injection control 中文意思是什麼

injection control 解釋
注入控制
  • injection : n. 1. 注射。2. 注射劑，注射液，針藥，灌腸（藥）。3. 充滿，注滿。4. 【醫學】充血。5. 【機械工程】噴射。6. 【宇宙空間技術】（衛星等的）入軌，射入軌道，射入軌道的時間[地點]。
  • control : n 1 支配，管理，管制，統制，控制；監督。2 抑制（力）；壓制，節制，拘束；【農業】防治。3 檢查；核...
  1. Heamagglutination tests were applied to detect virus in allantoic fluid of chicken embryos which were infected by b95 gathered from the vaccinated chickens " cloacal and oral cavity. the results show that the virus may be detected from 2 days to 11 days after the chicken being vaccinated. the hi antibodies were measured by heamagglutination inhibition tests. there is no significant difference between the immunized and the control chickens which were fed in one case. chickens were immunized with b95 by different immunization meathods or with different vaccines by the same meathod. lt is demonstrated that eyedrop, drinking water, spray or muscle injection all can stimulate good effects, but eyedrop and spray seem to be the best meathods. b95 immunized chicken have relatively higher hi titers and it also can last for a longer time than others

    但如果兩者相隔10天以上免疫， b95免疫不受h120的影響；如果同時免疫b95和h120 ，加大b95的免疫劑量也能獲得良好的免疫效果。用棉拭子采b95免疫雞口腔、泄殖腔的分泌液，檢測其中病毒的存在，結果免疫后2 11天雞口腔和泄殖腔中均有病毒的存在，說明b95免疫雞帶毒時間長。研究結果表明， b95具有不受母源抗體干擾、 hi抗體產生快、水平高、持續時間長、同居擴散性強等特點，因此b95是一株優良的、具開發前景的新的新城疫疫苗株。
  2. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  3. Closed loop control system for gas assisted injection molding equipment

    氣輔注塑裝置閉環控制系統
  4. Based on the development feature analysis, this paper studies thoroughly the reservoir flood feature and remaining oil distribution through the microstructure, sendimentary phase, reservoir heterogeneity and well control, and proposes the comprehensive adjustment based on the injection and development well net structure and improvement the result of the research is obvious with the production degression rate from 9. 14 % of 1997 to present - 1. 46 %, and water rate from original 0. 33 % to present 0. 16 %. in summary, the research idea, method and new achievement of the thesis provide a scientific geological basis for the oilfield development improvement

    在對本區開發歷程和開采特徵分析的基礎上，從微構造、沉積微相、儲層非均質性、井網控制等方面深入地分析了油藏水淹特徵及剩餘油分佈規律，提出了以完善注采井網、調整注采結構為目的的綜合調整措施，已見到了明顯的效果：油田遞減由1997年的9 . 14降至目前的- 1 . 46 ，綜合含水上升率由原來的0 . 33降至目前的0 . 16 。
  5. Eci - turbo electronic control injection turbo

    電子控制燃油噴射渦輪增壓發動機
  6. Electronic control for fuel injection system of diesel engine

    柴油機電控燃油噴射系統
  7. Electronic control of fuel injection system for diesel engine

    柴油機噴油系統的電子控制
  8. Quartz sand for sand control in oil, gas wells and water injection wells

    油氣水井防砂作業用石英砂
  9. Particulate monitor and control of injection solution of ilex pubescens compound in compatible application with several transfusion solutions

    復方毛冬青注射液與幾種輸液配伍的微粒監控
  10. Discussion on the fuel injection control system of gasoline engine

    汽油機噴油控制系統的探討
  11. The research on fuel injection control strategy in this paper is mainly based on the original ecu control strategy of hirth3203 engine. and the work is also based on the experience of many people who succeeded in developing the fuel injection control system

    本文是在hirth3203發動機ecu噴油控制技術的基礎上，借鑒了前人的一些研究成果，初步給出了該小型二沖程電控汽油機的噴油控制策略。
  12. The result of long - term operation shows that the computer control system is practical and effective, it can run in the optimal state within a long duration to fully realize data collection and process, remote data transmission and vfvs constant injection control of pumps. it speeds up the automatic procedures of the seawater treatment process, really realizes the unmanned working, decreases the physical intensity to a large extent, improves the management, enhances the management level, avoids equipment wear down as much as possible, makes the seawater treatment efficient and lessens the cost of production

    長期的運行結果表明，該計算機控制系統的實施切實有效，既成功實現了對被檢測參數的數據採集與處理、遠傳以及注水泵機組的變頻調速恆壓注水控制，又提高了系統的自動化程序，真正實現了無人值班作業，在很大程度上降低了工作人員的勞動強度，極大的改善了現場的管理狀況，提高了生產管理水平，且有效避免了設備損耗，提高了水處理效率，降低了生產成本。
  13. Injection control algorithm for an electronic unit - pump

    電控單體泵系統的噴射控制演算法
  14. Ficd fuel injection control device

    燃油噴射控制裝置
  15. Reprogramming injection control unit

    噴射系統-電腦重設程式
  16. A key problem of injection control was solved by calculation of the coal powder injection quantity

    通過程序計算實現了串罐噴吹中噴吹量的準確計量，解決了噴吹控制中的關鍵問題。
  17. This dissertation delivers ecu hardware design scheme and discusses its feasibility ; designs ecu hardware circuit based on mcu, including ecu input and output signal processing channel, and the emigration of c / os embedded real time operating system on mcu lpc2292 ; designs fuel injection control project software procedure, and simulate it. it implements the open loop control of air fuel ratio under part of the motor working condition

    在充分進行可行性論證的基礎上，完善了ecu的硬體設計總體方案;設計了基於單片機的ecu硬體單元電路，包括ecu的輸入、輸出信號處理通道以及c / os嵌入式實時操作系統在lpc2292單片機上的移植;設計了燃油噴射控制項目的軟體流程;最後通過模擬模擬，實現了發動機部分工況下的空燃比的開環控制目標。
  18. Finally, the fuel injection base map and a series of correction curves are obtained via analysing the data of test result acquired by the ecu monitoring software. the ecu fuel injection control strategy which can be applied to this type of engine is developed

    最後，通過分析臺架試驗所採集的數據，研究得出ecu噴油控制的基本噴油map圖和各種相關修正曲線，並研究了與該型號發動機匹配的噴油控制策略。
  19. 4. analysing the data of test result acquiring by the ecu monitoring software, the fuel injection base map and related correction curves are roughly delivered, the fuel injection control strategy for this type of engine is developed, and the flow chart of ecu control program for fuel injection control is also designed

    4 、分析監測軟體所採集的數據，分析電控燃油噴射系統工作參數之間的關系，得出比較粗略的基本噴油map圖和各種相關修正曲線，最後制定了適用於該小型二沖程汽油機的噴油控制策略，並給出了ecu噴油控製程序的流程圖。
  20. Analysis and design of the electronic fuel injection control software

    本文針對安全電子交易協議
分享友人
分享到 Line

分享到臉書