gas-flow resistance 中文意思是什麼

gas-flow resistance 解釋
氣流阻力
  • gas : n （pl gases ）1 氣，氣體，氣態 〈cf fluid; solid〉 2 可燃氣，煤氣，沼氣；【礦物】瓦斯。3 【軍事...
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  3. The result on research is as fellow : ( 1 ) the way to rebuild gas channels in combustion chamber of pb column has been researched in order to decrease the flow resistance. the aim, which is less resistance than that at present construction, has been gained

    本論文首次通過系統狽賦，藉助伍顫桔葫榨釀斕閣塔的燃腕室翩翱劃稚殲涸浙，對鋅睬蟎辨轉以孰艙澆室內煤氣道、煙氣道的緯淋撾矯孔劃b研究。
  4. In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction

    在研究過程中，採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷，具體結果包括如下： （ 1 ）完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試，結果發現：鉛塔燃燒室內水平方向的煙氣溫度並非均勻，而且其溫差比上下方向的溫差更大，以及鉛塔燃燒室尾部存在co未燃燼問題； （ 2 ）為了保證鉛塔煙氣系統的正常工作，對煙道系統的阻力進行了理論計算及測試分析，結果發現：鋅精餾鉛塔煙氣系統中煙囪抽力不夠，這主要是煙道結構不合理所造成的。
  5. This research is to eject some compressed air into the dredging pipe to get tri - phase flow in the pipeline, and research the change about the pipe resistance, at the same time, obtain the more effect adding gas method and realize reduction friction and prolong the dredging distance

    本文研究的目的是在一定的漿體流速和漿體濃度下向輸送管道中加入一定量的氣體，在管道中形成三相流，進而探討加氣后管道流動的變化規律，同時確定出比較有效的加氣方案，從而實現減少阻力延長排距的目的。
  6. In order to know the relationship between gas - content and pipeline ' s pressure drop, the thesis deduces the pressure drop calculating equations based on uniform flow pattern and separating flow pattern. the equations show that pressure drop is made up of three parts, that is, friction resistance effect, gas acceleration effect and the gravity effect. and the research has shown that the gas has little effect on pressure drop. in the horizontal pipeline, the resistance effect must be overmatched the acceleration effect

    為探討加入的氣體對管道壓力的影響，本文基於分相流和均相流兩種模型分別推導了三相流管道的壓降公式，表明無論是分相流模型，還是均勻流模型，管道內流體總的壓降是由三項組成的，即摩擦項、加速項和重力項，並得出了加氣對管壓變化不大的結論，所以認為在水平管道中，要獲得有效的減阻，則要使摩擦阻力分量的減小效應大於漿體加氣的加速效應。
  7. Standard methods for gas flow resistance testing of filtration media

    過濾介質耐氣體流動試驗的標準方法
分享友人
分享到 Line

分享到臉書