foam cell 中文意思是什麼

foam cell 解釋
泡沫細胞
  • foam : n 1 〈只用單數〉泡沫；（馬等的）涎沫[大汗]。2 泡沫材料，泡沫狀物，泡沫橡皮；泡沫塑料。3 〈詩〉海...
  • cell : n 1 小室，單室；隔間，艙；〈詩〉茅舍；（單個的）蜂窩，蜂房。2 〈詩〉墓穴，墓。3 （大修道院附屬的...
  1. Closed cell polyethylene foam backer rod

    密封微孔聚乙烯泡沫墊棒
  2. The metabolites eliciting inhibition to foam cell formation process of macrophage produced by endophyte hccb00017 were studied. several products were isolated through solvent extraction, and silica gel chromatography et al. one compound, hccb00017 - a, showed cytotoxicity ; the other two, hccb00017 - c and hccb00017 - e, showed inhibitory activity against foam cell formation process of macrophage

    對具有巨噬細胞泡沫化抑制活性的植物內生菌hccb00017的代謝產物進行研究，應用溶媒萃取、硅膠柱分離等方法，從其發酵液中分離出具有細胞毒性的活性物質hccb00017 - a ，以及具有巨噬細胞泡沫化抑制活性的組分hccb00017 - c和hccb00017 - e 。
  3. 1760 samples produced by endophytes reserved by shanghai health creation center for biopharmaceutics r & d were tested on several models, and many bioactive samples were selected. the result of second round indepth - screening for these bioactive samples demonstrated that three samples still possecced great inhibitory ability against foam cell formation process of macrophage

    本研究對1760份植物內生菌發酵樣品的活性通過多個模型進行了初步篩選，結果發現多個活性樣品，對活性樣品進行復篩，發現其中有三份樣品對巨噬細胞泡沫化抑制活性仍較強。
  4. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  5. Puma introduces the first foam - free midsole with puma cell technology

    Puma介紹其cell （蜂巢）技術，是為首個無泡綿中底
  6. The fitness of four negative electrode materials such as al, fe, zn, cd, and of six membranes materials : microfiber glass mat separator, polyethylene, polypropylene, polyvinyl chloride, vinylon, soapnated cellulose acetate, and of four current collects : carbon fiber ; nickel foam ; nickel foam sthongthened by iron wire net, punched silver grid in the super - iron alkaline batteries was comparatively studied. the influence of two storaged method ( with and without electrolyte ) and two impurities ( zno, fe ( oh ) 3 ) to the experiment cell ' s self - discharge nature was also comparatively studied. at last, the nature of discharge. structure and electrochemistry of experimental cell with k2feo4 as cathode active material prepared by three different methods : high temperature reaction, hypochlorite oxidizing and electrolysis, was comparative ly studied. we can conclude : i ) the open - circuit potential and the flat of work potential and the percent of capacity of k2feo4 till 1. 0v during the discharge at constant load of experimental cells decreased by the order of al / k2feo4, zn / k2feo4, cd / k2feo4, fe / k2feo4. as for the nature of charge - discharge cycle, cd / k2feo4 fe / k2feo4 zn / k2feo4. in water solute electrolyte, although al / k2feo4 can n ' t be used as storage battery, it have great potential as primary cell or storage cell from the aspect of its discharge capacity. discharge power

    採用組裝實驗電池、 x -射線衍射（ xrd ）和循環伏安（ cv ）的方法，從實驗電池的放電特性、充放電循環特性、自放電特性，不同高鐵酸鹽的結構特性和電化學特性幾個方面，對4種金屬負極材料（ al 、 fe 、 zn 、 cd ） 、 6種隔膜材料（復合玻璃纖維、幅射接枝聚乙烯、改性聚丙烯、聚氯乙烯、維尼綸無紡布、皂化再生纖維素） 、 4種集流體材料（泡沫鎳、以鐵網為加強層的泡沫鎳、切拉銀網、炭纖維編織網）在堿性高鐵電池中的適用性進行了比較研究；對2種雜質組分（ zno 、 fe （ oh ） _ 3 ）和2類不同貯存方式（干、濕）對實驗電池自放電特性的影響進行了比較研究；對3種方法（高溫固相反應、次氯酸鹽氧化、直流電解）所制k _ 2feo _ 4的實驗電池的放電特性、結構特性和電化學性能進行了比較研究。
  7. In this paper closed - cell foam samples with basically controllable pore structure and uniform distributed pore were prepared by means of melt foaming technique ( mft ). by relative theory analysis and adjusting the content of foam agent, foaming temperature, stirring time and hold time, means of getting samples with high quality has been found

    本文採用熔體發泡法，通過相關理論分析和控制發泡溫度、攪拌時間、保溫時間、調節發泡劑含量等制備出了孔結構基本可控、孔洞分佈均勻的閉孔泡沫鋁樣品。
  8. The mathematical model of cell size growth during microcellular foam injection molding process was studied, and the mathematical relationship between process parameters and cell size was established

    摘要研究了微細發泡注塑成型工藝中微泡長大的數學模型，建立了成型工藝和微泡尺寸之間的數學關系。
  9. Coopreating with foreign professional company, with nanometerails and our special foam machine, luen tai brassiere foam is provided with long time non - yellowing and delicate cell structure

    同國外專業公司合作，採用納米材料，配合自己的具有多項專利技術的發泡機，聯大胸圍海綿具有獨特的抗黃變技術。
  10. Centrifugal slip casting for preparing open - cell al2o3 foam

    離心成形法制備開孔氧化鋁泡沫
  11. Effect of relative density on compressibility of al - si closed - cell aluminum foam

    閉孔泡沫鋁材料的壓縮行為
  12. Specification for flexible cellular materials - vinyl chloride polymers and copolymers closed - cell foam

    柔軟泡沫塑料氯乙烯共聚物和大量分子聚合物規范
  13. Standard specification for flexible cellular materials - vinyl chloride polymers and copolymers closed - cell foam

    軟質泡沫材料標準規范.氯乙烯聚合物和共聚物
  14. I will also include a piece of the black closed - cell foam rubber " skin " which may have to be worn in more than one layer, but which, because it is thin, is easily added to without being too bulky

    我也將附上一份黑色的封閉的塑料橡皮「皮膚」 ，您也許不得不穿上它超過一層，但是由於它很薄，他很容易被穿上，而不會顯得太臃腫。
  15. Production and application of the open cell polyurethane foam

    網狀聚氨酯泡沫塑料的制備及應用
  16. Meanwhile, employing hg / hgo elecreode as reference electrode and nickel foam as counter electrode, a semi - cell model was made

    同時，以hg / hgo電極作參比電極，泡沫鎳為對電極，製作了半電池模型。
分享友人
分享到 Line

分享到臉書