force variation 中文意思是什麼
force variation
解釋
力的變化-
The common principle is the use of the induction of an electromotive force by the variation of the magnetic flux through a coil.
一般原理均是使用通過線圈的磁通量變化感應的電動勢。 -
The results show that all the three earthquakes occurred at the time intervals when the greater variation in the tide generating force at the epicentre appeared and the solar activities partially descended
分析結果表明，盡管這3次地震的震級都較小，但都發生在震中所受引潮力變化較大時刻和太陽活動局部下降時段。 -
The results show that : the main driving forces of arable land change of shouguang county are the per capita income, the ratio of the pasture output value, the ratio of the cropping output values and the ratio of agricultural labor force proportion ; the main driving forces of arable land change of quzhou county are the variation of grain yield per unit area, the ratio of the pasture output value, the ratio of the cropping output values, the ratio of grain field areas and the population density
結果表明：壽光市耕地變化的主導驅動力包括人均收入、牧業總產值比例、種植業總產值比例和農林牧漁業勞動力；曲周縣耕地變化的主導驅動力包括糧食單產、牧業總產值比例、種植業總產值比例、糧田面積佔耕地面積比例和人口密度。在此基礎上，揭示縣域尺度上耕地變化的驅動機制，並為進一步進行土地利用覆蓋變化研究積累方法和經驗。 -
Thus the use of these coefficients makes it easy to account for the variation in the prestressing force along the tendon.
因而，應用這些系數使得易於考慮預加力沿鋼筋的變化。 -
Tfv tractive force variation
縱向強迫震動 -
Applying perturbation technique, the image force on dislocation is obtained when dislocation located arbitrary point either outside or inside inhomogeneity, however, a number of previous related investigations on above problems only calculated the interactive dislocation force as the dislocation lies on the x - axis. the variation of screw dislocation forces for correlative material parameters and different radians of crack or rigid line is discussed particularly
針對以往大多數相關文獻~ （ [ 7 ] - [ 16 ] ）只求出了位錯在x軸上時位錯力表達式，本文應用擾動技術，導出了位錯在基體或夾雜中任意點的位錯力公式；並討論了位錯力隨材料相關參數，裂紋或剛性線弧度的變化規律。 -
Parametric active contour model to deal with automatic segmentation of weak edge medical image. based upon analyzing balloon force model, a minimum variation snake model is proposed and successfully applied to segmentation of weak edge medical image. in the model, variable force incorporating the information of foreground and background regions replaces constant force in the balloon snake model
高斯力和氣球力等傳統的參數活動輪廓模型難以處理弱邊界醫學圖像自動分割問題，在氣球力snake模型基礎上，提出最小方差snake模型，該模型將氣球力snake模型中的恆定氣球力修改為包含區域信息的變力，以目標和背景兩區域具有最小方差為準則，引導輪廓曲線運動。 -
Solution of nonlinear wave loads in regular oblique seas. based on strip method, thinking about nonlinear factors such as no straight shipboard on waterline, the instantaneous variation of wet surface shape and slamming effect of ship bottom, the numerical methods of nonlinear fluid force in large amplitude oblique regular seas are discussed
關于斜浪規則波中非線性波浪載荷的計算:本文基於切片理論，考慮到船體非直舷、水下剖面形狀的瞬時變化以及砰擊等非線性因素，討論了大波幅斜浪規則波中非線性流體力的時域計算方法。 -
The simulations get the variation curve of the torque acted on the helical gear spline during translating process, and get the important damping force acted on the middle part during engaging and disengaging process
模擬還求得了作用在螺旋齒花鍵上的扭矩在動態過程中的變化曲線；求得了作用在中間件上，起關鍵作用的阻尼力在嚙合、脫開中的動態變化曲線。 -
The possible factors including the deviation of temperature in length and breadth of rod, the changes of transfiguration resisting force under the changes of temperature, the adjustment of roll gap, the variation of rolling pressure, the changes of roller speed during dynamic adjusting press, the unmatched of seconds - flux under the dimension fluctuation of the coming sample and so on. the whole system was a closed loop which factors in it interacts each other
可能的影響因素有:沿軋件縱橫向溫度變化、由溫度引起的軋件變形抗力變化、軋機輥縫值變化、負載變化、電機調節系統由不穩定向穩定過渡過程中軋輥轉速的變化（如咬鋼過程中的動態速降后的回復階段） 、來料尺寸波動造成秒流量不匹配等，整個模擬系統是各個因素相互影響關聯的一個閉環系統。 -
Works on the bending roll system of four - roll rolling mill, the workroll shape variation caused by the force of bending roll and the contact stress between rolls was researched with the fem software ansys, the maximum deformation of the work roll was calculated, and the curve of the gap adopting the least - squares method was fitted, which set the base of the further calculation of load - gap shape
摘要以四輥軋機的彎輥系統為研究對象，利用有限元分析軟體ansys研究彎輥力和輥間接觸應力引起工作輥形狀的變化，計算工作輥彎曲的最大變形量，並用最小二乘法對輥縫曲線進行擬合，為進一步計算有載輥縫形狀提供可靠的理論依據。 -
Gravity instruments are designed to measure variation in the force of gravity from one place to another rather than the absolute force itself.
