heat loading 中文意思是什麼
heat loading
解釋
熱負荷-
Paper faced gypsum board is mainly made of construction plaster calcined with natural gypsum or chemical by - product and protective paper, mixing with fiber, modified starch, coagulant agent, vesicant and water. which are mixed, formed, coagulated, cut, dryed and sliced into light construction material. they have advantages of light weight, fire resistance, soundproof, damp proof, heat insulation, easy to operate sawn, nailed or milled an disassemble. it s widely applied in industrial and civil constructions, especially widely used as interior wall, less loading wall, ceiling etc in high buildings
紙面石膏是以建築石膏利用天然石膏或化學副產品石膏煅燒制得和護面紙為主要原料，摻加適量纖維改性澱粉促凝劑發泡劑和水，經混合成型凝固切斷烘乾切邊等工序製成的輕質建築板材。 -
The he - ne laser with the wavelength of 632. 8nm, when was interacting on the pd wire, which loading ratio is 0. 6, we gain the apparent " excess heat " by the excitation
而且，在he - ne激光器發出的波長為632 . 8nm激光的照射作用下，在充氫率為0 . 6時，曾一度觀測出明顯的「過熱」現象。 -
The protector of electromotor have used heat relay for a long time, but heat relay not only has a dead area in the light over - loading area, but also ca n ' t protect open phase under so much circumstances
電動機保護裝置採用熱繼電器已有很長的歷史，但熱繼電器在電機的輕過載區存在著「保護死區」 ，而且對斷相保護在許多情況下起不到保護作用。 -
The resulting system has an even heat loading.
這樣的系統有均勻的熱負荷。 -
Unloading of the parts from the tare for the heat treatment to the containers, mounted at the loading / unloading conveyer at the quantity of 5 - 6 pc. is carried out manually as well
在爐子里熱理過的零件要卸到集裝箱里，最好每次手工搬運5 ~ 6件，然後固定在裝卸傳送裝置上。 -
Handle all the ocean - air and truck united service of all the fcl or lcl in canton, hk or all over the world, we also offer other services such as supply container truck or lcl truck, stocking, loading or unloading the container, applying to customs, fumigation certificate ( heat - treatment ) and insurance etc
卸接廣東及香港地區到世界各地的集裝箱、散貨拼箱的海陸空聯運服務，配套提供集裝箱拖車、散貨噸車、倉儲、裝卸、拆櫃、報關、熏蒸、保險等服務。 -
The coupled effect is analyzed for an elliptical inhomogeneity under plane uniform loads and linear temperature change at infinity. the complex potentials are obtained for an elliptical inhomogeneity under plane uniform mechanical loading, uniform temperature change and uniform heat flow directed at any angle. the discussion is also given to the variation of the interfacial stresses with thermal parameters
分析了無窮遠平面加載和線性溫變的耦合效應，獲得了橢圓夾雜體在無窮遠平面均勻加載和均勻升溫以及任意方向的均勻熱流共同作用下的復勢解答，並討論了界面應力隨各熱載參數的變化規律，發現基體導熱性能越好（與夾雜相比） ，界面應力幅值越大。 -
In this dissertation, the effect of texture, heat - treatment, and hydrogen on the lcf behavior of zircaloy - 4 and the cyclic deformation behavior for zircaloy - 4, n18 alloy and n36 alloy have been investigated systematically using fully - reversed tension - compression loading under strain control ( r = min / max = - 1 ), while the evolvement of the friction and back stresses versus the number of repeated working cycles and the plastic strain amplitude has been studied, and the thorough discussion combined with the analysis result of fatigue sub - structure, friction and back stresses, and fatigue fracture has been given to the mechanism underlying the lcf behavior of alloys
本文採用對稱拉壓循環變形方法（ r _ = _ （ min ） _ （ max ） = - 1 ） ，系統研究了織構、熱處理狀態、氫對zr - 4合金低周疲勞性能的影響， zr - 4合金、 n18合金和n36合金的循環變形行為，並研究了摩擦應力、背應力隨循環周次、塑性應變幅的變化規律。結合疲勞亞結構和疲勞斷口的分析結果，深入探討了影響合金低周疲勞行為的作用機制。 -
But routine electronic protector ca n ' t realize the protection for counter time limit, which is matching with the graph of heat over - loading protect. it can only realize " single point protection " and ca n ' t protect the failure happened during start - up
但是常規電子式保護器無法實現與電機熱過載保護特性曲線相匹配的反時限特性保護，只能實現「單點式」保護，無法保護啟動過程中出現的故障。 -
When the loading is constant, the abrasion heat rises as the rotating speed rises
法正常工作如負載不變時，摩擦熱隨著輪轉速的增高而增大，極限情況下甚至 -
The change of residual contact pressure of bimetal composite pipe under the action of heat load in this article, the possibility of separation between two metal layers in temperature cycle was researched ; it has been shown that under heat loading condition, it has a limit working temperature
