hydrophilic film 中文意思是什麼

hydrophilic film 解釋
親水膜
  • hydrophilic : adj. 【化學】親水的。
  • film : n 1 薄層，薄膜；薄霧，輕煙；細絲狀的東西。2 【攝影】感光乳劑，照相軟片，電影膠片；影片。3 〈 pl ...
  1. The hydrophilicity of the modified nano - tio2 film was also studied. the ruslt shows that the hydrophilic angle has a little increase, but its super hydrophilicity is not alterant, and also shows the hydrophilic angle increasing on open entironment is slowing

    結果表明，改性后催化劑的接觸角有所增加，但催化劑的超親水性沒有發生改變，同時催化劑經等離子體處理后在開放的環境中樣品的接觸角的變化緩慢一些。
  2. In this paper, pan based metal gradient composites films ( pmgcf ) were prepared by electrochemical reduction. the effect of polymer matrix on pmgcf and preparation and its forming mechanism of pmgcf were invested, they are as follows : lacrylonitrile - methyl - methacrylate copolymer, acryonitrile - itaconic acid copolymer, acrylonitrile - methyl methacry late - sodium allyl sulfonate terpolymer have been synthesized seperately in order to analyze the effects of the mma monomer unites and the hydrophilic unites of acryonitrile terpolymer on the process of copper deposition in polyacrylonitrile - based metal gradient composite film ( pmgcf ) as well as the flexibility of the film

    其內容如下： 1通過合成的丙烯腈?甲基丙烯酸甲酯二元共聚物（ p （ an - mma ） ） ，丙烯腈?亞甲基丁二酸二元共聚物（ p （ an - ita ） ） ，丙烯腈-甲基丙烯酸甲酯?丙烯磺酸鈉三元共聚物（ p （ an - mma - as ） ）分別作為基體制備了聚合物基金屬梯度復合膜材料（ pmgcf ） ，以分析加入的mma基團和親水性基團對pmgcf沉積層中金屬銅的梯度分佈形態和膜的柔韌性的影響。
  3. The ability of counterion so42 - to improve fc16ab monolayer ' s compressibility is poorer than cl -. with the technology of lb film, the monomolecular film of fc16ab was deposited on to quartz and caf2 with hydrophilic surfaces on ultrapure water subphase, y - type lb film of transfer ratio approaching to 1 is obtained. the lb film is demonstrated with uv - vis, ft - ir spectra

    利用lb膜技術將不同亞相上的fc _ （ 16 ） ab單分子膜沉積到具有親水表面的石英基片和caf _ 2基片上，得到轉移比接近1的y -型lb膜，並用uv - vis 、 ft - ir光譜lb膜進行了表徵。
  4. Automatically catch hydrophobic n. w. fabric, guide - flow n. w. fabric, hydrophilic n. w. fabric, pe film ; without stopping, auto exchange material, control tension rectification and get rid of wasted products

    拒水無紡布、導流無紡布、親水無紡布、 pe流延膜自動換接料、自控張力，自動糾偏。換接料次、廢品自動剔除。生產故障自動停機。
  5. Xps showed that there were much chemical absorbing water on the ti _ ( 2 ) film surface which mainly existed in form of - oh, and the contents of - oh was increasing with the annealing temperature. hydrophilic property became better with the annealing temperature ; the essential relation between the changing of contact angle and light - induced - electrons and light - induced - cavities was studied in details. the photocatalysis of samples without heat treatment was very bad, but that of samples after heat treatment was much better

    Xps的分析表明：試樣的表面含有大量的化學吸附水，主要以羥基的形式存在，隨著熱處理溫度的升高，吸附羥基的含量在增加；親水性能測試表明：隨著氧氣分壓的變化，其親水性能變化不大，隨著熱處理溫度的增加，試樣的親水性能在變好，並從理論上解釋了親水性能光照前後變化和光生電子?空穴對之間的本質關系。
  6. Preparation of hydrophilic anticorrosion film on aluminum alloy by sol - gel process

    凝膠法制備鋁合金耐蝕親水性塗膜
  7. As far as the metal bo are concemed in this thesis, na +, k + in the thet main any, mgl in the second main any and miz + of the transient elements in the fourth period are of tather good therovement to the ffe - fodrig propeny of mse. ( 3whth the teehnology of lb, the monolayer of hise was deposited on to caf2 with hydrophilic sums on ultiapure water subphase, thus y - type lb fllm of transfer raho approaching to l is obtained. the lb film is demonstrated with ft - ir spectrum

    （ 3 ）利用lb技術將二次水亞相上的hise單分子膜沉積到具有親水表面的caf _ 2基片上，得到轉移比接近1的y ?型lb膜，並用ft - ir光譜對lb膜進行了表徵，發現hise的紅外吸收峰在製成lb膜前後沒有發生位移，隨著lb膜膜厚的增加，吸收峰呈現增強的趨勢，表明lb膜可有效、均勻地沉積。
  8. Silylate - terminated polyurethanes with built - in hydrophilic sites were synthesized. when the polymer is dispersed in water, the silane alkoxy end - groups of the polymer undergo hydrolysis, followed by condensation to form a stable cross - linked aqueous dispersion. tem studies indicated that with more incorporation of hydrophilic sites, the particle size of the dispersion decreased. it was also found that the film property depended on the particle size when the crosslinking density in particels was much higher. the average molecular weight of the elastically effective network chain mc measured by swelling experiments shows fairly good agreement with the theoretical value of mc. it was also found that the cross - linking density of the casting film may increase during the film formation and drying process

    將硅氧烷封端的含親水基團的線性聚氨酯預聚體分散於水中，獲得穩定的聚氨酯分散體.由於硅氧基團水解、縮合，在分散體粒子內產生擴鏈交聯反應，生成了交聯水基聚氨酯分散體.透射電子顯微鏡研究表明分散體粒徑小、分佈寬.掃描電子顯微鏡研究了成膜結構及成膜性能與粒徑的關系.溶脹實驗計算獲得的兩交聯點之間的平均分子量與理論平均分子量相符.研究還發現此分散體膜在乾燥過程中可進一步交聯.膜的水溶脹及機械性能表明，此分散體具有極大的工業應用價值
分享友人
分享到 Line

分享到臉書