inlet turbulence 中文意思是什麼

inlet turbulence 解釋
進氣道紊流
  • inlet : n. 1. 進口,入口。2. 【電學】引入,輸入,輸入線。3. 水灣,小港。4. 插入物,鑲嵌物。vt. (inlet, inletting)1. 引進。2. 嵌入,插入。
  • turbulence : n. 1. (風等的)狂暴;激流(現象)。2. 騷亂,動亂;強橫。3. 【氣象學】亂流。
  1. The goal of this paper is to study fully developed turbulent pipe flow. with the aid of the tripping annulus at the inlet, based on the experimental investigation and numerical simulation, detailed researches on a few basic rules in pipe flow have been performed, such as mean velocity profile, relative intensity of turbulence, the log - law, von karman ' s constant and reattachment length, thus filling some gaps in the research work of predecessors and obtaining a far - reaching understanding

    本文的目的就是利用入口擋環進一步探索充分發展的圓管湍流,通過實驗和數值模擬對圓管湍流的若干基本規律,如平均速度分佈、相對湍流強度、對數定律、馮?卡門常數和再附著長度等進行詳細的研究,以填補前人研究中的一些空白,並獲得更深入的了解。
  2. Certain discrepancy remain between the simulation results and the experiment results, not only caused by the turbulent model, but also by the simplification of the inlet boundary condition and the mesh generation. modeling gas - particles interaction flows is complex. in this thesis, gas - phase transport equations coupled with the gas - particle interaction are derived based on the dsm turbulent models to handle the interaction of momentum and kinetic energy of turbulence between the gas and particles

    分離器內的固體顆粒運動採用涉及湍流擴散影響的隨機軌道模型和確定軌道模型,同時在湍流模型中加入了顆粒影響的源項,在流場計算的基礎上,模擬了不同直徑的顆粒在分離器內的運動規律及顆粒分離效率,並同理論和實驗得到的數據進行了比較。
  3. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明,微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外,選用十二烷基硫酸鈉( sodiumdodecylsulphate , sds )以及烷基多糖苷( alkylpolyglycoside , apg )作為減阻添加劑,研究了表面活性劑添加對微通道流動特性的影響。
  4. In this paper, two - dimensional and three - dimensional flow models in supersonic inlet and a simple reacting flow model in combustor and integrated flow field are established on the basis of k ? two - equation turbulence model and steady - compressible n - s equations, which are dispersed by finite volume method

    本文以定常可壓縮n - s方程作為控制方程,採用-雙方程模型作為湍流模型,分別建立了超聲速進氣道的二維、三維流場計算模型和補燃室及一體化流場的湍流燃燒模型,並採用有限體積法對控制方程進行離散。
  5. Turbulence over flat wall is presented with the cfd software cfd ace ( u ) when given by various inlet boundary conditions, subgrid model and turbulence intensity under the two - dimensional circumstance. on comparing these outcomes with the experimental data, we can analyze the impacts that all these factors have on the development of flow boundary layer

    採用計算流體力學軟體cfdace ( u ) ,在二維情況下應用不同的進口邊界條件、亞格子模型和來流湍流度對平壁流動進行大渦模擬,並將模擬結果與已有的實驗結果進行對比,分析比較了這些因素對流動邊界層發展的影響。
  6. The emission control system incorporates both inlet port , induced air motion and compression , induced turbulence for fast and complete combustion

    可譯為:發射(或推進)控制系統混合來自進氣口的空氣,引起空氣運動和壓縮,並引發空氣湍流以加速並完全燃燒。
  7. Scramjet inlet is of great importance in the hypersonic airbreathing propulsion system and plays significant role in the realization of hypersonic flight. full 3 - dimensinal n - s equations are solved by using finite volume method, second - order harten - tvd spatial scheme, and algebraic baldwin - lomax turbulence model

    本文基於favre質量加權平均的三維navier - stokes方程,採用有限體積法、二階的tvd格式進行流場求解,並使用了bladwin - lomax代數湍流模型。
分享友人