ignition condition 中文意思是什麼

ignition condition 解釋
點火條件
  • ignition : n. 1. 點火,著火,燃燒;【化學】灼熱。2. 【機械工程】發火裝置。
  • condition : n 1 狀態,狀況,情形;品質。2 〈pl 〉外界狀況,周圍情形。3 地位,身分。4 條件;【語法】條件子句。...
  1. It is discovered that the combustion condition of the second stage pc is up to the outlet temperature of the first stage pc and the content of combustible gases in first stage flue also plays positive effect on the ignition of second stage pc. the effects of parameters of two coal - air mixture, wall temperature of first ignition chamber and annular filling air on imfit are studied experimentally in this thesis. in this thesis, the numerical simulations of ignition and combustion of pc in imfit are conducted

    本文通過建立數學模型,對感應加熱煤粉多級無油點火進行數值模擬,研究了一級煤粉煤粉在點火室內的著火過程和二級點燃過程、煤粉粒徑分佈對煤粉多級無油點火的影響,研究了一級點火室壁面溫度、一級煤粉氣流和二級煤粉氣流的風粉參數在煤粉多級無油點火過程中的影響規律;根據二級點燃段的流場和溫度場分佈,研究了環形夾心風推遲二級煤粉著火的機理。
  2. Practice of application on two boilers in rizhao power plant shows that the adjustment of detection distance not only can solve the problem of somewhat low indicating value for very few flame detectors, but also can save large amount of fuel oil used for stabilizing combustion, having remarkable economic benefit under condition of stable ignition and combustion for pulverized coal and air flow

    日照電廠2臺鍋爐的應用實踐表明,在煤粉氣流穩定著火燃燒的情況下,調整火檢的檢測距離不僅可解決個別火檢指示值偏低的問題,而且可節省大量的穩燃油,經濟效益顯著。
  3. Sources of ignition should be kept clear. do not overload at tight sealed condition

    染火點必須隔離。不要再密封的環境中超載。
  4. By improving surface condition of parts and one shot seal - off clean room grade, using ultrasonic vapor phase cleaning process, the inner parts of vacuum interrupter get cleaner. movable particles have been diminished by automatic current ageing, power frequency hi - voltage ageing and dynamic high current ageing. as the dielectric strength of clearance in vacuum interrupter improved, the probability of re - ignition in test drops evidently

    通過提高零件表面加工質量,改善一次封排間的真空衛生條件、制定合理的超聲波氣相清洗工藝提高管內潔凈度,採用自動電流老煉、超高壓工頻老煉、大電流動態老煉等工藝進一步消除真空滅弧室內活動性微粒,可提高真空滅弧室真空間隙介質強度,使真空開關投切電容器組的重燃率大大降低,並通過實驗驗證真空開關投切電容器組的重燃率在製造工藝改進後由原來的10 . 7 %降低至1 . 3 % 。
  5. This paper discussed the thermal equilibrium and critical condition in exothermic reaction system, and deduced the values of dynamic parameters such as the judging criterion for thermal runaway, the ignition temperature and extinction temperature in the critical state of thermal runaway when there is no consumption of reaction materials

    摘要討論化學放熱系統的熱穩定性和臨界條件,用化學反應物無消耗的假設推導化學放熱系統熱失控(熱爆炸)時的動力學參數臨界值,得到熱失控的判據、臨界點火溫度和熄火溫度。
  6. Because it is very expensive to import motorcycle magneto on - line test system, and china ' s equipment quality and technology level ca n ' t meet the request of modern production quality control and administration, it is practically important to develop an advanced on - line test equipment of motorcycle magneto ignition system on modern measure and control technology with a low cost and a suitable national condition

    摩托車磁電機在線檢測設備進口價格昂貴,而目前國內設備質量和技術水平又不能充分滿足日益增長的產品質量控制和管理要求,因此應用現代測控技術研究開發功能先進而成本較低、適合我國國情的摩托車磁電機點火系統在線檢測設備具有重要的現實意義。
  7. The performance of lpg fueled engine at different condition was studied. the relation between engine performance and air fuel ratio, ignition timing or injection timing is found through the experiment

    對比研究了不同條件下的lpg發動機性能及空燃比、點火提前角和噴射時刻等因素對發動機性能的影響。
  8. Testing research specifies that mpt can reliably start up for ar, he, n2, h2, and air under the vacuum condition, and that ignition is easiest with ar, than with n2, and most difficult with he

    實驗研究表明,在真空環境下,對于推進劑工質ar 、 he 、 n _ 2 、 h _ 2和空氣啟動可靠。 ar最容易啟動, n _ 2次之, he最難;微波功率越大,越容易啟動;並且在一定真空度范圍內最容易啟動。
分享友人