leakage air rate 中文意思是什麼

leakage air rate 解釋
空氣漏泄率
  • leakage : n. 1. 漏，漏出。2. 泄露。3. 漏出物，漏出量。4. 【商業】漏損率；漏損量。
  • air : n 1 空氣，大氣。2 天空，空中。3 微風，和風。4 態度，樣子，風度，氣派；〈pl 〉高傲的架子。5 傳播，...
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  1. Standard test method for determining air leakage rate by fan pressurization

    用風扇增壓法測定空氣泄漏率的標準試驗方法
  2. Measurement of mine surface air leakage rate with equivalent method

    等值法測定礦井外部漏風率
  3. Determination of leakage rate and specific resistance for mine air duct

    礦用風筒漏風率和風阻的測定方法
  4. Air leakage rate of mine

    礦井漏風率
  5. Since the air leakage rate of the air preheaters in waigaoqiao 900 mw units is too high, and the opening of the primary fan stationary blades can not meet the requirement of the unit loads, a retrofit was carried out for the air preheater sealing system in according to the scheme proposed by alstom germany

    摘要針對外高橋900mw機組空氣預熱器漏風率偏高、一次風機靜葉開度不能滿足機組負荷要求這一影響機組運行的安全性和經濟性的問題，依據alstom德國公司提出的改進方案，對該空預器密封系統進行了改造。
  6. Two typical examples analyses are conducted for the average conditions both of winter and summer climates under vapor diffusion and air leakage. a further discussion is set forth to determine the main factors that the moisture accumulation in wall is affected. it is found that the factors are the relative humidity at the wall surface, indoor temperature, permeability, air pressure difference and rate of the infiltrative or exfiltrative airflow

    本文首先研究了墻體內的濕氣遷移過程，詳細分析了濕積累現象形成的原因，通過對夏、冬兩季平均氣候下墻內溫度、水蒸氣壓力、相對濕度及濕積累在僅有擴散、擴散與空氣滲透同時存在等情況所作的具體計算，發現墻內、外表面的相對濕度、室內溫度、滲透率、空氣壓差以及空氣的滲流速度是影響墻內濕積累的主要因素。
  7. Test method for determining the rate of air leakage through exterior windows, curtain walls, and doors under specified pressure and temperature differences across the specimen

    在試驗樣件規定壓力和溫差下測定通過外窗幕墻和門空氣泄漏率的試驗方法
  8. Standard test method for determining the rate of air leakage through exterior windows, curtain walls, and doors under specified pressure and temperature differences across the specimen

    在試樣兩側特定壓力和溫度差下透過外窗，護墻和門的空氣泄漏率的測定方法
  9. Standard test method for determining rate of air leakage through exterior windows, curtain walls, and doors under specified pressure differences across the specimen

    通過樣品的規定壓差測定外窗幕墻及門的漏氣率的標準試驗方法
  10. Standard test method for rate of air leakage through exterior metal roof panel systems

    外部金屬屋面板系統漏氣速率標準試驗方法
  11. This test shall be carried out after all structural tests have been completed and prior to the heat leakage test. for the said refrigerated containers, the air leakage rate, expressed hi standard atmospheric conditions is 2. 38 m3 / h, not exceed 10m3 / h

    機械式冷藏集裝箱的製冷性能實驗（ 1 ）的測試結果為箱內平均溫度： - 18 . 03 ；箱外平均溫度： 38 . 02 ，試驗條件滿足規范要求。
分享友人
分享到 Line

分享到臉書