induction meter 中文意思是什麼

induction meter 解釋
感應計
  • induction : n 1 引入，誘發，誘導（作用）。2 【邏輯學】歸納法，歸納推理 （opp deduction）。3 就職，就職典禮；...
  • meter : n. 1. 測量儀表，計量器；計，表。2. 計量人；計量官。vt. 用表計算[測量、記錄]。n. 〈美國〉＝ metre.
  1. It can produce 1, 000, 000 sets of mechanical induction meter and 500, 000 sets of electric energy meter, 800, 000 sets of mutual inductance instrument and 1, 000, 000 sets of panel meter, 1, 500, 000 sets of electric breaker. quality guarantee contact us

    為了使浙江華邦電力儀表有限公司的產品質量能得到充分的保證，我們歡迎用戶有關部門領導專家及工作人員光臨本公司參觀考察指導和技術培訓。
  2. The analysis results show that : the frequency characteristic curve assumes the downtrend, so the electrical energy measurement of the induction meter will produce biggish error when the content of the harmonic is big, no matter taking the whole energy as measurement standard or basic wave energy

    研究分析結果表明：感應式電能表的誤差頻率特性曲線呈迅速下降趨勢，因此在電能計量中，不管是以全能量為計量標準還是以基波能量為計量標準，當諧波含量較大時對感應式電能表的電能計量將會產生較大的影響。
  3. Compared with the induction meter, the electronic meter ' s measurement error is affected diminutively by the change of the frequency, that is to say, the electronic meter has a wide frequency respond characteristic and its error - frequency characteristic curve is flat. therefore, taking the whole energy as measurement standard, the measurement error of electronic meter is less than that of induction meter very much ; while the measurement error of electronic meter is bigger than that of induction meter when taking the basic energy as measurement standard

    和感應式電能表相比，電子式電能表的計量誤差受頻率變化影響較小，具有較寬的頻率響應，誤差頻率特性曲線較為平坦，因此，在諧波存在下以全能量為計量標準時，電子式電能表的計量誤差遠遠小於感應式電能表的電能計量誤差，而以基波能量為計量標準時，電子式電能表的計量誤差比感應式電能表的計量誤差大。
  4. Three phase induction type watthour meter

    三相感應式電度表
  5. This thesis analyses the present situation of energy metering in bishan network and some network at home, main factors which lead to inaccuracy of energy metering are dissected and the severity degree are pointed out. the method of enhancing accuracy of metering using modern technique are put forward which including : 1 ) modernization of meter, replacing the induction watthour meter with full electronic watthour meter ; 2 ) put real time change of mutual inductor ratio of transformation into consideration, method on real - time computation are presented. 3 ) using full electronic watthour meter to measure fundamental power and harmonic power separately and discussing idea of billing on harmonic

    這些方法包括： 1 ）計量儀表的現代改造，用全電子式電能表代換感應式電能表； 2 ）計及互感器變比的實時變化，對互感器的變比進行實時模擬計算，並提出了實時計算的方法； 3 ）用全電子式電能表對基波電能與諧波電能分別計量，並討論了對諧波電能計費的觀點。
分享友人
分享到 Line

分享到臉書