flux-linkage 中文意思是什麼
flux-linkage
解釋
磁通匝鏈數-
Analyzing the limitation of method to observe the stator flux linkage of traditional dtc, indicated the key approach to achieve improvement for dtc preferment is to observe the flux linkage accurately
深入研究了傳統dtc控制採用的定子磁鏈觀測方法的局限性，提出實現高性能的dtc控制的關鍵環節是實現對電機磁鏈的準確觀測。 -
Permanent magnet synchronous motor ( pmsm ) drived by triphase sinusoidal current is research object in this paper. its mathematics models in several coordinate are set up, controlling principles of flux linkage and torque are discussed under dtc and the block diagram of pmsm with dtc is presented
本文以三相正弦波驅動的永磁同步電機（ pmsm ）為研究對象，建立了其在不同坐標系下的數學模型，並深入探討直接轉矩控制中永磁同步電機的磁鏈和轉矩的控制思想，給出控制方案。 -
According to the characteristics of dtc ( direct torque control ) in induction machine, this paper analyzed the estimation error of flux linkage and torque, and introduced an improved method of flux estimation, a compensation method based on low - pass filter
摘要根據感應電機直接轉矩控制的特點，對低速下磁鏈觀測誤差產生的原因進行了分析，給出了一種磁鏈觀測的改進方法低通濾波器補償法。 -
This paper gives the fundamental equation of electric circuit of switched reluctance generator ( srg ). the phase flux linkage, indutance and phase current of srg are discussed based on unsaturated magnetic circuit
給出了開關磁阻無刷發電機的相電路基本方程，分析了基於不飽和磁路條件的相磁鏈、相電感和相電流。 -
This paper also use non - linear feedback decoupling theory to decouple die vector - control close - loop system into linear decoupling of rotor speed and rotor flux linkage subsystems. the speed regulator and flux linkage regulator of these two linear subsystems can be designed with classical linear theory
本文同時還應用非線性反饋解耦理論將矢量控制的閉環系統分解為線性化的轉速子系統和轉子磁鏈子系統，兩個子系統中的速度調節器和磁鏈調節器可按線性理論設計。 -
Considering the system ' s wide speed range and ipm ' s switching frequency ' s top limit, the variable flux linkage locus structure control has been executed in the full speed adjusting range
考慮到系統調速范圍寬和逆變器開關頻率的限制，在全頻域採用分段變磁鏈軌跡結構的控制方法。 -
Based on the theory creation of space voltage vector ' s polygonal flux linkage locus, freewill partition of the ideal flux circle is realized by the software method. furthermore, different polygonal flux linkage locus ' s fluent switching point is also found, which overcomes the motor " switching failure and improves the speed adjusting dynamic performance
在充分研究磁通軌跡法原理的基礎上，採用軟體方法實現了任意多邊形磁鏈軌跡的生成；並找出了不同磁鏈軌跡間的平滑切換點，解決了切換時的電動機失步問題，提高了系統轉速調節的動態性能。 -
The accurate calculation of the input voltage and the compensation for the dc - offset error and the variation of the stator resistance are important factors in practical implementation of the integration since they can cause a drift in the stator flux linkage trajectory and furthermore deteriorate the quality of torque control
因此，輸入電壓的準確計算、直流漂移量的補償以及定子電阻變化的補償都是影響積分計算準確性的重要因素，這些誤差會導致定子磁鏈軌跡的偏移，進而降低系統轉矩控制的性能。 -
In the synchronous " model, based on the idea of polygonal flux linkage locus, by means of constructing the switch state period table of three phrase voltage inverter is required. in the brushless model, the igbt ( isolated gate bipolar transistor ) switch state period table is gained by gal ( generic array logic ) which analyzes the signal of position feed - back
在同步方式下，基於多邊形磁鏈軌跡法的思想，用作圖法求得三相電壓型逆變器的pwm波形序列；在無刷直流方式下，用gal對位置反饋信號進行邏輯綜合，得到開關管的導通規律。 -
A variable - speed dtc pmsm system is set up to verify the dtc theory in pmsm, that is to control the toque by controlling the torque angle of motor if the stator flux linkage keeps constant. this paper points out the function of the space voltage vector by which the torque angle can be changed according to the need of torque of the motor
主要作了以下開創性的工作：系統地闡述了永磁同步電機直接轉矩控制理論，發展了原有的控制理論，明確了空間電壓零矢量在控制系統中的重要作用? ?保持電機轉矩輸出，減小轉矩脈動，據此提出了包括零矢量的新型控制方法。 -
