growth formula 中文意思是什麼

growth formula 解釋
生長公式
  • growth : n. 1. 生長，成長，發育，發展。2. 栽培，培養。3. 生長物，產物；【醫學】瘤，贅生物。4. 【經濟學】（資本價值與收益的）預期增長。
  • formula : n （pl formulas lae ）1 公式，程式；定則，方案。2 【醫學】配方，處方。3 （政治口號等的）提法，表...
  1. Then the structure unit of hexangular lattice is found according to the principle of invariable symmetry. renormalization transformation is processed when we regard the structure unit and the growth model as graphs before and after transformation respectively. after choosing the 11 thermodynamic function fugacity as parameter, we can write out the partition functions before and after transformation and the formula of renormalization transformation

    然後根據對稱性不變的原則，從整體晶格中選取結構單元，把結構單元和生長模型分別作為重整化變換前、后的圖形來進行重整化變換，選取熱力學函數易逸度為參量，寫出了重整化變換前後的配分函數和重整化變換關系式，求出了這一變換的不動點。
  2. Guozhen pine pollen growth in the country is a unique selection of masson pine pollen species as raw material health treasures from the scientific formula

    國珍松花粉是選用生長於我國的特有樹種馬尾松之花粉為主要原料，經科學配方而成的保健珍品。
  3. And the spherulite growth rate of phbv is studied and the factors, which influence the growth rate and the formula of spherulite growth rate, were discussed

    並通過對phbv球晶生長速率的測定，對結。晶生長的速度方程及影響因素做出修正。
  4. The formula specially designed for men works to release toxic heat, prevent blackhead growth, thin pore, and clean skin

    特別為男士設計的專用配方，能清除熱毒，防止黑頭生成，幼細毛孔，使肌膚光潔潤澤，充滿魅力。
  5. Furthermore, the supposition of galvanic couple is drawn into the procedure of corrosion fatigue crack growth of aluminum alloys, the relation of couple current vs loading time is determined with electrochemical methods. a formula in the theory is deduced which expresses the stress corrosion crack growth rate of lc4cs aluminum alloy, the results of mathematical modeling preferably correspond with examination

    再將「耦合作用」的猜想，引入鋁合金的腐蝕疲勞裂紋擴展過程中，用電化學的方法測定耦合電流與加載時間的關系，並從理論上導出lc4cs鋁合金應力腐蝕裂紋擴展速率的數學表達式，數學模擬的結果與實驗值具有較好的一致性。
  6. And as luck would have it, kwong has a run - in with a strange old man in the park, and accidentally ingests a magical growth formula that causes him to begin aging very rapidly

    成長后的光仔劉德華飾既驚又喜，終于踏上了夢寐以求的旅程。他外表雖是成年人，內里卻仍是小孩心，因此鬧出不少笑話。
  7. The crack - growth increment of crack - line is computed by paris formula followed by fitting using three - time b - spline function

    根據以上思想方法，編寫了具有較高的計算效率和精度的數值模擬程序。
  8. A mathematical model for the particles layering growth is developed based on the mechanism of layering growth and law of conservation of mass. a formula for calculating the particle diameter was also deduced

    依據顆粒層式成長機理，根據物質守恆原理建立了顆粒層式生長的數學模型，提出了粒徑長大的計算式。
  9. And the influence of water condition to growth and yield of crops were discussed briefly. then based on the meteorological data, yield data, drought and flood data of jiangsu province from 1961 to 2000, the water profit and loss of every ten days in the growing period of crops was calculated on the foundation of the water balance formula in every agriculture climate district. the disaster index of drought and flood was confirmed and calculated

