with the variation of pressure and nozzle diameter ， average particle diameter decreases obviously and particle quantity increases obviously with the increase of pressure and decrease of nozzle diameter. these results will lay experimental foundation for precise spraying 、 low pollution and highly effective operation

    本文根據溫室內動力噴霧機壓力與噴嘴孔徑的變化影響霧滴大小、粒譜范圍、霧錐形狀、流量、覆蓋面積及覆蓋面積率的試驗數據，對相同壓力下不同噴嘴型號和相同噴嘴型號時壓力不同時的微粒化性能進行對比分析和研究，得到如下結論噴出量與霧錐形狀隨著壓力和噴嘴孔徑大小變化而變化；平均粒徑隨著壓力的增加和噴嘴孔徑的減小而明顯減小；粒數隨著壓力的增加和噴嘴孔徑的減小而明顯增多，為精噴量、低污染、高防效的防除作業奠定了實驗基礎。
  4. If increasing drawing interval, the movement and flow range of top coal will enlarge, and the velocity gradient on flow cross - section will diminish, so that it is good for controlling the flow rate of thin sand among loose top coal

    研究表明，加大放煤步距，頂煤運移流動的范圍變大，流動斷面內速度梯度變小，有利於控制細砂的下竄速度。
  5. The effects of such elements as primary flow total pressure, flow rate, degree of fuel rich, nozzle structure, flying speed and secondary combustion on ejecting mode performance were researched. it was found that thrust augmentation can be achieved on the condition that the flying mach number is above 0. 7. to deeply analyze thrust augmentation mechanism in low speed range, the research was further continued by changing secondary combustion organization and aft - body configuration

    研究了一次流總壓、流量、富燃程度、噴管結構、二次流來流速度、二次燃燒組織對引射模態性能的影響，發現實驗樣機構型在0 . 7ma以上的飛行條件下可以獲得推力增強，而在0 . 7ma以下無推力增強。
  6. The tramsission rate exceed to the range of isa bus, moreovcr the pci bus can be competent for the rate request. the card makes use of the total line in pcicontroller, the slice of fifo, fpga and super - speed a data correspondence chip, which can solve the transmission stream and total line in pci connecting problem. and realizes the mpeg - 2 deliver to flow with establish outside delivers

    此速率超過了isa總線所能支持的傳送速率，而pci總線能夠勝任這一要求，由此確定節目傳輸流發送卡採用pci總線。此卡利用pci總線控制器、 fifo晶元、 fpga晶元、高速串列數據通信發送晶元，解決傳輸流與pci總線之間的介面問題，實現了mpeg - 2傳輸流與外設的高速數據傳輸。
  7. Concentric jacket pipe surrounded the test condenser. steam was generated in the boiler, flowed upward to the inlet of connection pipes, then flowed downward into the condenser tube, the cooling water flowed countercurrently through the annulus. the experiment covered the range of the pressure 1. 0 ~ 3. 0bar, heating power 2. 0 ~ 15. 0kw, steam mass flow rate 0. 001 ~ 0. 004kg / s, air mass flow rate 0. 0 ~ 0. 00163kg / s, and cooling water temperature 20 - 60 ?

    在系統壓力為0 . 1 0 . 3mpa ，加熱功率為2 15kw ，蒸汽質量流量為0 . 001 0 . 004kg s ，空氣質量流量為0 . 0 0 . 00163kg s ，二次側冷卻水溫度20 60的范圍內，系統研究了豎直下降管內含有空氣的蒸汽冷凝特性，獲得了不同壓力、不同空氣含量和不同加熱功率下，冷凝段的溫度分佈和局部熱流密度的數據。
  8. Using minimum water supply cost as objective function, the secondary series of optimal dispatch model was set up. the optimal combination of fixed - speed pump and the optimal range of rate and flow in varied - speed pump station were elaborated. applying these methods for water supply system in yuci city, the result show it can save energy, which illustrate this optimal dispatch model was successful

    以供水費用最小為目標函數，建立了給水系統的一級優化調度和二級優化調度的宏觀模型；詳細闡述了泵站中只有恆速泵時恆速泵的最優組合方法，含有調速泵時，給出了確定調速泵最佳臺數、最佳調速范圍和調流范圍的計算方法。
  9. Abstract : according to the character and actual condition of rh in shanghai baogang, molten steel flow in ladle and its effect on decarburization were studied with a three dimension turbulent flow and concentration modelling. the results show that, within a certain range, the decarburization rate increases not only with the increase of snorkel diameter and ar fluid flow but also with the decrease of the immersed depth of the snorkel

    文摘:根據上海寶鋼rh的特點和實際情況，建立了三維流場、濃度場程序，對鋼包內鋼水的流動、處理過程的脫碳進行了研究，並對它們的影響因素進行了分析.結果表明，在一定范圍內增加循環管直徑和吹氣流量、減小浸漬管浸入深度有助於提高脫碳速度
  10. After analyzing the theory of mtdi and setting up the model of moving target echoes, the dissertation discusses in detail the effect of moving target doppler center frequency and doppler rate on the conventional sar image. it also analyzes detailedly the range migration of moving target from time field and frequency field and provides migration model in both fields. after that, it divides algorithms of mtdi into several classes, analyzes the influence of signal - to - noise on the detection results and gives the flow chart of moving target imaging processing

    本文的主要貢獻包括： 1 、建立了運動目標回波散射模型，深入探討了進行常規sar成像時，動目標的多普勒中心頻率和調頻率對動目標圖像造成的影響；從時域和頻域兩方面詳細分析了由於目標運動造成的距離徙動效應，建立了距離徙動模型；然後研究了動目標檢測原理，並對現有的檢測方法進行分類，使之更加系統化；詳細分析了動目標信噪比對檢測結果的影響，給出了sar系統動目標成像流程圖，指出了動目標成像中的關鍵環節。
  11. The blood flow increases with the increment of the compression degree when heart rate and the blood pressure range at the near end are invariable

    心率和近段血壓范圍不變時，流量隨著收縮程度的增加而增加。
分享友人
分享到 Line

分享到臉書