length height ratio 中文意思是什麼

length height ratio 解釋
長高比
  • length : n. 1. 長，長度，長短。2. （時間的）長短，期間。3. （賽艇的）一艇的長度；一馬的長度。4. 程度，范圍。5. 【板球】球程；投至適當距離的球。6. 【語言學】音長。7. 一段，一節。
  • height : n 1 高，高度；身高；海拔。2 〈常 pl 〉高地，山丘。3 高貴，卓越。4 絕頂，頂點；【聖經】天。5 〈罕...
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. The effect of exit back pressure and length / height ratio of isolator on forebody / inlet flow field is analyzed and discussed in the paper

    本文還研究了隔離段出口反壓及隔離段長高比對進氣道流場的影響。
  2. The results indicated that the plant growth regulator could increase plant height, main root length, lateral root number, root / shoot ratio, chlorophyll content, proline content and the activity of peroxydase ( pod ), and improve the ability of drought - resistance of soybean seedlings

    結果表明，植物生長調節劑可促進大豆幼苗莖葉生長和主根伸長，增加側根數，加大根冠比，提高葉綠素含量、脯氨酸含量和過氧化物酶（ pod ）活性，從而增強了植株的抗旱能力。
  3. Height, crown amplitude, size of leaves, leaf number, diameter of root, biomass of leave, biomass of root, total biomass and relative growth rate ( rgr ) of c. smyrnioides were all increase with soil water. but it was decreased with soil water for specific leaf area ( sla ), leaf area ratio ( lar ), specific root length ( srl ) and root length ratio ( rlr )

    明黨參株高和冠幅、葉片形態大小、葉片數、根粗、根體積、葉生物量、根生物量、總生物量和rgr均隨著土壤水分的增加而增大，而sla 、 lar 、 srl和rlr則隨著土壤水分的增大而減小。
  4. The results show the exit back pressure and length / height ratio of isolator have great impact on exit flow field and starting performance of inlet. high back pressure of inlet will result in unstart

    研究表明：隔離段長高比對進氣道出口參數影響較大；隔離段出口反壓不能太高，否則會引起進氣道不起動。
  5. The productions include : 1. the investigation of crackss of masonry structures, the characteristic and the reason on cracks of wall ; 2. the limited element analysis about datum of brick - wall the relation between the maximal stress in wall and the relative sedimentation of foundations, the relation between the cracks form in wall and inner stress, the validity of limited element mode ; 3. the limited element analysis about the relative sedimentation of foundations, the influence of ratio of length and height, foundations rigidity, groundsill rigidity on the inner stress in wall ; 4. the limited element analysis about the influence of temperature on wall cracks and the influence of space between extension cracks, difference in temperature on the inner stress in wall ; 5. the analysis about the cracks rule because of temperature, the contrast between the result and the simulant result ; 6. the study about the influence of cracks of masonry structures because of constriction stress, the experience of dealing with constriction cracks in the domestic and the foreign ; 7. the advice of avoiding cracks because of the asymmetric sedimentation temperature, constringency in design and construction

    本研究結合實際工程中的砌塊建築普遍存在的裂縫問題，參照磚墻裂縫調查研究的成果，針對我省的砌塊應用狀況，進行了充分的調研，並查閱大量的文獻資料，總結了砌塊建築墻體裂縫的特點和規律，通過對溫度裂縫、沉降裂縫的有限元分析和經驗公式的對比，深入的探討了墻體開裂的影響因素，結合各地實際工程經驗，在對混凝土砌塊墻體在材料、設計、施工等方面進行系統的理論分析、綜合研究的基礎上，給出開裂的防治方法，促進混凝土砌塊在我省的推廣應用，為相關規范的編制提供理論依據和經驗分析，主要研究成果有： 1砌塊砌體開裂的調查研究，墻體開裂的特點和原因總結； 2有限元分析磚墻實測數據，揭示了墻體內最大主應力和地基相對沉降量的關系及墻體開裂形態與內部應力的聯系，並且驗證了有限元模型的有效性； 3
  6. Through carrying out analysis on the aesthetics shape elements of 37 kinds of sample book, 12 shape elements for describing the contour features of industrial sewing machine, such as the elements of ratio between fuselage length and fuselage height and of shape of central part main shaft section etc. were defined

    通過對37種樣本的美學形態要素進行分析，定義了描述工業縫紉機外形特徵的12個形態要素，如機身長與機身高比率、中部主軸截面等形態要素。
分享友人
分享到 Line

分享到臉書