increasing velocity 中文意思是什麼
-
With the aqueous phase velocity increasing, the mass transfer flux increased, but the recovery extraction decreased
由回收率的大小可以看出，電泳萃取分離技術是一種很好的處理染料水的方法。 -
In astronomical coordinates ( reference mark is north latitude 43. 9 ), analyzed is the effect of azimuth angular velocity, acceleration and altitude angular velocity, acceleration etc. some formulae were given to compute all correlative quantities. with regard to the course of data processing beforehand, the thesis focuses on outliers eliminating technology because of outlier increasing acutely of high - elevation tracking ( approaches 10 - 20 % )
在觀測坐標系中推導出確定天頂盲區理論范圍公式和滿足過天項跟蹤條件的關系式；在天文坐標系中以長春衛星觀測站（北緯43 . 9 ）作為計算基準，分別討論了方位、俯仰方向的角速度、角加速度等對天頂盲區的影響，在理論分析上為解決過天頂跟蹤問題打下了基礎。 -
The following results were found, i. e., the water ratio affects obviously the acoustic wave velocity of rock sample ; the wave velocity is higher in saturated rock samples than in unsaturated ones ; and it decreases gradually with the strain of samples during uniaxial compression ; and also with the lengthening holding time at 160 ; when heating the samples the acoustic wave velocity increases slightly in initial stage and comes to the peak value at 60, then decreases gradually with increasing temperature ; meantime, there is a certain temperature effect on rock samples size
實驗發現含水率對波速影響比較大，飽和巖樣的聲波傳播速度高於不飽和巖樣的聲波傳播速度；人工預制裂紋對聲波傳播速度影響不大；單軸壓縮條件下，聲波傳播速度隨應變增加逐漸降低；在同一溫度（ 160 ）下，波速隨保溫時間的增加而逐漸降低；在對巖樣逐漸加熱情況下，初始加熱階段波速略有升高，當溫度達到60時，巖樣波速達到峰值，之後隨著溫度繼續升高其波速逐漸下降；波速隨溫度變化具有一定的尺寸效應。 -
The experimental results showed that incipient boiling point decreased with increasing fluid subcooling and was independent of other factors, and that temperature overshoot enhanced with decreasing jet velocity and fluid subcooling
結果表明：沸騰起始過熱度隨液體過冷度增加而減小，與其他因素無關，而溫度過頭值則隨射流速度和液體過冷度減小而增加。 -
The forecast method of formation compression the principle of forecast method is based on increasing of formation compression along with burial depth. the used parameters include velocity, density, porosity, and fluid content etc. in fact, the factor influence formation compression is very complex
4地層壓力預測方法地層壓力預測方法的基本原理建立在地層壓力隨埋深增加而增加的基礎上，所用的參數主要有巖層速度、密度、孔隙度、流體含量或與之有關的參數等。 -
A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle
試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。 -
If increasing drawing interval, the movement and flow range of top coal will enlarge, and the velocity gradient on flow cross - section will diminish, so that it is good for controlling the flow rate of thin sand among loose top coal
研究表明，加大放煤步距，頂煤運移流動的范圍變大，流動斷面內速度梯度變小，有利於控制細砂的下竄速度。 -
The reasons causing gun propellant charge temperature coefficient and the methods of reducing charge temperature coefficient and increasing gun projectile muzzle velocity have been studied
研究了火炮裝藥溫度系數形成的原因以及降低火炮溫度系數提高彈丸初速的基本原理和措施。 -
Increasing the cooling velocity and additions of nb and zr can refine the a - fe dendrites in as - cast alloys, decrease the amount of a - fe phase after homogenization treatment. as a result, the magnetic. properties were improved
提高鑄錠的凝固速度及添加nb和zr可以促進鑄態合金內- fe相的晶粒細化及均勻分佈，減少均勻后殘留的- fe相，提高均勻化的效率和質量，從而提高磁體的矯頑力。 -
3. the fixing quantity of ammonium in soils tested increased with the increasing of the fixation time, and the fixation rate was the largest at the beginning several hours. the releasing amount of fixed nh / in soils tested increased with the incubation time, and the velocity of fixed - nh4 + - release was very slow
供試土壤對外源銨離子的累計固定量隨時間的延長而迅速增加，反應以開始階段固定速率最大，由同種母質發育的酸堿度不同的土壤對銨離子的固定能力不同。 -
With the increasing initial orientation angle and length - width ratio, the drifting distance, the fluctuation of the orientation angle, lateral drifting velocity and rotation velocity all increase, while the final settling velocity decreases with the increasing length - width ratio
初始取向角和長寬比增大，則粒子的橫向漂移以及取向角、側向漂移速度和轉動角速度的振蕩幅度都增大；同時隨著長寬比的增大，粒子的沉降速度相應減小。 -
