formation flow capacity 中文意思是什麼
formation flow capacity
解釋
地層系數-
In this paper, the sensibility analysis of the factors affecting the temperature in well bore is relatively systematically made by using a large number of the data calculated with the borehole flow and heat transfer 3 ? d numerical model proposed by the author. the study shows that the thermophysical parameters of the drilling fluid and formation, etc. and the entrance temperature and circulating capacity, etc. of drilling fluid have a greater influence on the temperature in well bore. therefore, accurately mastering the thermophysical parameter values of penetrated formation and drilling fluid in well bore, considering the influence of the temperature and pressure on thermophysical parameters and accurately measuring such parameters as entrance temperature and discharge capacity of drilling fluid, etc. are of utmost importance for accurately simulating the temperature in well bore
利用由作者提出的井內流動和傳熱的三維數值模型計算所得的大量數據，文章對影響井內溫度的諸多因素進行了較系統的敏感性分析，研究表明：鉆井液和地層等的熱物理參數以及鉆井液的入口溫度、循環排量等對井內溫度有較大影響，因此，準確掌握所鉆地區地層和井內鉆井液的熱物理參數值，考慮溫度壓力對熱物理參數的影響，準確測量鉆井液的入口溫度、排量等參數值，對于井內溫度的準確模擬至關重要。 -
Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo
本文首先對數字減影血管造影（ dsa ）成像系統的組成結構和數據流向進行了深入研究和分析，並對系統中的數據流向進行了完整的歸納和總結，給出了x線數字成像系統中的高速大容量數據通道的設計方案；在對sdram的控制方式做了深入探討后，給出了實現大容量多條sdram共同工作的解決方案，在此基礎上設計了大容量幀存板實現對圖象數據進行高速存儲；通過對pci總線介面的深入研究，優化後端狀態機設計和低層驅動程序開發，給出了完整的pci介面方案實現高速dma數據傳輸，完全可以滿足視頻傳輸要求；深入研究了基於大規模可編程器件的數字系統設計方法，針對通用fifo使能信號漂移、輸出數據難于建立和保持等設計難點，提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案，從而實現利用fifo來協調系統各模塊之間的數據高速傳輸。 -
The result shows that 1 ) formation coefficient is a main factor. 2 ) boundary and formation heterogeneity have much effect. 3 ) water producing gas wells should be produced reasonably according to gas production policy with water controlling technique so as to avoid watered out. 4 ) with increase of non - darcy flow coefficient, gas well productivity decreases. 5 ) in the process of gas well production, formation energy should be used reasonably. 6 ) when skin factor increases from 0 to 6, its open - flow capacity is 60 % - 70 % of that without pollution
研究表明：地層系數是影響氣井產能的主要因素；邊界和地層非均質對氣井產能影響很大；對于產水氣井，應嚴格按照控水采氣技術政策合理開采，避免水淹；隨著非達西流系數的增大，氣井產能不斷降低；在氣井的生產過程中，必須合理利用地層能量；當表皮系數由0增加到6時，其無阻流量為不受污染時的60 % ~ 70 % 。 -
In order to study effects of various factors on gas well productivity, this paper takes changqing gas field as an example and uses gas reservoir engineering and numerical simulation methods to qualify effect of different factors on absolute open - flow capacity in different reservoirs in respect of formation coefficient, water production, non - darcy flow coefficient, formation pressure and skin factor
摘要影響氣井產能的因素多種多樣，為了具體描述各因素對產能的影響，以長慶氣田為例，利用氣藏工程和數值模擬方法，從地層系數、產水、非達西流系數、地層壓力、表皮系數等幾個方面定量分析了各因素對不同儲層條件下氣井絕對無阻流量的影響程度。 -
The author analyses and predicts the growth and developement trends of the passenger flow, holds that more trains put into running with the present train formation shall be the direct solution and a more effective way to enhance the transport capacity in shanghai metro line 1
保持當前的列車編組，通過增加上線運營列車數來縮小行車間隔，應是提高上海地鐵1號線運能的最直接、有效的方法。
分享友人