lead-lag 中文意思是什麼

lead-lag 解釋
超前滯后
  • lead : n 1 鉛,鉛製品。2 【航海】測鉛,測深錘,水砣。3 〈pl 〉(鋪屋頂的)鉛皮;鉛皮屋頂;【印刷】插鉛,...
  • lag : vi ( gg )1 延遲,逗留,落後;慢條斯理地走。2 未充分發展。3 【電學】滯后。4 慢慢地減少,變弱,鬆...
  1. But the braggart boaster cried that an old nobodaddy was in his cups it was muchwhat indifferent and he would not lag behind his lead

    吾決不落人後。 」然彼乃蜷縮于霍恩大廳之內而出此言,愈益顯示其懦弱之至也。
  2. Lead lag circuit

    超前滯后電路
  3. You can fine - tune task links - and make sure you do n ' t gum up the clockwork - by using lag time and lead time

    使用「前置重疊時間」和「延隔時間」調整任務鏈接,並且確保那些鐘表裝置不會粘上油漆。
  4. Dynamic measurement includes dynamic balance, power efficiency and servo load. the servo load is highly influenced by static lead lag angle

    動態測量包括動態平衡,功效和舵機載荷。舵機載荷對靜前沿滯角度后很敏感。
  5. By using lead and lag time, you can make your schedule more accurate, and you may be able to shorten it as well

    使用重疊時間和延隔時間后,日程將更加準確,同時也可能縮短日程。
  6. Other factors may include, but not be limited to, work contours, task calendars, lead and lag time, and task constraints

    其他因素還包括工時分佈、任務日歷、前置重疊時間和延隔時間以及任務限制(但不局限於此) 。
  7. ( you can also specify lead and lag time. ) for information about linking tasks, see chapter 5, " getting tasks done in the right order, at the right time.

    有關鏈接任務的內容,請參閱第5章「按恰當的順序和時間完成任務」 。
  8. General specification for helicopter blade lead - lag damper

    直升機槳葉擺振阻尼器通用規范
  9. Within this analytical model, the factors as unsteady aerodynamic and blade flap / lead - lag coupled motion are both considered

    旋翼機體耦合動力學模型考慮了非定常空氣動力和槳葉揮舞擺振運動耦合。
  10. Among others, one method to solve this problem is to install lead - lag dampers. the conventional configuration for installing dampers is to put them between blades and hub. in 1990s, eurocopter began to use the inter - blade dampers in ec155 which means to put every damper between two adjacent blades

    傳統的減擺器布置是槳葉-槳轂式;上個世紀90年代,歐直公司開始在ec155上使用葉間減擺器,減擺器不是布置在槳葉和槳轂之間,而是布置在相鄰兩片槳葉之間。
  11. The design of force feedback loop is emphasized on the base of theory analysis. then proportional - integral controller and lag - lead compensator are designed to improve dynamic performance of this kind of gyro. the main work includes optimizing parameters and system simulation

    用matlab分析了陀螺本體傳遞函數的波德圖,然後通過採用比例-積分控制和遲后-超前校正及參數優化、系統模擬,使陀螺系統的固有頻率得到顯著提高。
  12. According to the research of the converter s transient operation, the thesis presents the design of the resonant parameters and the dead - time setting range of the converters lead leg and lag leg, and i is confirmed by simulation

    論文在對變換器暫態工作過程研究的基礎上,給出了軟開關諧振參數設計和變換器超前橋臂、滯后橋臂的死區時間設置范圍,模擬驗證了設計的有效。
  13. Lead lag module

    超前滯后組件
  14. Lag - lead compensation

    滯后超前補償
  15. Nevertheless, errors in data collection, time lag, or the correlations among variables all can lead to the uncertainty of the data accuracy. for example, should we take the total number of students in the beginning, the middle, or the end of a school year as the number of registration of the year

    然而,由於資料收集的誤差、時間的延遲( lag )或變量間交互影響,造成數值資料本身具有不確定性與模糊性。例如每年的學生人數,年初、年中和年終數值往往有所不同。又如股票指數漲跌,開盤與收盤,最高價與最低價亦有相當的差距。
  16. The static measurement includes weight, center of gravity, static lead lag, bending stiffness and torsion stiffness

    靜態測量包括重量,重心,靜前沿滯后,彎曲鋼度,和扭區鋼度。
  17. To add lead or lag time

    如果要添加前置重疊時間或延隔時間:
  18. Use minute, hour, day, week, or month for the lead or lag time units

    前置重疊時間或延隔時間的單位可以是分、小時、工作日、周或月。
  19. Note1 : up screen display power factor and down screen display voltage to be lead or lag

    注1 :上屏顯示功率因數,下屏顯示電壓超前或滯后。
  20. This model is formulated as a non - linear state - space representation of helicopter flight dynamics, incorporating with blade element unsteady aerodynamics, a finite state dynamic inflow wake model, and flapping / lead - lag blade dynamic model. the formulation of the coupled rotor and fuselage equations enables the use of common solution techniques for trim and linearization in arbitrary steady flight condition as well as control response calculations

    本項研究針對新機研製過程必須解決的品質評定、飛控系統設計等問題,按照ads - 33軍用品質規范的要求,建立了一個較完整的直升機非線性的、具有狀態空間表達形式的飛行動力學模型,進行了模型驗證工作,並以某樣例直升機為例,計算了ads - 33品質規范( 3
分享友人