lattice parameter 中文意思是什麼

lattice parameter 解釋
點陣參數
  • lattice : n. 1. 格子。2. 【物理學】點陣；網路。3. 【建築】格構。vt. 1. 把…製成格子狀。2. 用格子覆蓋[裝飾]。
  • parameter : n. 1. 【數學】參數，變數；參詞；參項。2. 【物理學】參量；（結晶體的）標軸。3. 〈廢語〉【天文學】通徑。vt. -ize 使參數化。
  1. Then the structure unit of hexangular lattice is found according to the principle of invariable symmetry. renormalization transformation is processed when we regard the structure unit and the growth model as graphs before and after transformation respectively. after choosing the 11 thermodynamic function fugacity as parameter, we can write out the partition functions before and after transformation and the formula of renormalization transformation

    然後根據對稱性不變的原則，從整體晶格中選取結構單元，把結構單元和生長模型分別作為重整化變換前、后的圖形來進行重整化變換，選取熱力學函數易逸度為參量，寫出了重整化變換前後的配分函數和重整化變換關系式，求出了這一變換的不動點。
  2. Parameter analysis for out - plane global stability of space lattice tilted column frame

    斜腿剛架平面外整體穩定性參數分析
  3. The attice parameter change due to heat treatment and c doping does not alter this ptimum orientation relationship but only slightly adjust the deviation angles. the alculated angles between ( 111 ) s, and ( 110 ) p all is 4 ? 6 ? for the lattice parameters neasured

    另外還計算出（ 111 ） s ；與（ 11 ） p之間全部有4 」一6 」的空間角，將這個角投影至001 p方向或n刁1入；方向，就可以從理論上解釋為什麼會在高分辨照片上觀察到的近4 」的轉角。
  4. Molecular dynamics simulation of size dependent cohesive energy and lattice parameter of pb nanofilms

    納米薄膜的結合能和晶格參數的尺寸效應
  5. And the measured lattice parameter of the tabular particles was 3. 90a, which is in agreement with the previously reported for srtio3

    測得1200下保溫4小時后得到的srtio _ 3片狀晶粒的晶胞參數為3 . 90 （
  6. The lattice parameter, a0, and fwhm of the uo2 + x ( fluorite type ) decrease initially and stabilize later as the increasing of reaction times at 200. the uo2 + x is progressively replaced by u3o8 as the oxidation proceeds at 300

    200條件下，金屬鈾表層所形成的氟化鈣結構的uo _ （ 2 + x ）的點陣參數a _ 0和fwhm隨著氧化時間的增加逐漸減小，然後出現穩定。
  7. The lattice parameter of obtained ultrafine ni powders is 0. 35288nm which is larger than that of the perfect ni single crystal

    Xrd精確測定所得超細鎳粉的晶格常數為a = 0 . 35288nm ，比完整ni單晶的晶格常數大，晶格發生了膨脹。
  8. Another phase, the high temperature phase, is hexagonal with space group p - 62m, which is stable from 300 to 800. the lattice parameter and the full width of half maximum ( fwhm ) of xrd peaks of u3o8 were also investigated at different temperature, and it were found that they change with the temperature under rules

    在兩種相結構各自穩定的溫度范圍內， u _ 3o _ 8的點陣參數以及衍射峰半高寬（ fwhm ）出現了有規律的變化，這種變化表明u _ 3o _ 8的晶體結構依賴于環境溫度的變化。
  9. The experiment demonstrates that the simulated calculations are in good agreement with experimental results. the conception and algorithm simulation of lattice digital filter in electronics are transplanted into optical filter, with a novice algorithm to resolve optical lattice array concrete parameter

    3 .將成熟的電子學里的格型數字濾波器的概念和設計演算法移植到光學濾波器，給出了根據目標濾波傳遞函數求解光格型陣列具體參數的演算法。
  10. Determination method of artificial graphite lattice parameter

    人造石墨的點陣參數測定方法
  11. Lanio3 ( lno ), as a desirable candidate for electrode materials, has a pseudo - cubic perovskite crystal structure with a lattice parameter of 3. 84

    作為一種合適的侯選電極材料， lanio3 （ lno ）的晶體結構是一種贗立方的鈣鈦礦結構。
  12. This thesis focuses on the study of the layered lithium nickel - based oxides as catho de materials lithium - ion batteries, the main aspects follow : 1 study on the synthesis and properties of linixco1 - xo2 by the sol - gel method compared with solid - state method, sol - gel method enjoys the advantage of lower calcining temperature and small uniform particle size of products. after the xrd measurement, it was shown that the single - phase layered compound can be prepared in sintering temperature of 750 for 6 ~ 8 hours. the sintering temperature, the properties and the amounts of doping materials can all affect the product ' s phase, and its structure ( lattice parameter, crystal phase distance )

    本論文的研究工作主要集中在作為鋰離子電池正極材料的層狀鋰鎳基氧化物上，包括以下幾個方面： 1溶膠凝膠法（ sol - gel ）合成lini _ xco _ （ 1 - x ） o _ 2的研究與固相合成法相比，溶膠凝膠法合成lini _ xco _ （ 1 - x ） o _ 2煅燒溫度低，產物顆粒均勻一致，經過xrd的測試過后，結果表明750下燒結6 8小時，即可得到單相產物；燒結溫度，摻雜劑的種類及摻雜劑量均對產物物相的形成產生影響，並對產物的結構產生影響。
  13. The heteroepitaxial growth of 3c - sic on si substrate not only unfurls the maturity of si process, but also incarnates the excellence of 3c - sic, so that it become for long researchful direction. due to the large lattice parameter mismatch ( ~ 20 % ) and the large thermal expansion coefficient mismatch ( ~ 8 % ), however, the 3c - sic / si study is very difficult

    然而，由於3c - sic與si之間存在較大的晶格失配度（約20 % ）和熱膨脹系數差異（約8 % ） ，因此， 3c - sic / si異質外延薄膜的制備非常困難，仍存在許多技術問題需要克服。
  14. If we want to monitor the damage of the span lattice roof structure, the wind - induced responses and identification of parameters become the important problems first of all, which also the key technique of the damage monitoring of the structure. the method of time domain parameter identification is superior to the method in frequency domain : the structural response is only needed to identify the parameters of the structure

    時域參數識別方法具有頻域方法無可比擬的優點，僅僅需要結構的響應信息，便可實現結構的參數識別，尤其對于大跨空間網格結構，人為激勵往往有很多的弊端，因此，積極發展有效的時域參數識別方法，還是很有現實意義的。
分享友人
分享到 Line

分享到臉書