摘要分析了在熱載荷作用下雙金屬復合鋼管結合強度的變化，研究了經歷溫度循環后內外層管之間出現松脫的可能性。 -
In this paper tio2 / minerals have been prepared using natural minerals as carrier and the industrial metatitanic acid and the industrial sulfate titanium liquid as the raw material based on the effects such as loading capacity of tio2, specific surface area of minerals, different mineral source and preparation cost. the acid treatment and heat treatment of minerals, preparation methods and condition of ticvminerals have been studied, the photocatalytic experiments on samples were tested from degrading methylene blue solution, and some important results as follows : 1
本研究以天然礦物對tio _ 2的負載能力、比表面積、礦物來源、材料成本等因素為依據，通過對天然礦石載體的活化工藝研究和工業偏鈦酸、工業硫酸鈦液（以下簡稱濃鈦液）為原料制取tio _ 2天然礦物復合材料的制備工藝研究，以及樣品光催化降解有機物的研究，最終制得了具有光催化活性的tio _ 2天然礦物復合材料。 -
2. in order to meet the real - time simulation and guarantee specified ratio of precision, this paper had simplified and supposed some thermal process in module and use the lumped parameter way to model. for some special components, such as furnace cavity or water screen, had been reached good ratio of precision of simulation by divided into three parts ( upper area, intermediate area and lower area ) to model separately because of the huge difference of heat loading in vertical direction
2 、為滿足實時模擬的要求而同時要保證有一定模擬精度，本文對模型做出了一定的假設和簡化，並且主要採用集總參數法進行建模，對於一些特殊部件，比如爐膛和水冷壁，由於其豎直方向熱負荷差異較大，本文將其分為上、中、下三個區域，分別採用集總參數建模，達到比較好的模擬精度。 -
The effects of nabr loading, reaction temperature and contact time on the catalytic behaviors of nabr - promoted kzsm - 5 zeolite for the oxidative methylation of toluene were investigated systematically. it was found that the kzsm - 5 zeolite catalyst promoted with proper nabr loading was a very effective catalyst for the omt. the optimum conditions for the omt were found. the structure of catalysts have been characterized by xrd and framework ir. it was found that kzsm - 5 zeolite exhibited excellent catalytic activity for the omt and heat stability
化合物的選擇性及st eb值等方面的影響進行了系統的考察，發現nabr kzsm - 5催化劑對omt反應活性較高，適當的nabr負載量能提高omt反應活性，並能獲得苯乙烯含量很高的c -
We taking the factor of generating heat - the multiple value pv of the loading of unit area p and the surface linear velocity v to determine the using limit
一般情況下，我們用產生發熱的因素單位面積的負載p和表面線速度v的乘積pv值來決定使用的極限。 -
The construction of the project mainly includes : storage tanks for crude oil 、 intermediate oil and product oil, processing equipment, torch assembly, railway for product oil, highway for loading and transport, sewage disposal plant, heat supply, wind supply, power transformation and distribution, heating and ventilating, communication and other public and storage - transport works, control center and off - set facility for analysis and assay 、 maintenance and repair 、 office work
該項目的范圍主要包括原油、中間油及成品油罐儲區、工藝裝置、火炬、成品油鐵路、公路裝運、污水處理、供熱、供風、變配電、發電、暖通、通信等公用工程及儲運工程，控制中心，分析化驗、維修、辦公等輔助設施。 -
This thesis consists of eight chapters as the following. in chapter 1, the current research situation and development of the heat transfer and the thermal loading is retrospective firstly. then the current situation and development of the numerical simulation research of the internal combustion engine heated additionally component have been concluded
本論文共分為八章，具體包括以下內容：第1章首先回顧了內燃機工程中傳熱與熱負荷研究的發展和現狀，進而對內燃機受熱零部件熱負荷的數值模擬研究的發展和現狀進行了歸納和展望。 -
Tray - type cable support systems are ideal cable laying devices most broadly applied in petrolum industry, chemical industry, power and light industries. television and telecommunication, it is featured by such advantages as small weight, great loading capacity. good - looking shape, simple structure. convenient erection. quick heat dissipation and fine permeability
托盤式橋架是石油、化工、電力、電視電訊等方面最廣泛應用的敷設裝置，它具有重量輕，載荷大、造型美觀、結構簡單、安裝方便、散熱透氣性好等優點，既適用於動力電纜的安裝，也適用於控制電纜的敷設。 -
Special elasticity effect of the ub grinding wheel offers a long time continuous grinding operation, reducing generation of grinding heat with less loading
Ub磨輪特殊的彈性特點，可長時間持續地進行研磨作業，但不會產生太多的研磨熱及堵塞現象。
分享友人