重力儀的設計是為了測量一處到另一處的重力變化，而不是絕對重力值本身。 -
The paper analyzes and summarizes the following laws of distinctive sediment yield produced in storm floods of the region based on predecessors ' study : storm is the main dynamic force of erosive sediment yield and storm, flood and sediment exist an inevitable relation ; the flood occurring time is concentrated with high peaks and huge volume, suddenly rising and suddenly falling and has decisive influence to the formation of a major flood peak in the middle yellow river ; the main reasons of concentrated coarse sediment of the river is severe erosive sediment yield, strong sediment transporting capacity and high sediment concentration ; the important influence of frequent or continued storm floods happened in he - long reach especially in coarse sediment concentrated region to the sediment transport of the yellow river and ; along with the increase of harnessing, regional flood trend is becoming smaller but the variation of sediment quantity is not obvious and the reaction of peak discharge and flood runoff of majority tributaries are not sensitive, showing that a general and normal engineering works can not effectively control regional major floods especially the sediment of an extraordinary flood
摘要在前人研究的基礎上分析總結了該區特有的暴雨洪水產沙規律：暴雨是侵蝕產沙的主要動力，暴雨、洪水、泥沙之間存在著必然的關系；洪水發生時間集中，峰高量大，暴漲暴落，對黃河中游大洪峰的形成具有決定性影響；侵蝕產沙強烈而粗泥沙集中，輸沙能力強，洪水含沙量高，是黃河粗泥沙的集中來源地；河龍區間特別是粗泥沙集中來源區頻繁或連續的暴雨洪水對黃河輸沙有重要影響；隨著治理水平的提高，區域洪水有減小趨勢，但泥沙量變化不明顯，大部分支流的洪峰流量、洪水含水量反應不敏感，說明一般規模和水平的治理工程還不能有效控制區域大洪水特別是特大洪水的泥沙。 -
The general formulas for interaction energy and the force acting on the dislocation due to the presence of an elliptical inhomogeneity under longitudinal shear are given. the force acting on the dislocation is figured out, particular discussion being given to its variation with the dislocation azimuth and other parameters. it is shown that the force acting on the dislocation first reduces and then increases with the augment of dislocation azimuth
首次導出了縱向剪切下夾雜內外螺旋位錯引起的耦合干涉能與耦合位錯力的一般解析表達式，並討論了位錯力隨位錯方位角及相關參數的變化規律，發現縱向剪切下位錯力幅值隨位錯方位角的增大先減小后增大。 -
Then, the effects of the inner force and displacements of the exterior - protected structures influenced by the value of m and the different depths of inner poling are analysed with the m - method back - analysis programme. and the variation of optimized values caused by the numbers of different inversion parameters is also analysed, and a conclusion is drawn that a propriate parameter numbers should be in use of back analysis
然後，利用編制的m法反演分析程序，分析了m值對圍護結構內力和位移的影響，計算了內支撐不同設置深度對圍護結構內力和位移的影響，分析了反演參數個數對反演優化值的影響，即對解的適定性問題進行了討論。 -
Based on the theory that the optical properties of zncdse / znse qd structure at different formation and ripening stage are different from each other, by investigating the variation in emission peak energy and integrated intensity, the formation and ripening information of the dots was obtained, which overcomes the disadvantage of atomic force microscopy ( afm ) in that it can not be applied to the measurement of the initial formation stage of the qd. furthermore, it is of great help to clarify the controversies in the ripening process of se - compound qd
利用量子點在不同形成和熟化階段具有不同的光學性質這一思想，通過測量zncdse znse量子結構的發光峰的位置與相對強度的變化，獲得了量子點的形成和熟化信息，從而既解決了一般金屬有機物化學氣相沉積（ mocvd ）設備由於沒有原位監測儀器而無法對量子點的形成過程進行監測的不足，又澄清了原子力顯微鏡表徵的量子點熟化過程的爭議。 -
6. it also studied general variation regularities of wave force, added mass and added damping, tlp ' s kinetic respondence based on engineering examples and got some valuable conclusions ( see text )
6 .基於工程實例，分別研究了tlp波浪力、附加質量與附加阻尼、 tlp的動力響應的一般規律，得到了一些富有工程意義的結論（詳見正文） 。 -
Rfv redial force variation
徑向力震動 -
On the basis of association of finite element computation with optimization design and analysis of sensitivity of cable force variation to structural response and objective function ' s sensitivity, an optimization method for rationally bridge - completing cable force of large - span cable - stayed bridge was presented, where the structural internal force, linear control condition, and nonlinearity influence of structural geometry were taken into account in the entire process of optimization
摘要將有限元計算與優化設計分析相結合，在索力變化對結構響應和目標函數敏感性分析的基礎上，綜合考慮結構內力、線形控制條件，提出一種全過程計入結構幾何非線性影響的大跨斜拉橋合理成橋索力優化方法，採用一階分析法對成橋索力進行迭代優化。 -
Lfv lateral force variation
側力震動
分享友人