    根據江蘇省近40餘年的氣象資料、產量資料和旱澇災害資料，分農業氣候區利用農田水分平衡方程計算了不同作物逐旬水分盈虧量，確定了旱澇災害指數，並用多元積分回歸方法分析了降水對棉花和小麥產量的定量影響，得出作物生長期內逐旬水分敏感指數。
  10. The opening stress and the life of crack growth is calculated and compared with the test results and the experience formula. the feasibility of the newman theory of opening stress used in the high strength steel is validated. then through the slice synthesis method, the three dimension surface crack of the weld joint of cone - cylinder is decomposed into many plane through cracks

    本文將基於裂紋閉合現象建立的帶狀屈服模型，用在平面貫穿裂紋中，計算此時的裂紋張開應力和疲勞裂紋擴展壽命，與試驗結果和經驗公式比較，驗證newman裂紋張開應力理論在高強鋼中的可行性；然後，用切片合成法，把潛艇結構凸錐柱結合殼焊縫處的三維表面裂紋分解成平面貫穿裂紋，用帶狀屈服模型的理論來分析平面貫穿裂紋，得到裂紋沿深度方向的擴展速率，進而得到潛艇結構的疲勞壽命。
  11. We conduct fatigue crack growth experiment with four kinds of materials through the method, and get complete date of four kinds of materials " fatigue crack growth at first time. and also gain the laws of these four kinds of materials " at between 25 and 550 separately, that is the coefficient and exponent of paris ' s formula. meanwhile finding out the laws of fatigue crack growth of these four kinds of materials with the temperature changing

    採用上述試驗方法對四種材料高溫疲勞裂紋擴展行為進行試驗研究，首次獲得了16mnr 、 21 / 4cr1mo 、 21 / 4cr1mov和316l四種材料較為完整的高溫疲勞裂紋擴展數據，並得到四種材料在25 550溫度條件下的疲勞裂紋擴展規律表達式（即所對應的paris公式的系數和指數） ，找到了這些材料隨溫度變化的疲勞裂紋擴展規律。
  12. Under the proposed formula, the rate of adjustments would be based on two factors viz. the operator s growth in productivity as well as change in input price

    根據建議模式，調整率將會以兩個因素作為基礎，即營辦商生產力的提升及成本價格的變動。
  13. The effect of hydrodynamics on the algal growth rate is mainly studied herein based on the analysis of the algal growth mechanism and the measurement data of the daninghe river which is a branch of three - gorges reservoir, and then an empirical formula of the algal growth rate related with water velocity is proposed for the daninghe river ; which can be used to predict the change status of the eutrophication of the branch when the water velocity is decreased with the increase of water level of the three gorges reservoir

    基於國內外對氣候條件和營養鹽條件對藻類生長速率影響研究成果基礎上，採用機理分析和實際案例分析相結合的方法，重點探討了以流速為表徵要素的水動力條件對藻類生長速率的影響特點，並且以三峽庫區支流大寧河為例，初步建立了流速對藻類生長速率影響規律的經驗關系式，為預測三峽庫區富營養化演變態勢提供基礎，進而為有效防治富營養化提供技術支撐。
  14. In chapter three, the mechanism responsible for scanning probe field - induced oxidation in ambient air is attributed to an electrochemical process, i. e., anodic oxidation or anodization, after the analyses is given of a surface of a sample exposed to air. the effects of biases, tip speeds on morphology of field - induced oxidation, are introduced and deduced in the form of kinetics formula of oxidation growth

    第三章首先通過分析大氣環境下掃描探針場致氧化加工的基本特性，得出掃描探針場致氧化的加工機理為電化學陽極氧化反應；引進大氣狀態下場致氧化的動力學方程，推導出偏置電壓與場致氧化物的幾何形態兩者之間的關系、掃描探針移動速度與場致氧化物的幾何形態兩者之間的關系。
  15. The skeleton design of the growth of thin films ybilg and ybig, the analysis of the phase graph, the establishment of the formula and the establishment of equipment for lpe were accomplished

    通過自組搭建的cgx - 1型磁光法拉第旋轉測試系統，對樣品在可見光波段磁光性能進行了測試分析。
分享友人
分享到 Line

分享到臉書