guide-vanes 中文意思是什麼
-
By using harika algorithm, the characteristic of a high - pressure compressor is calculated at different installation angle of the inlet guide vane and the stator vanes ; the characteristics of a high - pressure turbine and a low - pressure turbine are simulated at different installation angles of the guide vane based on ainley method
本文用harika演算法計算了導流葉片和靜子葉片安裝角度可調的變幾何高壓壓氣機特性；用ainley法計算了渦輪導向器面積可調的高壓渦輪和低壓渦輪的特性。 -
The dynamo runs at rull speed to drive main shaft, then the main shaft makes the emulsifying wings in emulsification grove rotate, which absorbs the liquid in its brand groove into ring groove through guide vanes on upper and lower sides of the groove. the vanes spins circularly at high speed with the main shatf as center, and the blade and emulsificaton groove cut and crush it continuously. after that. it gers squeezed by the vanes highspeed centrifugal rotation. at last, it finishes isotropt emulsification tratment within extremely short time after continuous circulating mixing
由電動機全速運轉帶動主軸，經主軸轉動乳化框槽內之乳化翼片，使其將桶槽內之液體經框槽上、下兩側之導流葉片吸入環狀框槽內，經以主軸為中心高速圓周旋轉葉片；連續使乳化翼端刀面與乳化框間極小之間系高頻率之強力切割剪斷、粉碎，再借葉片高速離心旋轉排擠，持續循環混合，以極短之時間即可完成均質乳化之處理。 -
The efficiency, the runner and axis mode, the water leakage of guide vanes are also tested and used in the paper
並對5 #機組進行了補氣效果試驗和變速試驗，另外還有效率測試 -
Variable inlet guide vanes
可調的進氣導片 -
To meet the needs for wider surge margin of the turbofan engine, a new model was developed to predict the characteristics of the fan / high pressure compressor and turbine in this thesis. several ways, including, variable inlet guide vanes of the fan, variable guide vanes of the high pressure compressor, the variable inlet area ratio of the mixer and the nozzle areas, were presented to enlarge the surge margin of the turbofan engine. meanwhile, a method of combined variable geometries for optimizing controls of inlet guide vanes of the fan, guide vanes and the first two stators of high pressure compressor, area ratio of mixer and noz zle areas was established
為了滿足下一代作戰飛機對推進系統的性能和穩定性要求，本文建立了壓縮系統特性和渦輪特性的新模型，並分別採用改變渦扇發動機風扇進口導流葉片、壓氣機導流葉片和前兩級靜葉片、混合室進口處內、外涵面積比和尾噴管面積，研究了其對發動機性能和穩定性的影響，進而得出了渦扇發動機變幾何擴穩的方法，為發動機變幾何擴穩研究打下理論基礎。 -
The effects of layout of tip gap clearance on axial compressor rotor performance and stability have been investigated experimentally. a single - stage compressor rotor with no inlet guide vanes was tested under subsonic condition
本文用實驗的方法對壓氣機轉子尖部間隙沿軸向周向的布局進行了詳細的研究。 -
Consider a row of guide vanes in a compressible internal flow as shown below
如下圖所示，考慮可壓縮內部流中的一排導流葉片。 -
Some of the air is used for cooling the turbine blades and nozzle guide vanes, and part of it is employed to cool and seal the turbine discs
在現代航空發動機中，從壓氣機引出的壓縮空氣一部分用來冷卻渦輪葉片和渦輪導向葉片，另外一部分用來冷卻和密封渦輪盤。
分享友人