The system uses the permanent magnet synchronous machine as the driver motor based on the idea of polygonal flux linkage locus and the permanent magnet brush - less motor is as the momentum balance motor by means of speed and current loop in order to track driver motor precisely and rapidly. the harmonious control of driver motor and balance motor is realized by making full use of the dsp hardware resource and complicated programmable logic device. the software design is composed of c and assembly language to realize motor control arithmetic of polygonal flux linkage locus
衛星天線伺服控制系統以正弦波永磁同步電機作為驅動電機，採用多邊形磁鏈軌跡法（電壓空間矢量法）的控制策略；動量平衡電機採用永磁無刷直流電機，通過電流環、速度環達到快速、精確跟蹤驅動電機的目的，確保了衛星姿態恆定；設計方案中充分利用了dsp硬體資源和復雜邏輯陣列實現了驅動電機和平衡電機的協調控制，並通過c語言和匯編語言的混合編程實現了電機的多邊形磁鏈軌跡控制演算法。 -
This paper applied many methods to eliminate the estimation error of the flux linkage. finally, a sensor - less dtc pmsm system is implement and has a good performance
系統的調速范圍可達1 : 100 ，電機額定轉矩的階躍響應時間為1ms ，動態響應優秀。 -
The main achievements of the thesis are as follows : ( 1 ) kinds of techniques to detect magnetizing inrush of traction transformers are thoroughly investigated in this paper, and their limitation are indicated and corresponding improvement techniques are proposed. ( 2 ) in this paper, flux linkage equilibriun equations are used to build " ash - box " models of some traction transformers based on system identification, such as two - winding single - phase traction transformer, impedance - matching equilibriun traction transformer and scott traction transformer
論文的主要內容有： （ 1 ）詳盡分析了現有的針對牽引變壓器勵磁涌流演算法的保護演算法，提出了每種演算法的局限性及其改進方法； （ 2 ）提出適用於鐵道電氣化系統中各種牽引變壓器對應的三?二相轉換規則，利用該規則可將對應量的轉換置於保護軟體中，從而可大大減輕在牽引變壓器兩端外部復雜的接線。 -
In order to minimize the torque ripple of srd, the dissertation further design the intelligent torque control system, introduce the instantaneous torque control strategy based on torque distribute function, which is implemented by the flux linkage controller of srm. furthermore, considering the multi control parameter, the article also found the rotor position angle controller based fuzzy logic so as to optimize the whole control system and effectively reduce the torque ripple
為了降低srd系統的轉矩脈動，本文在所建模型的基礎上，設計出智能化轉矩控制系統，利用轉矩分配函數，提出瞬時轉矩控制策略，同時採用磁鏈控制器來實現；考慮到srd具有可控參數多的特點，本文同時建立了優化轉子位置角的模糊控制器來達到智能化轉矩控制的目的，從而有效抑制sr電機的轉矩脈動。 -
A dtc scheme of twelve - section stator flux linkage for pmsm
永磁同步電機定子磁鏈十二區間直接轉矩控制 -
The novel flux linkage method of the three - phase pwm rectifier with optimum control
整流器優化控制的磁鏈法 -
This paper discussed two - pole permanent magnetic spherical motor, in which two poles of rotor are permanent magnets. the electro - magnetic relationship is analyzed and the electro - magnetic model has been developed, which includes voltage equations, flux linkage equations, and electro - magnetic torque expressions
本文研究了雙極永磁型球形電動機的電磁關系，將不對稱繞組折算為對稱繞組，建立了電機的電磁模型：電壓方程式、磁鏈方程式和電磁轉矩方程式。 -
Based on the relationship between real and estimated values of the stator flux linkage, the compensatory formulas of the estimated flux linkage and its principle block diagram were presented
這種方法在採用低通濾波器代替純積分環節的基礎上，根據定子磁鏈的實際值與估計值之間的關系，推導出估計磁鏈的補償公式，給出了原理框圖，並對觀測結果進行了模擬比較。 -
In order to solve the problem of direct torque control ( dtc ) for permanent magnet synchronous motor ( pmsm ) related to the flux and the torque ripple and the uncertainty of switching frequency, a method which shorten the voltage - vector - function - time by svm ( space vector modulation ) is developed, and in order to improve the system performance, the stator flux linkage sectors and vectors are subdivided
摘要為了解決永磁同步電機傳統直接轉矩控制低速時磁鏈和轉矩脈動大的問題，提出了1種用空間矢量調制（ svm ）實現減小電壓矢量在1個控制周期中的作用時間的直接轉矩控制方法;為進一步提高系統性能，對磁鏈扇區和電壓矢量進行了細分。 -
Secondly, the adopted motor control method - - direct torque control is introduced. then, the initial flux linkage establishing and the electromagnetic torque ripples are analyzed
然後，介紹了本文所採用的電機控制方法? ?直接轉矩控制，並分析了傳統直接轉矩的初始磁鏈建立問題和電磁轉矩脈動問題。
分享友人