joint bond 中文意思是什麼
joint bond
解釋
共同債券在兩名或以上受益方有生期內持續付款的年金-
Methods of test for ancillary components for masonry - determination of bond strength of prefabricated bed joint reinforcement in mortar joints
圬工輔助砌塊的試驗方法.灰漿連接處預制基地接合處加固的粘結強度的測定 -
( 2 ) from the equilibrium conditions of the isolated segment from a beam - column sub - assemblage, it is clarified for the first time that the bond stress along the beam rebars passing through the joint transfers into the column end to balance shear at this column end at the same ratio as that of the compression force in the compressed concrete at beam ends
通過對樑柱組合體柱脫離體的平衡條件，首次明確了貫穿節點梁筋粘結應力和梁端受壓混凝土的壓力以相同的比例傳入柱端以平衡柱端剪力，從而對節點區的傳力機理重慶大學博士學位論文結出了完整的和具有說服力的解釋。 -
3. the parameters of steel frame with infill which affect the lateral, resistant ability, such as panel ratio, frame - to - panel connectors, frame - to - panel interface friction, gap between panel and frame and mortar joint bond and friction were discussed. it is emphasized that the reduced location, shape and dimension is very important for the function of dog - bone reduced beam flange and must be paid more attention
對填充墻高寬比、填充墻與鋼框架抗剪連接件、內填充墻與框架梁空隙、填充墻開洞和鋼框架與內填充墻界面摩擦等影響填充墻鋼框架抗側力性能的因素進行了討論，並指出設計中考慮這些影響因素對于達到預期的設計目的是至關重要的，必須予以重視。 -
Ltd. the new joint venture will provide voice broking services to the money 、 bond and derivatives markets in both the rmb and international markets
新的合資公司將為本外幣貨幣市場及債券市場以及衍生品等市場提供聲訊經紀服務。 -
The new joint venture will provide broking services to domestic and offshore foreign exchange market, money market, bond market and derivative market
合資公司將為境內外外匯市場、貨幣市場、債券市場及衍生產品等市場提供經紀服務。 -
Research on interface shows the joint begins at the bond periphery, then the center area of the joint, and at last the achievement of connection of the whole joint
鍵合試驗發現:鍵合點的形成始於鍵合點周邊，然後是鍵合點中心區域，最後完成整個界面的連接。 -
In this paper, the microstructures of the joints of aluminum - bronze surfacing on mild steel and on stainless steel are analyzed by means of sem, and the division and formation of bronze / steel joint bond are studied
藉助于電子顯微鏡技術對在低碳鋼和不銹鋼上堆焊鋁青銅的接頭的組織進行了分析，並對鋁青銅接頭熔合區的形成和區域劃分進行了探討 -
Abstract : in this paper, the microstructures of the joints of aluminum - bronze surfacing on mild steel and on stainless steel are analyzed by means of sem, and the division and formation of bronze / steel joint bond are studied
文摘:藉助于電子顯微鏡技術對在低碳鋼和不銹鋼上堆焊鋁青銅的接頭的組織進行了分析，並對鋁青銅接頭熔合區的形成和區域劃分進行了探討 -
In this study, advanced laser surface treatment, superplastic, solid - joint technologies were used to the bond of a - tial alloy to realize the high quality bond of this alloy at low temperature and short time
本文將先進的激光表面處理，超塑成形，擴散連接工藝結合在一起，實現- tial合金低溫、短時、高質量的固態連接。 -
Hot applied joint sealants - test method for the manufacture of concrete test blocks for bond testing recipe methods
熱用接縫密封膠.粘結試驗用混凝土試驗塊生產的試驗方法 -
Hot applied joint sealants - part 12 : test methods for the manufacture of concrete test blocks for bond testing recipe methods
熱用密封膠.第12部分:粘結試驗中混凝土試驗塊製造的試驗方法 -
Hot applied joint sealants - part 12 : test method for the manufacture of concrete test blocks for bond testing recipe methods ; german version en 13880 - 12 : 2003
熱用密封膠.第12部分:粘結試驗中混凝土試驗塊製造的 -
( 2 ) based on deterioration model of owerage bond stress of beam reinforcement accounting for effect of axial compression ration and number of displacement loops, and stress - strain relationship of the concrete in the joint core accounting for effects of both softening and confinement, the modified compression field theory was employed to simulate behavior of the joint core under loading reversals. analysis by means of the program jap on the tested specimens in this paper and those obtained from other researchers produced consistent results
根據本文建立的考慮軸壓比和位移循環次數影響的梁筋平均粘結應力退化模型和考慮軟化效應、約束效應的核心區混凝土應力應變關系，通過在試驗中得出的節點核心區混凝土、箍筋、節點正面、背面柱筋在反復荷載下的受力特點，利用斜壓場理論模擬節點核心區在反復受力過程中的受力狀態。 -
Methods of tests for ancillary components for masonry - part 2 : determination of bond strength of prefabricated bed joint reinforcement in mortar joints ; german version en 846 - 2 : 2000
磚石工程輔助元部件試驗方法.第2部分:灰縫中預制底層 -
Methods of test for ancillary components for masonry - part 2 : determination of bond strength of prefabricated bed joint reinforcement in mortar joints
圬工輔助成份試驗方法.第2部分:灰漿粘結處預制床接頭增強的粘結強度測定 -
Behavior of the confinement mechamsm is also different. before obvious bond deterioration of the beam rebars passing through the joint core occurs, the shear is mainly transfered by the truss mechansim. when the bond deterioration occurs comprehensively, the shear transfered by the truss mechamism is reduced significantly, the majority of the shear is transfered by the diagonal strut
當貫穿節點的梁筋未出現明顯的粘結退化之前，節點作用剪力主要通過街架機構傳遞，斜壓桿機構傳遞的剪力和約束機構發揮的作用較小；當梁筋全面出現粘結退化以後，行架機構傳遞的剪力明顯降低，作用剪力主要由斜壓桿機構傳遞。 -
Using the new numerical model for reinforced joint with consideration of the bond and slip between reinforcing bars and surrounding dam concrete, the 3d fem nonlinear analysis for 292m high xiaowan arch dan under design load working conditions of earthquake was conducted, and the effects of different kinds of reinforcement on stress, slip and transverse joint openings were studied
摘要利用考慮橫縫及跨橫縫鋼筋滑移的拱壩動力非線性模型，對設計地震荷載工況下的小灣拱壩進行了三維動力非線性有限元分析，研究了不同配筋率分佈對跨縫鋼筋的應力、滑移量及其控制橫縫變形的影響。 -
The issue of secondary bond and the joint - stock - system reform of state - owned commercial banks
次級債發行與國有商業銀行股份制改造 -
Where the shoe pinches of the repair success is all right combination of young and old concrete. presently, most of the researches inside and outside country made the two into one to against force through felt. in practice, however, it ca n ' t obtain ideal bond capacity only depend on adherence. thus, this paper bring forward a young method to make up the lack of felt capacity - use mechanical joint element to link young and old concrete
新老混凝土之間的良好結合是混凝土修補成功的關鍵所在，目前國內外的研究中絕大部分是通過二者的粘結作用使其結合成為整體共同受力。而實際工程中僅僅依靠粘結力往往達不到理想的結合程度。因此，本文研究的是加強新老混凝土結合，彌補粘結力不足的一種新方法，即採用機械連接件將新老混凝土結合在一起的方法。
分享友人