flux rate 中文意思是什麼

flux rate 解釋
流量
  • flux : n 1 流,流出;流動。2 漲潮。3 不斷的變動,波動。4 【物理學】流量,通量,電通量,磁通量。5 熔解,...
  • rate : n 1 比率,率;速度,進度;程度;(鐘的快慢)差率。2 價格;行市,行情;估價,評價;費,費用,運費...
  1. Temperature also affects the rate of decomposition and thus the nutrient flux rate.

    溫度還會影響分解的速度,從而影響養分流的速度。
  2. The experimental results showed that the extraction rate and mass transfer flux increased with the field strength increasing

    在自行設計的連續電泳萃取池內實驗研究了電場強度、兩相流速等因素對丁醇萃取率及傳質通量的影響。
  3. ( 1 ) it was found from the obtained results that increasing of flux will led to decrease in froude no. of the following water at the shrinking section which will reduce rate of disspated energy, this will make the protection of dam surface more difficult

    主要結論如下;隨著流量的增加,消力池收縮斷面弗勞德數減小,消力池的消能率減小。壩面平均流速增大,壩面的防護難度增加。
  4. The dual - bath coagulation method suggested by j. a. va n ' t hof could be used in membranes with high selectivity clearance rate of low - molecular weight substances and moderate water flux theoretically. therefore it may be applied in the field of hemofiltration. to improve and optimize the performance of the pes ultrafiltration membrane applied in the hf, here the flat membranes and hollow fiber ( hf ) membranes are made in certain conditions based on the dual - bath coagulation method where pes is used as the membrane material, dmso as solvent and pvp & peg as additives this paper includes five parts as follow : 1

    為了改善和優化聚醚碸超濾膜(單浴法)在血液過濾實際應用中的性能,本論文以j . a . van ' thof等提出的雙凝固浴法為基礎,以聚醚碸( pes )為主要成膜材料,以二甲基亞碸為溶劑,並添加一定分子量的致孔劑( pvp ,聚乙烯吡咯烷酮)以及一定分子量的添加劑( peg ,聚乙二醇)按照一定配比在一定溫度下製成透明均一的鑄膜液,靜置脫泡后在一定的工藝條件下製成聚醚碸平板膜和中空纖維膜,然後通過測試膜的結構和性能來評估其用於血液過濾中的前景。
  5. The results indicated that, the fabrication process of ultra - fine grain material is mainly determined by the stress, rotate speed and the flux of cooling water. the grain refining and the hardening effect are mostly affected by the rotate speed and the flux of cooling water. compared with commercial ly12, the invalidate strength and the prolongation rate of the ultra - fine grain material are properly improved in the measurement of compression property ; and the abrupt change of the dilatability of the ultra - fine grain material at 500c is found ; also the phenomena of which the grain size of these microstructures is stable when annealed under 300c is observed

    研究表明,採用本文提出的摩擦壓扭強變形區轉移法可以得到棒狀的超細晶材料,軸向壓力、扭轉速度和溫度是採用該方法制備超細晶材料的主控參數;試件的旋轉轉速和冷卻速度對變形區晶粒細化和硬化效果影響顯著;超細晶ly12的壓縮性能與淬火+自然時效狀態的ly12壓縮性能相比,斷裂強度和延伸率均有一定程度的增強;超細晶ly12的熱膨脹系數在550左右發生明顯的變化。
  6. Firstly, when the 10kv high pressure motor start up, the rate of false action caused by automatic switch protector ( asp ) will raise dramatically ; secondly, at moment of on / off switch, great electromagnetic flux induced in the asp cause damage

    一是在10kv高壓電機的啟動時,高爆保護器的誤動作率明顯提高;二是在分合閘瞬間,較大的電磁影響甚至造成了保護器的損壞。
  7. According to gaseous " molecular kinetic, the mass diffusion rate is within finite value. so theoretical conclusion of mass flux ' s producing and the essential relation of flux vs. force could be drawn. with the assumption that local density states in near equilibrium and the distribution is gradual changed, the classical first pick ' s law was modified considering mass relaxation time

    根據氣體分子運動論對質量傳播速度為有限值情況下的質量流的產生及流與力之間的本構關系作了理論推導,在假定局域濃度處于近平衡態,其分佈為漸進的情況下得到了考慮質量鬆弛作用的經典fick第一定律的修正式。
  8. The experimental results showed that the transfer rate of bilirubin was obviously enhanced after fixing albumin into the high - flux asymmetric membrane. the clearance of bilirubin was 43. 6 %, while blank membrane was only 3. 4 %

    以20小時計,促進傳遞膜對結合膽紅素的清除率為43 . 6 % ,而相應空白膜僅為3 . 4 % 。
  9. It can rescue the patients who eat any kind of mistake food or medicine. this machine can display the numerical value of pressure, ph, flux, and give the alarm of sound or light alarm. it can complete to wash the stomach process automatically, according to the demand and also can operate artificially, increasing the successful rate for rescuing of the patients

    該機器在醫院里用於清洗胃內毒物,搶救各種誤食藥物或者食物中毒的病人,該機具有顯示壓力、流量、 ph值等測量結果及其多種聲光報警,增加了儀器的安全性,能按要求自動完成清胃過程,也可人工操作,增加了搶救病人的成功率。
  10. Experimental results show that the order of fluoride salt being put in and flux type also influences the phases constitution, morphology, distribution and absorbent rate of ti and b. the experiments on remelting master alloys and al or al alloys at a certain temperature range show that the phases constitution and size have a remarkable heredity