Optical measurement systems are of increasing importance for research and industry. today ’ s laser sensors are rigid to withstand industrial environments. surfaces are probed with respect to distance, velocity and surface structure
目前，激光傳感器可以很好地適應工業環境，它可以測量物體表面的位移、速率和表面結構。 -
The temperature field along the axis, axial velocity, the turbulent energy, and the concentration of the particles were investigated when the temperature field varied. the numerical experiment shows that the thermophoresis force changes the concentration of the 2 - micron particle, decreasing in the main flow and increasing in the near - wall region
數值實驗的結果表明在兩相流模型中添加熱泳力源項會對2微米顆粒在流場中的濃度分佈有很大的變化，主流區的顆粒濃度降低，近壁區顆粒濃度在溫差不大的時候，提高幾十倍。 -
The principle of multi - method and multi - parameter is suggested, which should be followed during characterizing microstructures of alloy steels by ultrasonic not method. ultrasonic velocity ( c, ) of transformation products through different heat processes of three steels was measured by high - accuracy ultrasonic installation. the velocity of quenched microstructure of 38crmoal is the lowest, which gradually increases with increasing tempering temperature between 200 ? and 650 ? after quenching process
利用ti - 40n高精度超聲波測厚儀，研究了超聲波在不同鋼種、不同熱處理轉變產物中的超聲波速度c _ 1 : 38crmoal鋼淬火組織c _ 1最小，淬火后在200 650范圍內進行回火處理時，隨回火溫度的升高， c _ 1逐漸升高， hrc與c _ 1之間具有較好的相關性；正火組織的c _ 1介於淬火后中溫回火及高溫回火產物組織的c _ 1之間。 -
Excavating riverbeds in one channel may not only reduce the velocity area in some areas but also increase the velocity in other areas by increasing flow rate in this channel without correspondent changes in riverbeds of rocky rapids. in result, the velocity in waterway may be increased instead of be reduced, the flow condition may also be deteriorated. thus, which branch should be excavated and how to excavate in improving the flow condition of the branch should be further explored
但在分汊河道內，情況較為復雜，在一汊河道內採取開挖措施后，雖然其過水斷面有所增加，局部流速相應降低，但是由於工程后，汊道的分流比將會相應變化，而石質河床一般無法通過沖淤變化以適應水流條件的改變，因此，航道內工程處的流速可能降低，也可能不降反而有所增加，惡化了航道的水流條件。 -
Result of numerical simulation shows that the grads of continuous phase " s velocities decreases with the presence of microbubble of which the diameter is 100 / / w, the profiles of air volume fraction in the boundary layers is similar to triangle or echelon, affected by interaction among the particle, there is a saturated air fraction, within the scope of saturated air fraction, increasing the air injection ratio can accrete the friction reduction ratio, under the condition of same air injection ratio, the free - steam velocity is larger, the effect of friction reduction is worse
計算結果表明，直徑為100 m的微氣泡能減小近壁面連續相的速度梯度；微氣泡在邊界層中的濃度分佈近似為三角形或梯形分佈；受粒子間相互作用的影響，存在一飽和濃度；減阻率隨噴氣量的增大而增大，直至飽和噴氣量，此後，增大噴氣量，壁面摩擦阻力變化不大；相同噴氣量下，來流速度越大，減阻率越低。 -
The calculated results indicate that maneuvering efficiency of the bow lateral thruster is related to velocity and thruster ' s rotate speed directly, it is the best at zero velocity, and maneuvering efficiency of the bow lateral thruster increase with increasing thruster ' s rotate speed ; the calculated results also indicate that crabbing motion can be operated for large vessels under the main thruster, the bow lateral thruster and the rudder ' s united control
計算結果表明側推器操縱效能與航速及槳轉速直接有關，零航速最好，且隨槳轉速增高而增強；結果同時也表明了藉助于主推進器、首側推器和舵的聯合操縱可實施純橫移運動。 -
The ratio of the length to the depth of scour hole decreases with the increasing scour depth, in spite of the reason is the increase of the air concentration, the decrease of the jet velocity or the decrease of the jet thickness. 5. governing equations of the aerated jet flow are established
摻氣對沖坑形態並沒有實質性的影響，沖坑的寬深比隨沖坑深度的減小而增大，無論造成沖坑深度減小的原因四） 1大學i學博士學位論文是摻氣、降低流速還是減小入射水舌厚度，其變化規律都可用相同的直線關系表示。 -
The fan adds energy to the airstream, increasing velocity
而風扇的功用就是增加氣流的動能，增加推進速度。 -
Control role of primary hydrocarbon temperature - increasing velocity of organic matter to the secondary hydrocarbon generation
有機質初次生烴升溫速率對二次生烴的控製作用
分享友人