interfacial pressure 中文意思是什麼

interfacial pressure 解釋
界面壓力
  • interfacial : adj. 1. 界面的,面際的。2. 界面角的。
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  1. The study on interfacial crack - tip fields under pressure and shear

    壓剪載荷作用下界面裂紋尖端場的研究
  2. The study conducted research on the following four fields : firstly, the characteristics of the interfacial polymerization system of piperazine aqueous solution / trimesoyl hexane solution were systematically investigated. the results show that at a certain molar ratio between the two monomers, piperazine and trimesoyl, at the two phase interface, a dense functional layer of ultra low pressure, high permeating flux and high salt rejection formed by controlling the time of interfacial polymerization, such as the composite membrane ( i ), the concentration in water phase is 0. 4 %, and 0. 1 % in organic phase, and the polymerization time is 1 minute

    本文主要進行了四個方面的研究,首先系統分析和研究了哌嗪水溶液均苯三甲酰氯正己烷溶液界面聚合體系特徵、界面聚合反應中各影響因素對膜性能的影響等,結果發現,當界面處兩相單體(哌嗪和酰氯)分子摩爾比為某一比值時,通過控制界面聚合時間(有機相處理時間) ,可以形成超低壓高通量高脫鹽的緻密功能層,如復合膜( ) ,水相濃度為0 . 4 ,有機相濃度為0 . 1 ,聚合時間1min 。
  3. It set up the development of the world recognized high performance nanofiltration composite membrane of aromatic polyamide, on the basis of reviewing the development, the importance in the membrane separation technology, the classification, the fabrication technique and the current development of the research and the application of the nanofiltration membrane. polysulfone was chosen as the material for making the porous substrate because of its excellent compress - to - denseness resistance, its cheap price and its great availability. by fabricating an ultra thin polyamide functional layer on the polysulfone substrate through interfacial polymerization taking piperazine as the monomer in aqueous phase and trimesoyl chloride as the monomer in organic phase, high performance nanofiltration composite membranes of ultra low pressure and ultra high permeating flux were prepared

    選擇耐壓密性能優良,價廉易得的聚碸材料為制備復合膜基膜材料,哌嗪為水相單體,均苯三甲酰氯為有機相單體,通過界面聚合反應在基膜表面形成超薄功能層,制備了超低壓高通量聚哌嗪均苯三甲酰胺聚碸納濾復合膜,以0 . 1 mgso _ 4溶液為測試液,所得高脫鹽平板復合膜( )在0 . 4mpa下,脫鹽率為96 . 1 ,通量達85 . 2l
  4. The results show that, comparing with the gas pressure drops calculated by the modified ergun equation, in the cases of the gas reynolds number is small, due to the presence of the dead space, the observed p in the experiments are bigger than that obtained by calculation, and when the gas reynolds number is large, because of the small interfacial viscous drag - force between gas and liquid, the p observed are smaller than that obtained by calculation

    結果表明在氣相雷諾數較小時,由於停滯孔隙率的存在,實測壓降值比修正厄根方程計算的值大;氣相雷諾數較大時,氣液界面上產生的粘性曳力較小,實測壓降值比修正厄根方程計算的值小。
  5. The theory of interface of two - phase fluid id used to analyze the role of the interfacial heat transfer resistance in cond ensation process, it shows that the interfacial heat transfer resistance can not be ignored under such a vacuum condition, and the effect on heat transfer process becomes declined with the increasing of vapor pressure

    應用兩相界面理論分析了汽液界面熱阻在水平管內低壓蒸汽冷凝過程中所起的作用,發現實驗范圍內汽液界面熱阻不可忽略,且其對冷凝傳熱過程的影響隨蒸汽壓力的增大而減弱。
  6. Under the conditions of operation pressure about 0. 5mpa and feed temperature 25 c, the rejection performance of nacl feed solution ( 500ppm ), is about 35 %, while the flux is about 45ml cm - 2 h - 1. the pa membranes were prepared by interfacial polymerization, usingl, 3, 5 - benzenetricarbonyltrichlori2, 4 - dichloroterephthalaldehyd e, 1, 3 - phenylenediamine as monomers

    研究結果表明, 5102 / a12o :無機復合超濾膜的研製原料正硅酸乙酷、乙醇、水、 n , n一二甲基甲酸胺( dcca )和hno3之間的配比、塗膜過程、熱處理溫度等直接影響著溶膠的質量和膜的性能。
分享友人