    試驗結果表明,不同的氟鹽加入順序和熔劑種類的不同也直接影響著中間合金中化合物的相組成、形態、分佈以及中間合金中ti 、 b的實收率等。在用純鈦顆粒法制備中間合金時,熔煉溫度的改變只能影響tial _ 3晶體的尺寸大小,而無法改變其形態。
  11. An expression is derived using basical concepts of physics ( i. e. mass conservation ), to define the relationship between sediment transport rate and vertical flux of sediment to the seabed

    從基本的物理概念和物質守恆定律導出了海底沉積物通量的計算表達式,應用該式取得了與實際海域相符的海底沖淤分布圖。
  12. This theoretic model employs the basic idea of correlation measurement, achieve the density wave speed by the correlation of the signals of upper and lower sensors, and get the total flow rate and water cut through the theoretic relationship of density wave speed and total flow rate as well as holdup with the help of drift flux model so as to accomplish the oil / water two - phase flow measurement at last, using the limited available experiment data, the theoretic model has been simplified into an applicable linear alternative which is suitable to homogeneous oil / water two - phase flow measurement to accomplish the oil / water two - phase flow measurement using the density wave phenomena is of highly theoretically valuable for density wave theory research as well as oilavater two - phase flow measurement research. to develop new type oil / water two - phase flow instrumentation based on this theoretic measurement method will be very applicable and promising

    在此基礎上,針對穩態密度波理論提出了基於密度波理論的油水兩相流測量理論模型,該模型以密度波傳播理論作為基礎,通過上下游傳感器信號相關獲得密度波傳播速度,利用密度波傳播速度與總流量以及持相率的理論關系結合漂移模型來求解總流量和含相率,實現油水兩相流的測量,在理論分析的基礎上,在實驗資料有限的條件下,對基於密度波理論的油水兩相流測量理論模型作了極限的簡化,提出了本文油水兩相流測量理論方法應用在測量均勻油水兩相流中的實用線性模型。
  13. Although the flux per revolution of the optimized pumps is a little smaller than that of tatsuno combined pumps, other characteristics, such as fluctuation rate, maximum pressure angle and velocity fluctuation rate etc, are much better. the methods to cut gears are proposed in the theory for the practical produce in the future

    雖然,在體積相等的條件下,優化出來的外圓弧包絡線內嚙合齒輪泵的排量略小於tatsuno組合泵的排量,但其它性能(如:流量脈動率、最大壓力角、速度波動量)都更優。
  14. This temperature calculation method avoids the non - correspondence between the flow rate and heat flux, which may exists in that used by boiler manufactures, and was employed to calculate the tube temperature of dangerous position that concerns with the retrofit scheme of superheater 1 of tower type coal - fired 330 mw once - through boiler in pucheng power plant for 100 % and 50 % operation load

    針對蒲城電廠330mw塔式燃煤直流鍋爐1號過熱器的改造方案,利用本文提出的方法與電廠鍋爐常用的壁溫計算方法分別計算了100 %與50 %鍋爐運行負荷下危險部位的壁溫。
  15. As the dangerous position needed to be verified has been identified with the known heat flux profile and the characteristics of flow rate distribution, the metal tube temperature of the position can be obtained

    此方法克服了目前常用的電廠鍋爐壁溫計算方法中校核點工質流量與熱負荷並不一定互相對應的缺點。
  16. Of the currently available coolers for electronic products with a high heat flux, microchannel heat sinks have been proved to be able to provide the best heat transfer performance and are one of the most promising coolers. the manifold microchannel ( mmc ) heat sink has many advantages such as low thermal resistance, compact structure, little amount of coolant, low flow rate, uniform temperature distribution along the flow direction and many others, so it is able to provide the best heat transfer performance : lowering the maxmal temperature and the temperature difference

    在目前高熱通量電子產品冷卻器中,微通道熱沉已被證實是傳熱性能最佳且最具應用潛力的冷卻方式之一,而歧管式微通道熱沉因具有低熱阻、結構緊湊、所需冷卻液量小、沿流動方向溫度分佈均勻等優點則成為減小電子元器件換熱表面最高溫度、降低溫度變化的一種有效方法。
  17. The predicted results showed that maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux would increase with increasing phosphorus mass flow rate when excess - air coefficient or air flow rate was constant

    模擬結果表明,無論過剩空氣系數固定還是空氣流量固定,隨燃磷量的增大,最高燃燒溫度、煙氣出口溫度、壁面平均熱流和最大熱流都呈上升趨勢。
  18. Based on the mass and energy conservation equations of the borehole and formation - borehole system, the decisive functions between production rate and flow flux as well as temperature of the fluids in the borehole as all depth of the well have been deduced in this study

    本文在井筒及井筒?地層系統中的質量能量守恆方程基礎上,推導出了沿井身的地層各相產出速度與井眼流量溫度之間的決定性方程組。
  19. The result of analysis shows that the convective heat flux has main effect on fuel pyrolyzing and vaporizing, the liquid layer of pe fuel can increase the regression rate but also can cause unstable burning. 4

    研究結果表明:對流熱流是引起燃料熱解氣化的主要因素, pe熔化產生的液體層提高了燃料熱解退移速率,但液體層厚度增加到一定程度時,對發動機工作穩定性有負面影響。
  20. The results of e - o tests showed that ktp crystals by our flux technique is an attractive material for various e - o applications, especially used in a high - repetition - rate and high responsible laser system

    電光應用試驗結果表明,本實驗的熔劑法ktp晶體是一種非常吸引人的電光材料,特別是適合用於高重復頻率、高響應速度等激光系統。
分享友人